DESIGN & DETAIL A DOUBLE FER THE STANDARD BOLT HOLES SHEAR CONNECTION ANGLE (BOLTED - BOLTED) BEAM COLUMN CONNECTION. USE TO WITH AB25 GENTS.

Q: eight at 0kpa: 396 g Weight at -33kpa: 325 g Weight at -1500kpa: 291 g Weight at -3100kpa: 280g…

A: Weight at 0kpa: 396 gWeight at -33kpa: 325 gWeight at -1500kpa: 291 gWeight at -3100kpa: 280gWeight…

Q: An agricultural land of 486 ha is to be irrigated for a crop having delta as 120 cm and 17 cm of…

A:

Q: Situation 1 | A built-up beam made from fastening two channels to a wide flange section carries…

A: Diagram;Draw SFD;Thus Vmax = 49.077 kn

Q: The steel connection below shows a beam W310 x 52 connected to column W310 x 74 using 2 Web Plates…

A: CAD Template 1st;

Q: Draw the projection of a circle of diameter 50 mm such that the plane of the circle makes an angle…

A: Diameter: 50mmAngle on plane of circle: 45To draw : projection. Of circle.

Q: The perception - reaction time for a vehicle travelling at 90 km/h, given the coefficient of…

A: The perception reaction time for a vehicle travelling with,Speed of the Vehicle, The coefficient of…

Q: A strip footing 1.5 m wide is located at a depth of 0.75 m (equal to the foundation thickness) in a…

A: Width of strip footing = 1.5m , Depth = 0.75m = Thickness of foundation , Unit weight of sand =…

Q: :Design a concrete column shown in figure using fe'-28 MPa, fy- 420 MP Itimate applied load. P=545…

A: A  concrete column is normally a composite column that consists of steel and concrete also in…

Q: 2. Consider the system of cable subjected to a uniformly distributed load. Determine the tension at…

A: Diagram;d = d1 = 6 m

Q: Problem Solving: Round off your final answer to 2 decimal places. 3m 1 3m 1 4 m 20 KN 15 KN 10 kN 1…

A: For the frame provided below, consider the following properties, Members along level 2: Regular…

Q: Q4-The stream flows due to three successive storms of 2.9, 4.9 and 3.9 cm of 6 hours duration each…

A: Given;Three storm of intensity 2.9,4.9 and 3.9 cm of 6 hr. duration each. Area of basin (A) = 118.8…

Q: A sand sample in a triaxial test have the following stresses: Cell Pressure 25kpa 34kpa Axial Stress…

A: The stresses on sand sample in a triaxial test are given as Cell pressure  Axial stress Pore…

Q: Q3 Analyze the structure shown in Figure (3), using Slope-Deflection Method, (support d settles by 1…

A: As per the honor code, the first problem will be solved. Fixed end moment: Span ab:…

Q: The equation of motion of a particle on a straight path is S = t³ - 3t, where s is displacement in…

A: Given;The equation of motion of a particle on a straight path is S=t3where 'S' is displacement.t = 3…

Q: What should be the diameter of sewer (in m) if it is designed to carry a discharge of 0.75 cumec…

A: Discharge Q=0.75 cumec running half full,Manning's coefficient n=0.016Gradient of the pipe = 1 in…

Q: not solve based on eurocode 7, design approach 1, combination 2

A: Width of the footing, B = 5m , Length of footing , L = 10m , Dry Unit Weight,γdry=20kN/m3Saturated…

Q: If the pump head is 75 m, discharge is 0.464 m³ /s and the motor speed is 1440 rpm at rated…

A:

Q: Determine the flexural capacity of the given section of beam below. b=280 d=420 d'=80 fc'=34 fy=350…

A: To calculate - A) Mu (NSCP 2001)                       B) Mu (NSCP 2015)

Q: 8. Determine the peak runoff rate in Ashville, NC, for a 25-year storm of a 50-acre watershed with…

A: The area of the residential plot = 22 acresThe area of the apartments = 12 acresThe area of the lawn…

Q: Q3: A) The recorded discharges and stages at the hydrological station on a channel is given below.…

A: We know that regression equation is given by,                  .... (1)And,Here,The stage value for…

Q: Problem Solving : Round off your final answer to 2 decimal places. 20KN DI L4 H ! T 3m SKN ↑ 3m 2.…

A: For the frame provided below, consider the following properties, Members along level 2: Regular…

Q: (Q2) Calculate coordinates of point P (by Tienstra formula) in the following drawing if you know:…

A: Given; Point Easting Northing A 23808.69 19480.97 B 23930.75 19769.49 C 23989.38 19602.00…

Q: A horizontal curve on a three-lane highway with 12-ft lanes has a PC located at station 10+00 and PT…

A: 3 lane road with 12 ft lanes  = 25o e = 4% or 0.04Clearance distance = 40 ft

Q: The equilibrium superelevation required on a broad gauge track at horizontal curve of radius 650 m…

A: Given data,  Horizontal curve radius = 650 m Speed = 65 kmph

Q: On the profile shown in the figure, two large embankments will be built at an interval of 6 months.…

A: Height of first embankment, H1 = 1m Height of second embankment, H2 = 2mUnit weight of embankment,…

Q: D₂ = 5 cm D3 = 6 cm D₁ = 4 cm The flow network carries the water at 20°C to exit pipe 4. The flow…

A:

Q: Give best solution to resolve a flash flood problem. The cause of flash flood are elevated portion…

A: Flash flood problem-When there has been a lot of rain, a levee or dam has failed, or water has been…

Q: 6-69. Determine the maximum moment at C caused by the moving load. 12 kN Bla 1 m -0.5 m 8 m 4 m B

A: The below beam figure is shown,To determine:-The maximum moment at C caused by the moving load.

Q: A 1.5 m square footing is founded at a depth of 1m (equal to the foundation thickness) in…

A: Dimensions of square footing = 1.5 m Thickness of footing = 1 m Depth of footing = 1 m Properties of…

Q: Q3: Determine the horsepower developed by a passenger car traveling at a straight road at a speed of…

A: Speed u=60 km/hr = 37.28 mphupgrage = 4 %Weight W  2000 kg = 4409.245 lbsArea A=4 m2 = 43.05 ft2

Q: The steel floor framing shown is designed to support a reading room for a library area of a…

A: Dead load = concrete + steelConcrete load  = 6/mTile load = 6/mSteel load = 0.01Total Dead load =…

Q: Four forces of act on a system as shown in the figure. Determine (a) the magnitude and direction of…

A: System of four forces are given below:To find:-(a) Magnitude and direction of resultant force(b)…

Q: A SOIL SAMPLE WITH A GRAIN SPECIFIC GRAVITY OF 2.67 WAS FILLED IN A 1000ML CONTAINER IN THE LODSEST…

A: Given data-

Q: (1) 21 1 2 I 1 (3) 021 821

A:

Q: Use the virtual work method to find the collapse load of the structure. Wc 0.75l * 0.25l

A:

Q: A plate is used as a tension member, to carry a deadload = 300 KN and live load of 260 KN. Steel…

A: Dead Load = 300 kN and Live load = 260 kNFy = 248 MPa and Fu = 400 MPa and width of tension plate  =…

Q: Apply the virtual unit charge method 3) Zon +3m w=3Tos/m. B4m D + 2m + x dys? TO G.

A: To determine:1) Rotation at 'A'2) Deflection at 'D'Using Unit load (Virtual unit charge) method

Q: Trial Question For the following particle size distribution, calculate the efficiency of a Lapple…

A: Given; μg =0.06 kg/m.hr  = 1.67×10-5 kg/m.sW = 0.25D = 0.250.5 = 0.125 m

Q: 2 kN. 2 KN 2 kN A E G -4m->> B T 3 m D + 3m F+ H 3m

A:

Q: What are the perks of both horizontal and vertical walls?

A: Horizontal walls are walls that are parallel to the ground or floor. Horizontal walls provide…

Q: An extended aeration tank receives a BOD load of 768 kg/day. If two fixed aerators with oxygen…

A:

Q: Determine the slope and deflection at point C of the beam shown by the direct integration method and…

A: Overhang beam with two point loads    NOTE : The question is solved by direct integration method…

Q: The Domestic Building Dispute Resolution Victoria (DBDRV) and the Victorian Civil and Administrative…

A: In Victoria, Australia, both the Domestic Building Dispute Resolution Victoria (DBDRV) and the…

Q: ( Determine the slope and deflection at point B of the steel beam shown below using conjugate beam…

A:

Q: For a falling head permeability test, the following are given. Length of specimen is 380 mm, are of…

A:

Q: Q4:-Calculate the amount of materials used for one batch in (0.2m³) concrete mixer for production of…

A: Batch volume = 0.2 m3 C : FA : CA = 1 : 1.6 : 2.9w/c = 0.5Water = 190 kg/m3Absorption in coarse…

Q: Q.2 There are 2 primary settling basins each 24 m in diameter with a side water depth of 2.1 m…

A: 2 primary settling basins- Diameter of basin D = 24 m, Side water depth H = 2.1 m single effluent…

Q: A square pile of section 30 cm x 30 cm and length 10 m penetrates a deposit of clay having c = 50…

A: A square pile of section 30 cm  30 cmB = 0.3 mLength, L = 10 mA deposit of clay having c = 50…

Q: What are the difference between Spatial Resolution and Color Resolution

A: Context: Spatial Resolution and Color Resolution

Q: 2 kN 150 mm 30 mm 2 kN

A:

Connections

In steel structures, connections are the members that join two or more steel members. The connections are the most important members of any steel structure, and hence, they are designed more carefully. The majority of the construction cost of steel structures is incurred due to the connections. The design of connections is done as per the recommendations and specifications of the American Institute of Steel Construction (AISC).