For the following circuit in the figurebelow consider the direction of thecurrent given. Determine ɛ ( in units ofV) when I = 0.50 A and R = 28.3 Q.%3D%3DR2R2RISelect one:A. 84.9В. 56.6C. 70.8D. 14.2E. 18.8

Answered: Image /qna-images/answer/c23d6cb5-09a3-4d53-8a2e-b5b4a735082e.jpg

Answered: Determine &

Science

Physics

Determine &

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 80AP: In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a...

See similar textbooks

Similar questions

In Figure OQ32.4, the switch is left in position a for a long lime interval and is then quickly thrown to position b. Rank the magnitudes of the voltages across the Four circuit elements a short time thereafter from the largest to the smallest.
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
What is the plia.se angle in a series RLC circuit at resonance? (a) 180 (b) 90 (c) 0 (d) 90 (e) None of those answers is necessarily correct.
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
Consider the RC high-pass filler circuit shown in Figure P33.53. (a) Find an expression for the ratio of the amplitude of the output volt age to that of the input voltage in terms of R, C, and the AC source frequency . (b) What value does this ratio approach as the frequency decreases toward zero? (c) What value does this ratio approach as the frequency increases without limit?
For the circuit shown in Figure P18.30, use Kirchhoffs rules to obtain equations for (a) the upper loop, (b) the lower loop, and (c) the node on the left side. In Figure P18.29 each case suppresses units for clarity and simplify, combining like terms. (d) Solve the node equation for I36. (e) Using the equation found in (d), eliminate I36 from the equation found in part (b). (f) Solve the equations found in part (a) and part (e) simultaneously for the two unknowns for I18 and I12, respectively. (g) Substitute the answers found in part (f) into the node equation found in part (d), solving for I36. (h) What is the significance of the negative answer for I12? Figure P18.30
For the circuit shown in Figure P18.30, use Kirchhoffs rules to obtain equations for (a) the upper loop, (b) the lower loop, and (c) the node on the left side. In Figure P18.29 each case suppresses units for clarity and simplify, combining like terms. (d) Solve the node equation for I36. (e) Using the equation found in (d), eliminate I36 from the equation found in part (b). (f) Solve the equations found in part (a) and part (e) simultaneously for the two unknowns for I18 and I12, respectively. (g) Substitute the answers found in part (f) into the node equation found in part (d), solving for I36. (h) What is the significance of the negative answer for I12? Figure P18.30
For the circuit shown below, =20V , L = 4.0 mH, and R = 5.0 . After steady state is reached with S1 closed and S2 open, S2 is closed and immediately thereafter (at t = 0) S1 is opened. Determine (a) the current through L at t = 0, (b) the current through L at r = 4.0 x 10-4 s, and (c) the voltages across L and R at t = 4.0 x 10-4 s.
The current in the RL circuit shown below reaches half maximum value in l.75 ms after the switch S1is town. Determine (a) the tine constant of circuit and (b) the resistance of the circuit if L = 250 mH.
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
plss answer within 15mins In the series circuit below, suppose R= 152.88Ω, L = 60.48 mH, C = 0.45 uF, V = 18.17 V, and ω = 9045.61 rad/s. Find the current amplitude I. Final answer should be in two (2) decimal places. For the final answer, express the unit in symbols. For example: 5.00 Kelvin should be expressed as 5.00 K DO NOT answer in exponential form.