Answered: Determine the equivalent inductance for…

Determine the equivalent inductance for each of the networks of inductors shown in the figures below. Each inductor has an inductance of 100 mH. f.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 85PE: A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the...

See similar textbooks

Related questions

Q: Derive equation for induced emf across the two inductors given in figure

A: When two coils carrying time varying current are close to one another, magnetic…

Q: Q. 7: Find force on the square loop shown in Figure below. Also, find the expression of mutual…

A: Given: A square loop of length 'b' Distance between loop and wire is 'a' I1 is the current in the…

Q: See the attached picture of an RLC series circuit. Power supply voltage is given as v(t) =…

A: f=ω2π = 71.619 s-1 Inductive Reactance, XL : 2πfl = 202.497 ohm Capacitive Reactance, XC : 12πfC=…

Q: h energy is stored is 6 mH inductor with 1 amp current. Calculate the power if you consume all the…

A: Given values:- Inductance,(L)=6 mH=6 H ----(1) Current,(i)=1 Amp. ----(2) Time,(t)=100…

Q: Find an expression for the current through the inductor, and voltage across the capacitor. R21 + Vs…

Q: What circuit element is represented in the shown figure? a. a battery b. a resistor с. а сараcitor…

A: To find: The circuit element represented in the figure.

Q: Calculate the voltage and current of the inductance and the voltage and current for the capacitance…

Q: A series circuit contains a resistor and an inductor as shown in the figure. Determine a…

Q: How much energy is stored is M mH inductor with N amp current. Calculate the power if you consume…

A: Given: The inductance (L) of the inductor is M mH. The current through the inductor is N A. The…

Q: 5. In an electric circuit containing inductors, the largest induced voltage usually occurs is opened…

Q: The magnetic circuit shown in the figure has two windings and two air gaps. The core can be assumed…

Q: In the circuit, the capacitor is fully charged when switch ?S is closed. Calculate the time needed…

A: Energy stored in the inductor UL = 12Li2 Energy stored in the…

Q: The current in an RL circuit increases to 97% of its final value2 10 s after the switch is dosed.…

Q: Electrosurgical units (ESUs) supply high - frequencyelectricity from resonant RLC circuits to cut,…

A: (a)Write the expression for resonant frequency.

Q: r 2 inductors La and Le with values 150µH and 200µH.Calculate (3M) Total inductance when La and LB…

Q: The figure below shows a circuit with and ideal battery, two identical resistors, and two identical…

A: Consider the inductance of the first and second inductance be L1 and L2, respectively, the…

Q: uncharged and are ideal. Which branch will have the most current after “a long time”? Expla

Q: Describe the relationship between the charge and current oscillating between a capacitor and…

Q: 1. In the circuit below, suppose the switch has been in position A for a very long time. If it is…

A: For a L-R circuit, From boundary condition,

Q: For the circuit in Problem 5, calculate the final current flowing through the inductor if the…

A: in this question first of all we find Requivalent and then we find IL by current division.

Q: the R-L circuit shown below, is the current in the resistor always the same as the current in the…

A: The expression for the current (i) in the resistor in the RL circuit is, i=εRsinωt Here, ε is the…

Q: True or False; explain why Similar to capacitance, inductance contains only geometric information…

A: Capacitance is the ability to store energy in the form of an electric field. Inductance, which is…

Q: 3. The unit of inductance is a. Ohms b. Henry C. Farad d. Tesla

A: I ductace is ratio of induced voltage to the rate of change of current.It is represented by letter…

Q: A 15.0 kHz, 32.0 V source connected to an inductor produces a 1.90 A current. What is the inductance…

Q: Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and…

Q: In the circuit the emf ɛ = 188 volts and the inductance L= 38.4 mH. What will be the magnitude of…

Q: For the transformer shown in Figure Q3(a), determine the following: i. The turns ratio of the…

Q: Calculate the reactance of a 5.0-mH inductor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.

Q: What must be the capacitance for a station at 1700 kHz ? What is the inductance (assumed…

Q: An inductor with inductance L = 0.4H carries a current of 1A. Calculate the potential energy stored…

Q: Calculate the following: i. Current through inductor. ii. Voltage across inductor and resistor.

A: Given, R=3.3 K ohm L=10 mH Current through the circuit when the switch is closed…

Q: Q2: In the circuit shown below calculate the value of capacitor C, and the inductor L if the stored…

Q: Which of the following is not a practical type of inductor? O a. SMD Chip Inductor O b. AM Radio…

A: Inductor is a electronic device which is used to store electrical energy in the form of magnetic…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Determine the equivalent inductance for each of the networks of inductors
shown in the figures below. Each inductor has an inductance of 100 mH.
е.
f.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
Show that the SI unit for capacitive reactance is the ohm. Show that the SI unit for inductive reactance is also the ohm.
Starting with emf2=MI1t, show that the units of inductance are (Vs)/A=s.
Construct Your Own Problem Consider the use of an inductor in series with a computer operating on 60 Hz electricity. Construct a problem in which you calculate the relative reduction in voltage of incoming high frequency noise compared to 60 Hz voltage. Among the things to consider are the acceptable series reactance of the inductor for 60 Hz power and the likely frequencies of noise coming through the power lines.
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
If the capacitors in Figure 23.55 are replaced by inductors, which acts as a low-frequency fitter and which as a high-frequency fitter?
After the switch is dosed in the LC circuit shown in Figure CQ32.8, the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible? Figure CQ32.8 Conceptual Question 8 and Problems 52, 54, and. 15.