Determine the equivalent resistance between terminals a and b. ww 5 ohms 10 ohms 4.4524 ohms; The answer cannot be found on the other choices. 2.5684 ohms; 8.9374 ohms; www 15 ohms M 20 ohms 25 ohms ww 30 ohms

Q: 1. The de emitter current IE is: A. 2.62 mA 2. The ac resistance re is: A. 8.67 2 B. 9.9222 3. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Feedback: 2. An ideal series-shunt feedback amplifier has Rs negligibly small. If Vi = 100mV, Vfb…

A: Series-shunt feedback system: This system works as the true voltage amplifier because the input…

Q: Figure shows a BCD counter that produces a four-bit output representing the BCD code fo number of…

A: The truth table for given BCD counter is shown below.

Q: 3. Determine the daily load and the peak power required (with the help of daily load curve time…

A: Given Data, For LED P=20W; T=3 Hours For CFL P=10W; T=8 Hours For DC Fan P=30W; T=2 Hours

Q: Three resistors of 50 ohms, 100 ohms, and an unknown resistance R are connected in parallel and the…

A: In this question we need to find a current through 100 ohm resistor.

Q: A boost converter is a dc-to-de switched power supply in which the voltage output is larger than the…

A:

Q: B = 85. Check if approximation can be used. Show calculation proof. +Vcc=20V RB wwwww 1kn2 IB V BE…

A: Brief description: For the given BJT we need to calculate values of all the DC currents such as IB,…

Q: Given: 120V, 60H₂, 39, 6 Pole , Y-connected IM R₁ = 0.08₁ X₁ = 0.3 S = 0,031 XM = 6:33 R2 = 0.07,…

A: Given parameters are R1 =0.08 ohm X1 =0.3 ohm R2' =0.07 ohm X2 =0.3 ohm Xm =6.33 ohm slip is s=0.03…

Q: Q4: Find Vx in the network in fig.(4) using mesh (loop) analysis. 120 Yr M 30v Fig.4 lon >4VX vx≤ 4₁

A:

Q: Solve the total capacitance, total current, voltage across 6 microfarad (out of 3 choose 1) at the…

A: Given data From the above diagram

Q: 4. describe the result

A: Here we discuss about the result of the above experiment.

Q: A square loop has corners at (+40cm, +40cm), (-40cm, +40cm), (+40cm, -40cm) and (-40cm, -40cm). If…

A:

Q: Q2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Re 1.0 KM) RB www 20 KQ VBB 50

A:

Q: A sinusoidal wave traveling in the positive x direction has an amplitude of 30.0 cm, a wavelength of…

A:

Q: An 11-kV, three-phase wye-connected generator has a synchronous impedance of 6 ohms per phase and…

A:

Q: For the circuit shown below, determine the power consumed by battery 1's internal resistance.

A: This question belongs to circuit theory . It is based on the concept of power consumption by the…

Q: 120V, 60H₂, 30, 6 Pole, Y-connected IM R₁ = 0.08₁ X₁ = 0.3 S = 0,03 XM = 6.33 R2=007, X₂ = 0.3…

A:

Q: b. Determine the proper spatial sampling interval required to make small-scale propagation…

A: The minimum sampling frequency should be at least twice the frequency of the system. The proper…

Q: A three-phase, four-wire unsymmetrical supply, with a phase sequence of ACB, supplies loads which…

A: Here we deal with the fault analysis of the power system.   NOTE :- As per our company policy,…

Q: Explain 2 types of DC motors in terms of giving electric current to the rotor?

A: The solution is provided in the following section.

Q: The bus admittance matrix for the power system shown in Figure 1 is given by 3-j9 −2+j6 -1+j3 0 Ybus…

A: Gauss-Seidel (G-S) method is one of the simplest iterate method. It is a modification of…

Q: Q1: Using a 50 nF capacitor in the parallel RLC bandpass filter with a quality factor of 5 and a…

A:

Q: Find current through R2 resistor. R1 R3 10 12 II +vi 10 Select one: O a. 3.04 h 267 NO (+1

A: current in R2 is determine by using simple nodal analysis it is given as-

Q: 2. Use the Kirchoff's Laws for the Circuit R₁ R₂ www 10 Q 25 220 V L RESISTANCE (R) RTOTAL R₂ 15 02…

A:

Q: Feedback: 3. An ideal shunt-shunt feedback amplifier has Rs =∞ . If Ii = 100 microAmp, I fb = 99…

A:

Q: Low Frequency Response: Compute for the following. b. Av

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: Given: 120V, 60Hz, 3phase, Yconnected, 1M R1= 0.08 X1= 0.3 R’2= 0.07 X2= 0.3 S= 0.03 Xm= 6.33…

A:

Q: Q1. Determine IE, VBE, VCE, and VCB in the circuit. Assume BDC = 150. Rc 390 RB wwww. w 8V 88 Assume…

A:

Q: For the circuit shown, find the Thevenin and Norton equivalent circuit to the left of terminal A and…

A:

Q: Find current through R2 resistor. R3 10 12 PE 11 V1 10 Select one: O a. 3.04 O b. 2.67 O c. 3.75 O…

A: Given circuit,

Q: The load shown below is connected to a 360 V, 50 Hz three-phase supply with a positive phase…

A: The load shown below is connected to a 360 V, 50 Hz three-phase supply with a positive phase…

Q: Q2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V.

A:

Q: R₁=56 20v A) RTOTAL = B) I TOTAL = CV-TOTAL = R67 E) V3 11 R3-20 R₂=55 R5=45 R6 = 3 R₁-252 R7 = 3

A: circuit is solve as Rt is calculated by series and parallel combination of resistance

Q: Find the Laplace transform of f(t) = 10 coswtu(t). Answer: 10s/(s² + ²).

A: Given f(t)=10cos(wt)u(t)

Q: The Laplace transformation of equation is given by: V₂ S Apply initial condition How? Taking the…

A:

Q: 外的 Si 7mA 22.2k2 *1.2 Q os

A:

Q: QUESTION 5 R www L roo + + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to…

A: In this question we need to find a amplitude of voltage Vo only when sinusoidal voltage source is…

Q: From the figure shown below, find the modulation index, then write an equation represents the shown…

A:

Q: I need to convert the drawing from a handwritten drawing to a computer print font or with the…

A: Discrete Time Signal: Time is considered as a discrete variable in discrete time, with values of…

Q: Use Mason's Rule to reduce the following signal flow graph to a single transfer function. G₁(s)…

A:

Q: what are the circuit that used to convert PWM to PPM? 3:43 ✔

A: PWM - Pulse width modulation PPM - Pulse position modulation   ---> The PPM Signal can be…

Q: 3, R2=15, 11=27 A & K1=2 in the shown circuit, Find the Norton equivalents at terminals a-b of the…

A:

Q: (a) Point charges of 1 nC and 2 nC are located at (0, 0, 0) and (1, 1, 1), respectively, in free…

A:

Q: 01: Explain the following briefly: a) Access Time, b) Seek time, c) Transfer time, d) ROM, e)…

A: ROM is the read only memory it is a non volatile memory. it receives the data and permanent writes…

Q: How can I be safe with electricity?

A: Always use gloves while working with electrical equipment and gloves must be insulated. While…

Q: 7. In this problem, use without proof the fact that rect(t) convolved with itself is tri(t). Use…

A:

Q: A combinational circuit with four inputs (A, B, C, D) and one output (Z) is designed as follows…

A:

Q: An air-filled parallel-plate capacitor has plates with an area of 2.5 cm² separated by 1.5 mm. The…

A: Given,For an air-filled parallel-plate capacitor,Area, A=2.5 cm2Distance, d=1.5 mmPotential…

Q: Q10-Design Colpitts oscillator to generate sine wave with frequency equal to 3 KHz, with gains equal…

A: The colpitt's oscillator circuit contains a tank circuit and it acts as a feedback network for…

Q: Question No. 1 The switch S₁ of figure 5 has been closed for a long time. At t=0sec, S₁ is opened,…

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.