Determine the percent uncertainty in sine when 0 = 55.0° ± 0.7° . Include 2 digit after the decimal point and maximum of 5% of error is accepted in your answer.

Q: Question 1. For a cone with a base radius of 0.45 m and a height of 2.18 m, if the error in the…

A: Here given the radius of a cone is 0.45 m and the height is 2.18 m. The error in the radius is E1,in…

Q: Each 4 m length of a long cylinder (radius = 3 cr throughout its volume. What is the magnitude the…

A: Given Length of cylinder, L=4 mRadius of cylinder=3 cmCharge, q=17 nC=17×10-9 CDistance of point…

Q: Chapter 1- questn-9 If the dimensions of a physical quantity is ML what is it's SI units?

A: Given physical quantity is, ML/T2

Q: Show whether or not the following equation is dimensionally correct. Note that [s] = L, [v] = L/T,…

A: For an equation to be dimensionally correct, its dimensions must be equal at both LHS and RHS. The…

Q: P (t) = PmaxCos (Bt) If t is measured in seconds, what value should the quantity B have? B = If t is…

A: The value of quantity B.given,P(t)=Pmaxcos(Bt)frequency(f)=349 Hz

Q: For questions 1-3, suppose that in cr2 S = we have that the error in measuring r and L are ±2% and…

A: ; errors: r = ±2% L = ±5%

Q: Carry out the following arithmetic operations: (a) the sum of the measured values 756, 37.2, 0.83,…

A: (a) In addition, the result is rounded to least number of significant figures after the decimal The…

Q: Estimate the number of jelly beans in the jar of Fig. 1–18. FIGURE 1–18 Problem 45. Estimate the…

A: Assume that the jellybeans are packed very close to each other and that there is very little empty…

Q: Show whether or not the following equation is dimensionally correct. Note that [s] = L, [v] = L/T,…

A: Given data: s=Lv=L/Ta=L/T2t=T v2=2as-3(vs)/t+7a2t

Q: A surveyor measures the distance across a straight river by the following method: Starting directly…

A: Given:  x = 100 m  θ = 35.0°

Q: Carry out the following arithmetic operations: (a) the sum ofthe measured values 756, 37.2, 0.83,…

A:

Q: Given that the average size of a human skin cell is about 10 microns across, which of the following…

A: Scientists estimate that the human body is made up of around 10 trillion cells in total. Your skin…

Q: Question No. 1 A physical quantity is measured and its value is found to be equal to nu, where n is…

A:

Q: find te dimension of Streess in SI unit and CGSunit.

A:

Q: factors in Appendix E.. {A E14. The volume of a cube is found by multiplying length times width…

A: In a cube length, width, and volume all are equal. Let the side ( length = width = height) of the…

Q: 1) Perform the indicated mathematical operations. State the uncertainty of the final answer as ±…

A: In the given question, the calculations can be performed as,

Q: Which of the following equations are dimensionally correct?(a) v f=vi +ax(b) y=(2m)cos(kx), where…

A: To determine: Which of the following equations are dimensionally correct?(a) v f=vi +ax(b)…

Q: QUESTION 3 For the following three measurements trials L1 L2 L3 Length (cm) 2.3 2.5 2.9 Calculate…

A: First calculating the true value from the data; L=L1+L2+L33=2.3+2.5+2.93=2.567 cm

Q: 48. You are working with the formula V = ²h. You are given values of r= 1.00 ft and h = 2.00 ft.…

A: Detailed solution of given question is given in below steps.

Q: Four students use different instruments to measure the length of the same pen. Which measurement…

A: Precision is known as the  accuracy in measurement of a physical quantity.the units of measurement…

Q: Can anybody tell me about the ending 0 in these numbers, why we include it in determiining "sig…

A: In 0.0210, the number of significant digits is 2. Because of the zero on the right side of the…

Q: Carry out the following arithmetic operations. (Give your answers to the correct number of…

A: (a) Sum of the measured values 756+37.2+0.83+2=800 (b) The product 0.0032×356.3=1.1

Q: Zero error is +0.005 cm, What is the correct diameter?

A: Given data,  Least count =0.01 mmIt is used to measure the diameter of a wire.Reading of the sleeve…

Q: Can you approximate the height of one of the buildings on your campus, or in your neighborhood? Let…

A: Height of a building

Q: Can you clarify the "sin" it looks like three times please, what are those digits exactly please?…

A: Maximum height calculation formula for projectile have square term of sinθ. i.e. sin2(θ)

Q: Carry out the following arithmetic operations. (Enter your answers to the correct number of…

A: a)533+35.0+0.80+9=577.8Here 533 has no decimal place significant figure than answer shouldround off…

Q: Evaluate each of the following to three significant figures and express each answer in SI units…

A:

Q: what is the minutes the error taken for hours if greg to hours tarren?.

A: we know, 1 hour = 60 min time taken = 10 min = 10/60 hours = 0.166 hours error in time =± 0.3 min =…

Q: A lecture period (50.0 min) is close to 1.00 microcentury. (a) How long is a microcentury? (b) Usin…

A: (a)we know that,minutes in 1 century=52.6×106 minutesminutes in 1 micro century= 52.6 minutes

Q: The first several digits of p, the ratio of the circumference tothe diameter of a circle, are p =…

A:

Q: The following is known about three numbers: Three times the first number plus the second number plus…

A:

Q: A surveyor measures the distance across a straight river by the following method: Starting directly…

A:

Q: Using dimensional analysis, evaluate the following and report in the unit required. Be sure to use…

A: Basic rule of significant figures which is followed while adding or subtracting numbers is that the…

Q: A spelunker is surveying a cave. She follows a passage 180 mm straight west, then 290 mm in a…

A: The diagram of the given problem can be made as follows:

Q: P V =

A:

Q: A watch manufacturer claims that its watches gain or lose no more than 8 seconds in a year. How…

A: Number of seconds in a year is,

Q: Now you will use the ruler to measure the dimensions of a block of pure aluminum metal. Make sure…

A:

Q: Which of the following equations are dimensionally (units) consistent? 1. v = 1/2at2 2. t = v/a…

A:

Q: Must two physical quantities have the same dimensions if you are subtracting them? Select one O True…

A:

Q: A quadrilateral shaped area given by the following measurements have these corresponding probable…

A: Perimeter is sum of all four sides. In summation , error is sum of numerical value of all errors.…

Q: In a measurement of B two results were obtained, B1 =(1.62 +/-0.57) mT and B2 = (1.60+/- 0.38) mT…

A:

Q: The volume of the rectangular block in the figure is calculated from the following measurements of…

A: Given: da = 0.10 cm a = 10 cm db = 0.06 cm b = 5 cm dc = 0.04 cm c = 4 cm   We have the volume of…

Q: 1. Significant Figures Solve the following problems: В. 5.02 x 106 has 200.00 has, _significant…

A:

Q: U.S. football field is 120 yards long (including the end zones). How long is the field in the…

A:

Q: Use dimensional analysis to determine which of the following equation is certainly wrong: mv v=…

A:

Q: Estimate the number of breaths taken by a human being during an average lifetime.

A: The typical life span of a human being is 70 years and the rate of respiration is about 10…

Q: A prism with square base each side with length x, height h.The measurements are: x = 25.3 +/- 0.5 cm…

A: Given value--- length  = 25.3 +/- 0.5 . height = 35 +/- 0.3 . We have to find--- dv in cm³ ?

Q: Which of the following equations are dimensionally consistent? (a) v = at, (b) v = 12at2, (c) t =…

A: a V=at     For dimensional stability , both side should have same dimensions .   LT-1=LT-2T…

Q: 128. Compute the relative error and absolute error when measuring the area of a rectangle of length,…

A: As per guidelines, only first , Q.138 is solved her. L = (10±0.2)m W = 6±0.1m We know that area =…

Q: What is the difference between accuracy and precision? Explain Calculate the volume and percent…

A: Note:-  “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Estimating Errors for Multiple MeaSurements of a Physical Quantity Using variance Distance (M)…

A: Actual value of a physical quantity x = x1 + x2 + •••••+xn /n

Q: Problem 16. Consider the physical quantities m, s, v, a, and t with dimensions [m] = M, [s] = L, [v]…

A: Given data:  The dimensions of m, s, v, a and [m] = M, [s] = L,  [v] = LT-1, [a] = LT-2 and [t]  = T…

Q: Compute For the relation between the cubic inch and the cubic om by taking the ratio of the volume…

A: Volume of the wooden block = a * b * c ( where a, b & c are av. length , av. width and av.…

Q: Problem 1: A rectangular box is h = 4.5 inches in height, w = 39.5 cm wide, and L = 1.1 yards long.…

A:

Q: How many significant figures are there in 0.003048

A: 0.003048

Q: The area of a circle is given by ar? where r is the radius. This can be written as area = (tr) × r.…

A:

Q: Using the laws of logarithms and exponentials solve the voltag battery 9*+1 – 36 3* + 27 = 0 log,(2x…

A: c) 3) We know that We have given the voltage  in a charging capacitance as a function of time  as…

Estimate of calculation