Determine the vertical rise h of the load W during 10 seconds if the hoisting drum draws in cable at the constant rate of 180 mm/s. M W

Q: #3. A ball tossed straight up has v = 0 [m/s] at its highest point. Is it in equilibrium? A) YES B)…

A: When a ball is thrown straight up, its velocity goes on decreasing and at its maximum height the…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A: a. The required tension in the rope is

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A:

Q: The bagger at Krogers filled your grocery bag with 10kg of stuff. If you pick up the bag and…

A: Given data The mass of the bag is m = 10 kg The tensile strength of the bag is T = 100 N The…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(a) to support a car engine of mass…

A: Given that, Mass = 140kg  As per given we have to neglect the pulley system mass then drawing free…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A: (a) Consider the diagram in Figure 5.18(c) and calculate the tension in the rope.

Q: 2. A force of 800 N acts on a bracket as shöwn. force about B. the 800 N 60 s ce 160 mm 200 mm

A: Force is an external agent that has the ability to change the state of rest or motion of a certain…

Q: When using a pencil eraser, you exert a vertical force of 6.00 N at a distance of 2.00 cm from the…

A:

Q: When using a pencil eraser, you exert a vertical force of 6.00 N at a distance of 2.00 cm from the…

A: a. the cross sectional area of the pencil is The shear force on the pole act in perpendicular…

Q: 2. Block A in the figure weighs 100 N, p = 0.35 and W = 30 N. The system is in equilibrium. a) Find…

A:

Q: A 3491kg car is going up the Amerat hill, at angle 14.4, with 2 people inside the car each of 76kg.…

A:

Q: View Available Hint(s) Fmin Submit Provide Feedback Next > rch LOO 9:27 PM Th 72°F 3/24/2022

A:

Q: AN 7. A block of mass 5 kg is being pulled along a board horizontally with a constant velocity; the…

A: Along vertical, net force must be zero.  So, weight of block is balanced by normal force. Since,…

Q: FIGURE 9 Figure 9 shows a weight, w pounds (Ib), sliding down an inclined plane wh an angle a with…

A: Given:- The weight of the object is  W and it slides down an inclined plane which makes an angle α…

Q: A 1.50×103 kg car, whose front is facing to the right (towards +x-axis) and whose engine is turned…

A:

Q: A 3kg block starts from rest at the top of 30o incline and slides with a = 1.78 m/s2. Find (a) the…

A: mass (m) = 3 kg initial speed (u) = 0 msangle (θ) = 30oacceleration (a) = 1.78 ms2

Q: 1. The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 6. A 1.60 kg box rests on a plank that is inclined at an angle of 58.0° above the horizontal. The…

A: Free body diagram of the problem -  Therefore, Balance equation will be -  kx=mgsin58o+Fk Where,…

Q: Spring scale A is attached to the floor and a rope runs vertically upward, loops over an ideal…

A:

Q: A 0.400-kg pendulum bob passes through the lowest part ofits path at a speed of 3.00 m/s. (a) What…

A: (a)The tension in cable will be the sum of the centripetal force and weight of the bob.

Q: R14–1. If a 150-lb crate is released from rest at A, determine its speed after it slides 30 ft down…

A: Given Data: The weight of a crate is, W=150 lb The coefficient of kinetic friction is, μk=0.3   The…

Q: In reality, the product r*v remains fixed when the string is pulled in. That means that v increases…

A:

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(a) to support a car engine of mass…

A: (a) Calculating the tension in the rope:

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A: (a)   Consider the diagram (c), write the expression for the mechanical advantage (MA), that is, the…

Q: The system moves at 1.50 m/s² while the inclined planes are rough. a) Determine the coefficient of…

A:

Q: A) B) Draw the free body diagrams. OB - 6 2.75 G0 mm

A:

Q: A bag is gently pushed off the top of a wall at A and swings in a vertical plane at the end of a…

A: In this case, position 1 is at A and the position 2 is at B.   Use the work-energy theorem,…

Q: Explain why the friction when they are smooth an

A: Required : Why the friction is reduced when the surfaces of two wood pieces are polished.

Q: Researchers have found that a gecko’s foot iscovered with hundreds of thousands of small hairs…

A: (a)

Q: Determine the velocity of the aircraft flying at 2500 m, when the dynamic pressure is 45N/m^2?…

A: Given∆P=45 N/m2h=2500 m2

Q: 2. A 50 kN block rests on top of an inclined plane, 25° with the horizontal. Also, a 10 kN load is…

A: The free-body diagram of the block on the inclined plane is shown below. Here, m is the mass, N is…

Q: to the right (towards +x-axis) and whose engine is turned off and in neutral, is held at rest on a…

A:

Q: a) Find the tension in the strings shown. 30 50 30 45 65N 1kg

A: As per our  guidelines we are supposed to answer only one question. Please repost the other…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(b) and find it necessary to exert a…

A: Write the expression for net force acting on the pulley in Figure (b).

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(b) and find it necessary to exert a…

A: (a) Consider the figure 5.18(b), apply force equilibrium on the lower pulley, and solve for the mass…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A:

Q: A block moves down an incline (40 degrees) starting from rest. After moving 5 meters along the…

A: Given Angle of the incline θ = 40o Distance travelled S = 5 m Initial velocity u = 0 Final velocity…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(c) to support a car engine of mass…

A:

Q: Let's go back to the toboggan we studied in Example 5.10. The wax has worn off, so there is now a…

A:

Q: B. The ends of three 8-ft studs are nailed together, forming a tripod with an apex that is 6 ft…

A: Solution: The three ends of the studs is forming a tripod, as shown in the figure below:…

Q: A1. Consider this combination as a single "effective" spring. (Imagine it's contained in a box and…

A: Given Rest length of spring= lo Spring Constant = k Elongation = ∆l Stretched length = lo+∆l Force…

Q: Suppose you use an ideal pulley of the type shown in Figure 5.18(a) to support a car engine of mass…

A: According to the question statement, we are only considering image (a). Here, If the tension of the…

Q: Tendons are strong elastic fibers that attach muscles to bones. To a reasonable approximation, they…

A:

Q: A box of weight W is pushed downwards a rough inclined plane (kinetic friction coefficient u) with…

A: Free body diagram of box,

Spring Potential Energy

The potential energy is the energy possessed by a body by virtue of its position or the energy held by the object due to its position relative to other objects, its force like stresses, charge, and other factors affecting the particles of the body. The potential energy is the measure of the net work done by or on the body. The spring potential energy is the potential energy stored due to the deformation of an elastic spring and this elasticity is due to the stretched spring. The elasticity is the ability of a solid-state matter to come back to its equilibrium position or original position after any kind of external force is acted on it. It is also known as Elastic potential energy. The potential energy here is caused due to the displacement of the spring from its equilibrium position to another position and this potential energy is equal to the net work done due to the stretching of the spring. It also resembles the same mechanics of the oscillation of a simple pendulum, where due to the external force, the object moves from its equilibrium position to its maximum ends and the periodic motion continues till it comes back to the equilibrium position to rest.