Determine the width of a a.) apron conveyor b.) flight conveyor without skirts whose capacity is 56 tons per hour at a speed of 50 fpm handling solids with an average density of 50 pounds per cubic foot.

Q: Determine the required wind speed in

A: Determine the Wind speed.

Q: Q2: A wind turbine gives maximum output put of 3MW at a wind speed of 15m/s. Calculate the length…

A:

Q: O N/m. l1=0.4 m and l2=0.6 m. A. Pump

A: data given Motor pump system Mass m =50 kg mass moment of inertia J0 =100 lg/m2   spring stiffness…

Q: Locate where are the part in the roller coaster design having high and low kinetic and potential…

A: In this problem, it is asking where the high and low kinetic energy and potential energy will occur.

Q: QUESTION 2 Calculate the difference between the free surface SG=0.90 1 m Water Figure 2 0.4 m Ah ++

A: To find: The difference between the free surface . Given: The density of water is ρ=1000 kgm3. The…

Q: FRICTION weighs 520 lb. The coefficien

A: To Find : The friction force acting on the body .  Given: The Weight of block is m = 520 lb  The…

Q: Flow Pump 6-in Schedule 40 4-in Schedule 40 4 in Engine Oil 30 in Mercury (sg =13.54)

A: Calculate the pressure change from point 1 to point 2. P1-ρoilg4 in-ρhgg30 in+ρoilg34…

Q: Explain how conveyor belt water system cab overcome water flow issues

A: Temperature and salinity drive the worldwide ocean conveyor belt, which is a continually moving…

Q: NET THRUST - POUNDS THRUST LAPSE RATE APPROX. 36,000 FT. ALTITUDE - FT.

A:

Q: Problem No. 1 A Paul is Driving a Car and travels 100 km East in 3 hours and decided to back West…

A: Problem No. 1 Given: Distance travel in East direction d1=100 km, Time of travel in East direction…

Q: Write any four advantages of Vertical Axis wind turbine.

A: A vertical axis wind turbine is a type of wind turbine in which the main rotor shaft is transverse…

Q: Find total head

A:

Q: e lift slope for a straight wing is

A: Given: Aspect ratio= 5 Lift slope for airfoil section = 0.1/degree To find Lift slope for straight…

Q: What is probable length of blade if the wind turbines are separated with the distance of 200 m?

A: The spacing between two wind mill is around 3 to5 times the diameter of blades. Therefore, S=3D to 5…

Q: Convert the ff.   8 ft 2.25 in as m

A: General conversion concept: 1 meter = 3.28084 foot 1 meter = 39.3701 in

Q: Dynamic

A: ωAB=12 rad/svB=ABωAB=12*.2=2.4 m/sVB=vB→;VD=vD↑ Instantaneous center of bar BD lies at C…

Q: List 5 constraints of a windmill.

A: Constraints of windmill are listed below.

Q: need of Fair is su s 310 m

A:

Q: chain wit RS=102.3m

A:

Q: Option (1): Fluid in outer channel-Air, Fluid in inside channel - Water, Option (2): Fluid in outer…

A: heat transfer is proportional to the Nusselt Number. and  Nu α  Pr0.4

Q: voman wishes to walk on the muddy soil in able to cross her way b essure greater than 0.47kPa.…

A: The solution of the above question can be obtained by applying the mathematical formula for the…

Q: Gate 6-ft wide M 459 Water 4 ft 2 ft 1 ft So=6

A:

Q: Calculated average water flow the city.

A: A continuity equation, also known as a transport equation, is a formula that explains the…

Q: An aluminum cube with an edge of 5 cm is resting on the ground on one of its faces. calculate the…

A: Given data  s= 5 cm = 0.05 m  d= 2700 kg/m³  Note: diagram is not necessary for the understanding…

Q: Place the correct formula in the blank %To determine Generated Power Output of Wind turbine

A: Given:- Wind turbine:-   To find- Power formula

Q: Shape factor S=M/N, N isShape factor S=M/N, N is

A: Shape factor defines the ratio of the under which two surfaces project over one another.

Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…

A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…

Q: Diagram of the problem, necessary formulas, clearance and numerical solution It is planned to lift…

A:

Q: The impeller of a radial pump with diameter of 34.2 in such that its head is reduced by half. What…

A: Initial diameter of the impeller, D1= 34.2 in Initial head= H1 Given that head is reduced to half.…

Q: b) Convert 670 mmHg ft to metric horsepower·h

A:

Q: -Q4:- If the wind speed measured on 10 m height from the earth. What the height of wind turbine…

A: Given Data The height from the earth surface is: h=10 m The speed of the wind is: V2=5 m/s To…

Q: (B) A thrust bearing shown in Fig.(5) consists of a 10cm diameter pad rotating on another pad…

A: Determine relation for torque using Newton’s law of viscosity

Q: 1- State the differences between ropes elevator and hydraulic lift if th C

A: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: of 300 mm running at a speed of 2950 rev/min delivering 45 similar spare pump running at a speed of…

A:

Q: Convert between energy units. 567 Cal to J

A: The energy is E=567 cal. The unit conversion factor to convert Calories into Joule is, 1 cal=4.184…

Q: of span 100 m and

A:

Q: What is probable length of blade if the wind turbines are separated with the distance of 160 m? a.…

A: we know that , It has long been believed that distances between 6 and 10 times the diameter of the…

Q: Prove that 1HP = 746W

A:

Q: 0 kg, what power is required to maintain an uphill speed of 10 km/h

A:

Q: th a spring with spring co hitial position ro = 5 m a in meters.

A:

Q: Th4 Base is Snmly moved wilh The Veloci ky of 5 m/s Find The Velociy and Acceloratronof Head

A: Let the width be x ft length = (3x−70) ft Perimeter = 940 ft Also Perimeter of rectangle = 2(l+w)…

Q: 5. Flow occurs over a spillway (Figure). Determine the horizontal force on the spillway per foot of…

A:

Q: 25 m at a spee olose to the

A:

Q: The impeller of a radial pump with diameter of 34.2 in trimmed such that its head is reduced by…

A: Given data   Initial Diameter of Pump = D1 =  34.2 inFinal Head = Initial Head2H2 = H12We have to…

Q: An aircraft is required to climb with 10° of climb angle. The aircraft has a mass of 30,000 kg and…

A: Given data :-  Angle of climb - 10° Mass of aircraft = 30000 kg Drag = 50000 N Find the lift must be…

Q: CLow b = 36 Wing: CLO 4 = 21 ft 4 = 18.5 ft Clow Tail:

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.