Th4 Base is Snmly moved wilh The Veloci ky of 5 m/s Find The Velociy and Acceloratronof Head

Q: Sketch the hydraulic motor, show the direction of rotation of the rotor and the direction of…

A: Disclaimer : “Since you have asked multiple question, we will solve the first question for you. If…

Q: Determine the time required that the elevator travels at any instant at a distance of 8 meters. The…

A: this question is multipart type so i have answered very first question accordingly company policy

Q: A tap discharges water evenly in a jet at a velocity of 2.6 m/s at the tap outlet, the diameter of…

A: Let point 1 be the datum line. Let point 2 be the tap outlet.

Q: A refrigerating system operates on the reversed Carnot Cycle. The higher temperature of the…

A:

Q: Water is the working fluid in an ideal Rankine cycle. Superheated vapor enters the turbine at 10…

A: Given data as per the question p1=10 Mpa=100 barT1=4800CP3=6kpa=0.06 barηT=0.84ηP=0.73 Considering…

Q: shaft in torsion only is to transmit 2500 hp at 570 rpm. Its material’s allowable shear stress is 10…

A: as per guidelines we need to answer only first 3 subparts

Q: What is the difference between modal and nonmodal G codes?

A:

Q: Derive the kinetic energy equations and the mass equivalents of the system shown.

A:

Q: Q1: A flat plate 2m long, 1m wide and 10mm thick. If a uniform tension is applied in the…

A:

Q: A bicyclist starts from rest and after traveling along a straight path of 20m, he reaches a speed of…

A: Using Newton's law of motion to solve this problem Find  a, t

Q: a) The stress in the wire. Answer in MPa b) The strain in the wire. c) The increase in the length of…

A:

Q: Helium is used inside a 7.19m diameter spherical balloon. The said substance is at 98.499 kPa and…

A:

Q: Find the specific gravity of a fluid having viscosity 0.05 poise and Kinematic viscosity 0.035…

A: The specific gravity of a fluid with a viscosity of 0.05 poise and a kinematic viscosity of 0.035…

Q: s peed TC the meter-in circuit shown in the figure? The load weighs 2,908 Ibs and the cylinder…

A: Given data→Load (p)=2908 lbs Piston area(A0)=3.7 in2Rod area(Ar)=1.4in2Specific weight= 53.23…

Q: A ventilating fan discharges 5 cubic meter/sec of air through a 87cm diameter duct against a static…

A: Given data, Discharge rate, Q = 5 m3/s Diameter of the duct, d = 0.87 m Static pressure head, hs =…

Q: 3. For a single element beam as shown in figure below, its equivalent nodal load matrix should be W

A:

Q: forced draft centrifugal fan draws air at 1.32 cubic meter/sec towards a combustion chamber of a…

A: Write the given value of initial and final pressures and convert them into SI units. Here, P2 is…

Q: Why does the shape of the passenger cabin windows on modern airplanes are rounded or elliptical? Why…

A: Given question: Why does the shape of the passenger cabin windows on modern airplanes are rounded or…

Q: For the wheelbarrow in the fiqure the center of gravity of a net load of 40 kg is located 50 cm from…

A:

Q: y b k.. a

A: Diameter of the part= a Diameter of the hole= c Distance between top edge of the part and top edge…

Q: A 3200 lb car traveling with a speed of 60 mph rounds a curve whose radius 484 ft. Find the…

A:

Q: The specific volume of a certain gas is 0.7m/kg. Determine its specific weight and mass density.

A: Find the density and specific weight.

Q: C 3 ft B 0.8 ft A

A:

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

A: Given:v1=3.7 m/st=3.5 sec

Q: Energy storage devices that use spinning flywheels to store en- ergy are becoming available. To…

A: An external agent of push or pull which is responsible to change the state of the object from moving…

Q: Solve for the pressure differential in Pa if the temperature inside a 5.44m vertical wall is…

A: Given Data The temperature of inside wall is:Ti=23.34°C The temperature at outside is:To=-17.78°C…

Q: 32. A container has water. If the water level is 0.5 m and water density is 10³kg/m³, the pressure…

A: Pressure is directly proportional to density of fluid and height of fluid in the tank

Q: An elevator is accelerated upward at 2 ft/s², if the elevator weighs 500 lbs, what is the tension in…

A: Given that: Upward acceleration of the elevator = 2 ft/s2 weight of the elevator = 500 lbs It is…

Q: Determine the external reactions at A and F for the roof truss loaded as shown. The vertical loads…

A:

Q: 1. A 75 m high wind tower with a 50 m rotor diameter has been constructed in a region that follows…

A: Given: The height of wind tower, H = 50 m The diameter of rotor, d = 50 m The coefficient of shear…

Q: 3. The 4 kg box shown in the figure start from rest at t = 0 in which the friction is negligible.…

A:

Q: 2.) An automobile lift raises a car weighing 3000 lbf, 6 ft off the shop floor (Fig. 2-12). Assuming…

A:

Q: The flow profile in a straight microfluidic channel with a square cross- section is parabolic if the…

A: The well-known phenomena of electroosmotic flow is induced using microfluidic tubes constructed…

Q: Air enters the diffuser of a turbojet engine with a mass flow rate of 70 lb/s at 9 lbf/in2, 420°R,…

A: T-s diagram of the system is Given data, Mass flow rate of air, m˙=70 lb/s Pressure at state 1, P1…

Q: The image below shows a linkage at a scale of 1:1. A is the driver and rotates CW at 5 rad/s. The…

A: Given data ωA = 5 rad/sWe have to find the rotational velocity of B for the configuration given…

Q: The simply supported beam consists of a W21 x 44 structural steel wide-flange shape [E = 29,000 ksi;…

A: (a) Draw the free-body diagram of the given beam. Apply force equilibrium in horizontal direction.…

Q: Convert vacuum gauge reading 200 mm of Hg into absolute pressure in N/mm".

A: We must convert a vacuum gauge reading of 200 mm Hg into absolute pressure in N/mm2 in this problem.…

Q: A ballast-type accumulator with a 3,000-in. capacity is heated from 70°F to 225°F. What will be the…

A:

Q: processing plant is convectively heating a solid half-sphere of radius of 12 cm made of pure…

A:

Q: 1. List major differences between nonpositive displacement and positive displacement pumps.

A: To find :- Difference between non positive displacement versus positive displacement pump.

Q: The momentum thickness OM for laminar flow over a flat plate is (115/1134) 6. Find the following: a)…

A:

Q: A basketball player applies a force F-89 lb to the rim at A. Determine the equivaleot force-couple…

A:

Q: 1 A beam is subjected to a moment of 972 k-ft. If the material the beam is made out of has a yield…

A: Section modulus is used to determine the strength of materials which subject to loads, moment or…

Q: 7. Calculate the displacement at the free end of the inclined beam shown in Figure P3.7.Repeat the…

A:

Q: Q8: The 25-kg bar BD is attached to the two light links AB and CD and moves in the vertical plane.…

A:

Q: Consider an aligned fiber reinforced-polymer matrix composite for which the constituent fibers have…

A: Tensile strength is the highest load a material can withstand without cracking when stretched,…

Q: A- What is the system which used in Lorry braking ?, what is the advantages and dis advantages of…

A: Given question:What is the system which is used in Lorry braking? What is the advantage and…

Q: 5. A refrigerator with tetrafluoroethane as refrigerant operates with an evaporation temperature of…

A:

Q: Calculate the partial pressure and gas-phase concentration (in ppm) of i-pentane in air when air at…

A:

Q: Exercise: Develop an IPR curve for the well described below. The drainage radius is 1490 ft and the…

A: Interproximal reduction (IPR) (also known as interproximal enamel reduction (IER) / slendering, air…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.