:Determine the y-coordinate of the centroid of the shaded area. 80mm 60mm 60

Q: Find the efficiency of the Carnot heat engine operating between 427 C and 77 C.

A: Given, Higher temperature of Carnot heat cycle = TL = 427 oC = 700 K Lower temperature of Carnot hea...

Q: 3x+2 <0 2x -7

A:

Q: A glass tube is attached to a water pipe, as shown in the figure. If the water pressure at the botto...

A:

Q: Determine the deflection at point B given the cross-section of the beam and assuming E = 200 GPa.

A: Given data, Young's modulus of the beam material, E = 200 GPa To determine, the deflection of the be...

Q: 8. Compute Ihe maximum shear force in Ihe beam. 100 lb 200 20 in the oem if is Cubecad

A:

Q: Question 1 Complete the following table for water. Show all steps taken in order to fill the blanks....

A:

Q: The velocity of a particle is v = { 3i + (6 - 2t)j} m/s where t is in seconds. If r = 0 when t = 0, ...

A: Given Data  v = { 3i + (6 - 2t)j} m/s

Q: Steam at a velocity of 60 m/s and 250°C and 7 bar absolute is expanded through a nozzle to 200 C and...

A:

Q: 3. Collar P is attached to rod AP which rotates at a constant angular velocity of 4 rad/sec counterc...

A:

Q: Consider two cases of vaporization of a saturated liquid to saturated vapor at constant pressures of...

A:

Q: A second unidirectional composite also comprises aligned continuous fibres in an epoxy matrix but wi...

A:

Q: Pa. The required gauge pressure is

A: To find gauge pressure

Q: I am trying to figure out how much heat is gained through a 1 ft^2 glass windowpane with the above s...

A: Given   Area, A = 1 ft2               = 0.0929 m2 Temperature, T = 35oC                          = 3...

Q: with a length of 7 cm. "A" is on the left side Link 2 (AB) - 2 cm in length. Initially 30 degrees ab...

A:

Q: nowmobile and he accidentally rides it off a cliff! Point A has a velocity of -1.5 Point B has a vel...

A:

Q: In the special position shown for the log hoist, booms AF and EG are at right angles to one another ...

A:

Q: For final answers: h and u (correct to 2 decimal places), s and v (correct to four decimal places). ...

A: For 102.7 KPa: From the steam table: Saturation temperature→Tsat1=101°C=374 K  Entropy of saturated ...

Q: A current problem in the U.S. Air Force is the neck/shoulder fatigue experienced by pilots. To be ab...

A: Given data Center of gravity of goggles = 20 cm in front of neck pivotLoad of goggles = 1 kgCenter o...

Q: wo blocks A and B each weighing 250 N are connected by a weightless flexible cable as shown in the f...

A:

Q: The demand for a two-wheeler was 900 units and 1030 units in April 2015 and May 2015, respectively. ...

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below. Th...

A: The equation based on the principle of conservation of mass is called the continuity equation. thus ...

Q: uryer eharges ameter, well-rounded vent with negligible loss is n en connected to a 15-ft-long, 5-in...

A: select point (1) toward be inside the drier and point (2) toward be the exit of the drier.consider t...

Q: I am trying to figure out how much heat is gained through a 1 ft^2 glass windowpane with the above s...

A: Given   Area, A = 1 ft2               = 0.0929 m2 Temperature, T = 35oC                          = 3...

Q: Discuss a case study where the mechanical hazard caused an accident, determining:  - the cause of ac...

A: Given Mechanical hazard To find Cause of accident Consequences of accident Safety measures

Q: Q1) Consider the type one servo system given by:

A: To determine controllability &amp; observability of the system

Q: Find the maximum stress developed in a stepped shaft when it is subjected to a: i) Torque of "T" Nm....

A:

Q: Find the magnitude direction of the force 3 acting compressor if (gamma)os 16 ib/ ft³ ,A is 4ft? v i...

A: given; density of fluid (ρ)=16lb/ft3inlet area (A1)=4ft2inlet velocity(V1)=12ft/sdeflection angle (δ...

Q: How does polishing a connecting rod in a high speed internal combustion engine help to reduce the po...

A: Connecting rod used to transmit the compressive and tensile load transmitted by crankshaft. Rod fail...

Q: I am trying to figure out how much heat is gained through a 1 ft^2 glass windowpane with the above s...

A: Given   Area, A = 1 ft2               = 0.0929 m2 Temperature, T = 35oC                          = 3...

Q: Q1: A wheel has an initial clockwise angular velocity of 10rad/s and a acceleration of 3rad/s2. Dete...

A: According to the company policy I can give you only 1 question answer If want answer second question...

Q: Complete the following table (where applicable) for water. STATE в Pressure, MPa Temperature, °C 114...

A: Given:mass, m=1.5 kgTemperature, T=114.2o CEntropy, S=2.1936 kJ/K

Q: during the working stroke of an engine the heat transferred out of the system was 160kJ/kg of workin...

A: GivenQ=-160kJ/kg (the heat transferred out of the system)∆U=-405kJ/kg

Q: Determine the total elongation of the bar shown in figure below. Materials E (GPa) Bronze 83 Aluminu...

A: Given data Area of Steel section = As = 300 mm2Area of Aluminum section = Aal = 600 mm2Area of Bronz...

Q: Only ítem C)    a) select the diameter of the cylinder to be used from L=150mm, if it is required ...

A: Given : L = 150 mm = 0.15 m F = 350 kg = 3433.5 N   (multiply by gravity) P = 80 Psi = 551581 Pa To ...

Q: antages and disadvantages of Natural gas sweetening. Dont writing by

A: High quantities of Hydrogen sulfide or carbon dioxide give rise to Natural gas. The presence of thes...

Q: (2 of 2) Air flows through a single-stream, steady-flow device. At thế flow rate is 3.4 kg/s and the...

A:

Q: Velocity field of an incompressible flow is given by V = 6xi − 6yj (m/s) a) Find the pathlines in x-...

A: Introduction:

Q: A closed tank contains 0.5 m of mercury, 1.5 m of water, 2.5 m of oil of specific gravity 0.8 and ai...

A:

Q: The volume flow rate of water that recirculates from the blade outlet to the impeller is estimated t...

A:

Q: A o 25 mm hole is pierced in a t = 2.5 mm thick steel sheet having shear strength t = 350 MPa. If th...

A:

Q: The annual demand for an item is 10,000 units. The unit cost is Rs. 100 and inventory carrying charg...

A:

Q: A force F=15 N is acting on a box at an angle a=20° with respect to the horizontal, as in figure 1. ...

A: Given Data : Mass of jupiter (M)=1.9×1027 kg Distance between sun-jupiter(R)=778547200km=778547200×1...

Q: 4) The water tanks are connected to each other through a mercury manometer with inclined tubes as sh...

A:

Q: One of the beneficial applications of an automotive control system is the active control of the susp...

A:

Q: Linear Approximation, Sensitivity, Strain Consider a one-dimensional scalar fleld f(x) = A (2x -) de...

A: according to the given details

Q: Q2/ Determine the magnitude and direction of a force (P), if the horizontal and vertical components ...

A:

Q: Thickness (in) / (mm) Visible Trans. Visible Refl. Out Visible Refl. In UV Trans. (%) Solar Trans. S...

A: In addition to colourless sheet, the various grades can be ordered in a variety of colours, includin...

Q: At a temperature of 20 °C there is a gap ∆ = 0.2 mm between the lower end of the brass bar and the s...

A:

Q: A Compressor, Shown in Figure. Find the acting force and it's divection if Sair=o.075 lb/Ft?, inlet ...

A: given; density of air (γ)=0.075lb/ft3inlet area(A1)=4ft2velocity(V1)=12ft/sdisvharge area(A2)=3ft2di...

Q: fety valve spring having 9 and 2 coils has the ends squared and ground. The out eter of the coil is ...

A: