Determine values of k and e such that the steady-state amplitude of the center of the cylinder in Figure P6.66 is less than 4 mm for 60 rad/s < w< 110 rad/s? 6.66 200 sinor Massless 5 x 10' N/m pulley 20 cm 40 cm Skg

Determine values of k and e such that the steady-state amplitude of the center of the cylinder in Figure P6.66 is less than 4 mm for 60 rad/s < w< 110 rad/s? 6.66 200 sinor Massless 5 x 10' N/m pulley 20 cm 40 cm Skg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Question (1). B. The following system is oscillating under the action of a moment M = 20 sin(3r), R…

A: According to the given information we have d2 which I distance of mass m from the point O…

Q: General Solution for small oscillations of a simple pendulum with length 5.0 m and mass of 2.0 kg…

Q: A mass, m of 22kg consider one vertical motion only with angular displacement, 0 = wt, with spring…

Q: (3) For the system shown in fig.2, if s 0.15 find (a) EOM w.r.t 0. (b) natural frequency of the…

A: For solution refer below images.

Q: ounted on a vertical wall to support a 64.4 lb mass. At t=0 and an initial velocity of 9 in/sec. to…

A: GIVEN:K=54lb/inm=64.4lbv=9in/sec

Q: Two mass placed on top of each other have a mass of 20 g each and there is a coefficient of static…

A: At the position of amplitude the restoring spring force will be F=kAand therefore the acceleration…

Q: 6.12. Determine the equations of the forced response of the two degree of freedom system shown in…

A: Derived the equation of the forced response of the two degree of freedom system.

Q: Nhich of the following can be the range of values for the damped angular frequency of an underdamped…

Q: A 50-kg turbine is mounted on four parallel springs, each of stiffness of 3 x 10° N/m. When the…

A: n = 4 m = 50 kg K = 3 × 105 N/m f = 40 Hz X= 1.8 mm w = 2πf = 2×π×50 = 80π w = 251.327 rad/s…

Q: 12. Find the position of a free vibration with a response of 2(d^2 x/dt^2) + 128x = o when = IS.…

Q: spring-mass system with m = 0.01 Mg and k= 5 kN/m is subjected to a harmonic force of amplitude 0.25…

Q: A uniform slender rod of mass M and length L is pinned at one end and attached to a point mass, m…

A: According to the information we have a uniform slender rod of mass m and length L, pinned end of…

Q: (a) The undamped natural frequency of the system; (b) The damping ratio associated with the system;…

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: Find the position of a free vibration with a response of 4(d^2 x/dt^2) + 25x = 0 when t = 2.5s.…

A: For solution refer below images.

Q: The system shown below is subject to a sinusoidal base excitation with an amplitude of Y = 14.7437…

A: Given data as per question y = 14.7437 cm frequency = 43.0110rad/s M= 633.5136Kg

Q: Q: Determine the steady-state amplitude of the system shown in figure below: y = yo sin wt k k 1 L.…

Q: A spring-mass system with m = 50kg and k = 4000N/m shown in Figure Q3(a). If the mass is released…

A: (i) Free body diagram Equation of motion…

Q: Let O be the counterclockwise angular displacement of the disk in the following system. a) Derive…

A: Given Data: Now draw the free body diagram of given system Here, x2=r2θ x1=r1θ

Q: A spring-mass system with m = 50kg and k = 4000N/m shown in Figure Q3(a). If the mass is released…

A: (i) Free body diagram Equation of motion…

Q: 1.25 Determine the steady-state amplitude of block in the system of Figure 9.9 and Problem 1.15 if…

Q: A 20 kg object is attached to a spring with spring constant 260 kg/s?. It is also attached to a…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A machine, weighing 3000 N, is supported on a resilient foundation. The static deflection ofthe…

A: (a)Consider W as the weight force, k as the stiffness of the foundation, and ds as the deflection.…

Q: Base motion y(t) has a triangular shape as shown in the figure. when given as; (1) Find the…

Q: A 65 kg painted sewing machine has an imbalance value of 0.15 kgm in rotation. The machine operates…

Q: 6.12. Determine the equations of the forced response of the two degree of freedom system shown in…

A: For solution refer below images.

Q: Determine the response of a system with one degree of freedom to an impulse F for the following…

Q: 3.21. What is the amplitude of steady-state oscillation of the 30-kg block of the system of Fig.…

Q: Consider the system of the following figure which is pivoted at point O. F(t) m Assume, a = 0.4645…

A: The equivalent stiffness of the spring system is

Q: The damping ratio of the system below is 0.3. How long will it take for the amplitude of free…

Q: 15. Find the position of a free vibration with a response of 4(d^2 x/dt^2) + 25x = 0 when = 2.5s.…

A: Calculated position of free vibration when t= 2•5 sec

Q: Answer the attached file

A: Suppose the angular velocity at steady state is 350 rad/s. Write the expression for the steady state…

Q: The response of a machine is represented by two harmonic functions both with a frequency of 6 Hz,…

A: Given: A=0.2 inB=1 inf=6Hz

Q: 3.21. What is the amplitude of steady-state oscillation of the 30-kg block of the system of Fig.…

Q: Compute a value of the damping coefficient c such that the steady state response amplitude of the…

A: Given Datam=100kgFo=20Nω=0.3rad/sk=2000N/m

Q: A second-order system is described by the following equation: a x(t) + x(t) + b x(t) = 12 cos (wo…

Q: The equation of motion of a free damped oscillation is given as d2x 5.8- dt2 dx + 9.5 dt + 16.6x=0.…

A: The equation of motion of a free damped oscillation is given as 5.8 d²x dt² dx + 9.5 + 16.6x=0. dt…

Q: suspended by a spring having a modulus of 15 lb-s/in. When displaced and permitted to oscillate…

Q: A mass-spring system oscillates on a frictionless horizontal surface in simple harmonic motion with…

A: Given that the amplitude a=0.2 let the spring constant=k

Q: Calculate the frequency of damped oscillation of the system shown in Figure () for the value m =…

Q: Determine: i. The undamped natural frequency. The damping ratio. The damped natural frequency. ii.…

Q: A mass-spring system oscillates on a fridtionless horizontal surface in simple harmonic motion with…

Q: 2. A damped 2 DOF system with one dashpot between masses 1 and 2 is subjected to a harmonic force…

Q: spring mass damper system with k=4000N/m, m=10kg,and c=40N-s/m Find the steady-state and total…

Q: A damped single degree of freedom mass-spring system is excited at resonance by a harmonic forcing…

A: Given that, Force, F=40 N,Mass of system, m=3 kg,Stiffness coefficient, k=2700 N/m,Damping…

Concept explainers

Strain Gauges

All the components used in civil engineering and mechanical engineering applications undergo deformations due to induced internal stresses under the application of external loads. Under repeated application of loads, there is a high possibility of failure of the components. Hence, periodic monitoring of the components and determination of stresses are very important.

Question

Determine values of k and e such that the steady-state amplitude of the center of
the cylinder in Figure P6.66 is less than 4 mm for 60 rad/s < w < 110 rad/s?
6.66
200 sinor
Massless
5 x 10' N/m
40 cm
pulley
20 cm
40 cm
Skg
FIGURE P6.66

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

spring-mass system with m = 0.01 Mg and k = 5 kN/m is subjected to a harmonic force of amplitude 0.25 kN and frequency ωo. If the maximum amplitude of the forced motion of the mass (particular solution or steady state) is observed to be 100 mm, find the value of ωo
A single-story building frame is subjected to a harmonic ground acceleration as shown in Figure 7. Assume that M =1,099 kg, A=0.32 m/s^2 , ω=1.6 r/s and K=10,060 N/m. Find the maximum amplitude of the steady state motion of the floor in millimetre (mm).
The equation of motion of a certain mass-spring-damper system is 5x'' + cx' +10x = f(t). Suppose that f(t) = Fsin(wt). Define the magnitude ratio as M = X/F. Determine the natural frequency w_n, the peak frequency w_p, and the peak magnitude ratio M_p for damping ratio = 0.1 and the damping ratio = 0.3
Find the velocity of a free vibration with a response of 4(d^2 x/dt^2) + 25x = 0 when t = 2.5s. Initial displacement and velocity 2 in and 1.5 in/s respectively 1.665 in/s-3.376 in/s-4.995 in/s6.932 in/s
A spring, with a 54 lb/in spring constant, is mounted on a vertical wall to support a 64.4 lb mass. At t=0 and an initial velocity of 9 in/sec. to the left, the mass is released from a position 2 inches to the right of the equilibrium position. Determine: a.Amplitude, C b. Period, Ƭ c. Natural frequency
The following mass-and-spring system has stiffness matrix K. For the mks values, find the two natural frequencies of the system and describe its two natural modes of oscillation. m1 m2 k1 k2 k3 x1 x2 K= −k1+k2 k2 k2 −k2+k3 m1=1, m2=5; k1=3, k2=10, k3=15 Let ω1<ω2be the two natural frequencies. ω1= ω2= (Type exact answers, using radicals as needed.)
(a) A mass suspended from a helical spring of stiffness s, is displaced by a distance x from its equilibrium position and allowed to vibrate. Show that the motion is simple harmonic. (b) A vertical helical spring having a stiffness of 1540 N/m is clamped at its upper end and carries a mass of 20 kg attached to the lower end. The mass is displaced vertically through a distance of 120 mm and released. Find : 1. Frequency of oscillation ; 2. Maximum velocity reached ; 3. Maximum acceleration; and 4. Maximum value of the inertia force on the mass. (c) A machine of mass 75 kg is mounted on springs and is fitted with a dashpot to damp out vibrations. There are three springs each of stiffness 10 N/mm and it is found that the amplitude of vibration diminishes from 38.4 mm to 6.4 mm in two complete oscillations. Assuming that the damping force varies as the velocity, determine : 1. the resistance of the dashpot at unit velocity ; 2. the ratio of the frequency of the damped vibration to the…
spring-mass system consists of a mass weighing 100 N and a spring with a stiffness of 2000 N/m. The mass is subjected to a resonance by a harmonic force F(t) = 25 cos ?t N. Find the amplitude of the force motion at the end of a) ¼ cycle, b) 2 ½ cycles, and c) 5 ¾ cycles.
A wooden rectangular block of density p, height h and cross section b x a is depressed in an oil tub of density po and made to vibrate freely in the vertical direction. Neglecting the damping effect , find the natural frequency
A spring, with a 54 lb/in spring constant, is mounted on a vertical wall to support a 64.4 lb mass. At t=0 and an initial velocity of 9 in/sec. to the left, the mass is released from a position 2 inches to the right of the equilibrium position. Determine: a. Angular frequency
For the system shown in figure below, derive the differential equation of motion for small oscillation. If m1=m2=1 kg, k1=k2=1000 N/m, c1=c2=10N·s/m, a=b=0.5 m, and l=1 m ﬁnd the solution after 1 s provided that the initial angular displacement is zero and the initial angular velocity is 5 rad/s. Assume that the rod is massless.