Differentiate between MCB and kit kat fuse

Q: 5) An air conditioner operates at 240 Vrms at a frequency of 60 Hz. It absorbs an average power of 9…

A:

Q: A Fast Fourier Transform (FFT) is a technique that can be used to estimate the frequency spectrum of…

A: According to the question, for the given input sequence xn=1, 9, 0, 0, 1, 3; We need to determine…

Q: 5) For the circuit Figure Q1(b), assume the circuit is in a steady state at t = 0 bef the switch is…

A:

Q: 4.5 nA CHAPTER 7 CAPACITORS AND INDUCTORS 15. For each circuit shown in Fig. 7.46, calculate the…

A: The capacitor behaves as an open circuit in steady-state analysis, which implies that no current…

Q: Use the mesh analysis to find io in the circuit 10 V | + 1 ΚΩ 10 ΚΩ 3 ΚΩ 3 ΚΩ 2 ΚΩ

A:

Q: A DC generator consist of 100 wires connected in series and lying in a radius of 10 cm. The…

A:

Q: Determine the curl for vector M = 4xsecy i - 2y2z j + (ztany)/2 k at point (π/5 , π/9, π/7).

A:

Q: Find the charge on the capacitor in an RLC series circuit when L=0.5H, R=10 ohms, C=0.01F, E(t)=150…

A: Given:  In an RLC series circuit, L=0.5H, R=10 ohms, C=0.01F, E(t)=150 V; q(0)=1 Coulomb, and i(0)=0…

Q: A system consists of o cubic cell. The electric potential applied to this cell drogs to 10V from 30V…

A: The value of the work done (W) can be calculated by multiplying the value of the potential…

Q: Consider the network function, H(s) = 2(s+3) (s+2)(s+4) What is the steady-state response due to a…

A: Given data: Network function, Hs=2s+3s+2s+4 Unit step input, Rs=1s

Q: Two charges are placed as shown in Fig. 17–49 with q1 = 1.2 µC and q2 = -3.3 µC. Find the potential…

A: Given: Two charge, q1=1.2μCq2=-3.3μC

Q: Q6:- For the system in Fig. 5: a) Find Pr. Qr. ST, Vr and the power factor Fp. b) Draw the power…

A: Given:

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The solution is provided in the following section.

Q: (b) Vi A circuit which operates at o = 50 rad/s is shown in Figure Q2(b). (i) (ii) If an input…

A:

Q: A €252 R = 252 R=302 Y, 13 ohms X. = 16 ohms 357 Om

A:

Q: a) V1: c) V3: c) IT: V1 b) V2: d) RT:

A:

Q: A 250 V d.c. shunt motor has a shunt field resistance of 200 S2 ohm and an armature resistance of…

A:

Q: x(t) = δ(t

A:

Q: 2. Find the marked voltage v. 29V ΠΩ ΖΩ ww V = 20Ω 120ΩΣν 40Ω

A: Given circuit:

Q: What is the difference between apparent power and real power?

A: Apparent power is the total power absorbed by the resistive, inductive, and capacitive load. Thus…

Q: (II) Suppose that you have a 9.0-V battery and wish to applya voltage of only 3.5 V. Given an…

A: Given: A 9-V battery is present. Unlimited supply of 1 Ω resistors. Required: A 3.5 Volt output is…

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos (6πt + T ) ans =F(W) = 2+…

A:

Q: Distinguish between serial and parallel processing.

A: Serial Processing: The processor completes one job at a time during serial processing. The other…

Q: No. 1 2 3 4 5 6 7 8 9 10 Mnemonics MOV A, # 0A9h RL A RL A SWAP A CLR C RRC A SWAP A CLR C RRC A…

A: The instruction as defined as MOV A, #0A9H; Move the immediate data 0A9H into accumulator RLA;…

Q: 1. What is the phase sequence of a balanced three- phase circuit in which VAN = 7200 20° V and VCN…

A:

Q: he output signal from a frequency inverter will appear on a scope screen as a: A. pure sine wave of…

A: Frequency inverter : Every inverter has a base frequency of 50 to 60 Hz a control method is used to…

Q: 4. A 1000 KVA transformer has a reactance of 5%. Its reactance at 2000 kVA base is (1) 5% (iii) 20%…

A: Given: Rated kVA = 1000 kVA Base kVA = 200 kVA Reactance of rated kVA = 5 %

Q: 14> a)What is 11kV transformer? b)What is LT line? c)What is HT supply?

A: Given data,   a)What is an 11kV transformer? b)What is the LT line? c)What is HT supply?

Q: 8. In 8-bit microprocessor, how many opcodes are present?

A: The correct option along with the explanation is provided in the following section.

Q: b) Find the secondary voltage of an iron-core transformer if the applied voltage is 20 V, and Np=60…

A: Given, An iron core transformer with Primary voltage, Vp=20 V Primary turns, Np=60 Secondary turns,…

Q: The Maxwell-Boltzmann distnbutlOn function  

A: Solution- Given, fE=e-E-Ef/KTDcE = AE-Ec1/2  a) Carrier distribution taken as f(E) in conduction…

Q: 8. a) RT: 9. a) RT: 12V +12V I R1=50 R3=60 A www R2=20 b) IT: ww REV (R2=120 b) Ammeter reads: R1=40…

A: 8- given:- R1=5 ohm, R2=12 ohm, R3= 6 ohm Voltage = 12V As we seen circuit Diagram All the registers…

Q: day, (1) The total current taken from the supply at a voltage of 230 volts (2) The energy consumed…

A:

Q: explain why Transformers are necessary in all stages of power distribution systems. Three-phase…

A: Given: Transformer

Q: 7.35 Find the solution to the differential equation 2dy (1)/dt+ 3y(t) = x(t) if (a) x(t) = 2te, with…

A: Given data : The differential equation is, 2dytdt+3yt=xt,  if (a). xt=2te-t with initial condition…

Q: Explain regenerative braking in detail as applied to electric motive

A:

Q: : Find y(t) = X(+) *h(t). For the Signals Shown below h(t) X(X) w w. 4

A: If convolution of x(t) and h(t) is y(t) Then convolution of x(t-a) and h(t-b) is y(t-a-b)…

Q: Q2 The circuit in Figure Q2 is an active filter. (a) (b) (c) (d) Derive the expression for the…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: Q2 (a) Explain, using phasor diagrams, what happens to a synchronous motor as its load is varied.

A:

Q: Transmission Lines and Health. Currents in dc transmission lines can be 100 A or higher. Some people…

A: Given data, a). The line with current is 150A And the height is 8.0m, b).  The earth's magnetic…

Q: E₁ H14 R₁ www Answer: R₂ www + Hill E₂ Given that E₁ = 9.5V, E₂ = 2.8V, R1₁ = 9760 and R₂ = 2650,…

A: Given,   E1=9.5 VE2=2.8 VR1=976 ΩR2=265 Ω

Q: Discuss the stability of the system modeled by the following transfer function $+8 H(s) S³+58² +68…

A: Given data, Transfer function Hs=s+8s3+5s2+6s

Q: A three-phase induction motor is running at 4% slip. If the input to the rotor is 1,000 W, then the…

A: Given: A three phase induction motor, Running at slip, s = 4 % = 0.04 Input to the rotor,…

Q: Determine the input impedance of a short circuited 500 coaxial line with ß = 8.5rad/m and (d)λ/8.…

A: Given data: Z0=50 Ω

Q: Vm Find r.m.s 10 III 0 211

A:

Q: For a pulse code modulated system, the uniform quantizer has 256 different levels. Estimate the…

A: The detailed solution along with the explanation is provided in the following section.

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: The solution is provided in the following section.

Q: Determine the total charge on the capacitors. Write down only the number. Use microCoulombs as a…

A: Given,

Q: A 3 HWCR has a supply of 110V / phase. Find out the value of mean voltage for a delay angle of 150°…

A:

Q: (a) Determine IC and VCE for the circuit (a) given below. (b) Change B to 120 (50% increase), and…

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit. The…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.