Direction: Analyze the given problems and provide the following: a. Design the equivalent pneumatic and electrical circuit with complete labels. 1. A stack magazine module is controlled by a double solenoid valve that separates workpieces from a magazine. A double-acting cylinder pushes the lowest workpiece out from the gravity feed magazine if a workpiece is available detected by a through-bean sensor and a pushbutton is pressed. The cylinder will go back to its initial position once the capacitive sensor sensed that a workpiece is out. The position of the ejecting cylinder is sensed electrically using inductive sensors. The advancing and retracting speed is adjustable.

Direction: Analyze the given problems and provide the following: a. Design the equivalent pneumatic and electrical circuit with complete labels. 1. A stack magazine module is controlled by a double solenoid valve that separates workpieces from a magazine. A double-acting cylinder pushes the lowest workpiece out from the gravity feed magazine if a workpiece is available detected by a through-bean sensor and a pushbutton is pressed. The cylinder will go back to its initial position once the capacitive sensor sensed that a workpiece is out. The position of the ejecting cylinder is sensed electrically using inductive sensors. The advancing and retracting speed is adjustable.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter4: Numerical Analysis Of Heat Conduction

Section: Chapter Questions

Problem 4.4P

See similar textbooks

Similar questions

Need step by step solution ASAP
Explain, with suitable THREE examples, how adaptive control can be applied in monitoring the working conditions of a milling machine with incorporation of sensor technology. (Word limit: ~100)
Describe primary engineering controls and give examples.
Make an essay about the importance of instrumentation controls in engineering industry
8. A system that has the ability to start, regulate, and stop a process to get the desired output is called.... a. control systemb. Manual controlc. strain sensorsd. Control chaine. digital signal
Calculate the reliability of the following system: (PLEASE EXPLAIN THE STEPS SO I CAN UNDERSTAND)
(a) The feeder-selector device at one of the workstations of an assembly machine has a feed rate of 56 components/min and provides a throughput of one part in five. The ideal cycle time of the assembly machine is 6 sec. The low-level sensor on the feed track is set at 10 components, and the high-level sensor is set at 25 components. (a) How long will it take for the supply of components to be depleted from the high-level sensor to the low-level sensor once the feeder-selector device is turned off? (b) How long will it take for the components to be resupplied from the low-level sensor to the high-level sensor, on average, after the feeder-selector device is turned on? (c) What are the time proportions that the feeder-selector device is turned on and turned off?
Made to reduce the coefficient of resistance (CD) on an object. Explain 3 of the control mechanisms by drawing a figure.
In an hydraulic control system, the connecting linkage has areliability factor of 0.98. The pressure sensor that actuates thelinkage has a reliability factor of 0.92. The pressure sensor actuatesthe valve that has a reliability factor of 0.90. Assume that all the threeelements namely; the actuator, the linkage and the hydraulic valveare connected in series with independent reliability factors.- What is the reliability of the control system?
Describe the difference between an open- and a closed-loop operation.
In GD&T Coaxiality is that condition where the axes of two or more surfaces of revolution are _____________. There is a misconception that centerlines or the tolerance block control the ____________________ between two cylinders.
Describe the equipment and functions with detailed infromation and provide diagram for the basic equipment system for the figure to support your description.