Discuss in detail with the help of diagram, the load transfer mechanism in skin resistance-end bearing piles. Subject: Geotechnical design

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A:

Q: Compute the ultimate load bearing capacity of the group of piles considering the piles acts Individu…

A:

Q: . What is pile foundation? Discuss the classification of pile based on materials/composition and…

A: Deep footing - If the depth is more, the footing are considered as deep footings. Meyerhoff (1951)…

Q: Check the total settlement of a group of pile as shown in Figure 1. The total allowable settlement…

A:

Q: Define The local availability of each pile type

A: Pile foundation : Pile foundation is defined as a series of columns constructed or inserted into the…

Q: Write a Short note on Statical Analysis (Single Pile Capacity).

A: Static Analytic Method Of Single Pile Capacity

Q: What are the two methods that are used to determine the capacity developed along the length of the…

A: Pile load capacity depends on a number of factors including cross section, pile length and shape…

Q: A concrete pile is 15 m long and has 406 mm diameter circular cross section. The pile is fully…

A:

Q: Explain some conditions which are consider for the structural design of driven piles.

A: The driven pile may be a form of pile that inserted up to the exhausting layer within the soil…

Q: State the different types of piles according to its function and construction?

A: The types of piles are:End bearing piles: These pile have strong ends so as to resists the load and…

Q: concrete, steel, and wood. Considering the properties and limitations of these materials. Give…

A: concrete is one of the most used material in today's world because of its availability. With the…

Q: 3. As shown in the diagram, the RC solid precast square pile will be lifted up by two points, the…

A:

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A: Skin Resistance End bearing piles-In three types of piles the actedload is transfered to the soil…

Q: Describe the categories of the structural loads applied to piles.

A: pile is the long cylindrical member made up with material which having high compressive strength .…

Q: In what situation would the LTP be complemented by a pile cap?

A: A pile cap is a mat-like structure made of cement, sand and small scales. This mixture is placed in…

Q: For the soil profile shown below, calculate the minimum number of precast concrete piles of 300mm…

A: Solution:

Q: What is pile foundation? Discuss the classification of pile based on materials/composition and load…

A:

Q: Compare features of cast in place piles: Constructed by a driven steel shell with concrete…

A: Cast in place piles or cast in situ piles:

Q: Describe representative Pile Load Capacities and Available Lengths.

A: The ultimate bearing capacity of a pile is the maximum load that it can carry without excessive…

Q: An 18 in diameter, 75 ft long ACIP pile is to be constructed in the following soil profile:…

A: Given:- d = 225 ft  FOS = 3 d =18 inch L=75 ft To find:- ASD allowable downward load capacity

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A: Load transfer mechanism in skin resistance -end bearing piles* These yype of piles  are driven in…

Q: The length of friction piles based on O Shear strength of soil O Pile size O applied load O all of…

A: 6. The length of friction piles based on: The loads are transferred from the structure to the soil.

Q: Describe a typical structure and subsurface conditions where a pile supported or pile enhanced mat…

A:

Q: Discuss the following method of load carrying capacity of pile : Dynamic formula

A: Dynamic formulas are as follows. Engineering News Formula Hiley's Formula

Q: Describe the following briefly: (a) Negative Skin friction and its estimation. (b) Dynamic…

A: Negative skin friction or 'down drag' is a phenomenon, in which portion of a soil layer surrounding…

Q: Explain these two questions based on pile foundations in about 8-10 lines. i) How do the soil…

A: A Pile foundation is a deep foundation whose height is more than the breadth of the foundation. It…

Q: Compare features of cast in place piles:a)Constructed by a driven steel shell with concrete…

A: Cast in-situ pile:Cast-in-place (Cast-in-situ) piles are those piles that are cast in position…

Q: As driven piles penetrate into a saturated clay soil, why the material in the vicinity of the pile…

A: Once a pile is driven into clay, the soil around the pile develops vertical and horizontal…

Q: The static pile capacity consists of two main component: ( ) and ).

A: Static pile load capacity means the the static load the pile can take without failure.

Q: Based on Meyerhof’s (1956) suggestion, do you think a mechanical or electrical cone penetration…

A: Following is required answer :

Q: Describe the Concept—Osterberg load cell placement and effects on test pile.

A: - In Osterberg test, The Osterberg cell also known as O cell is placed inside the pile during its…

Q: Describe about the Relation between pile capacity and driving.

A: The soil that surrounds a pile is substantially disturbed when pile is driven in normally to lightly…

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A: Skin Resistance End bearing piles - In these types of piles the acted load is transferred to soil…

Q: A building is to be constructed on driven piles. The downward vertical load on each pile based on…

A: Load on each pile- 120k  FOS- 2.5  To determine- Rated hammer energy

Q: Please help me solve The soil profile and soil properties at a site are shown  in the table below.…

A: Given data Number of Piles =12 n a 3 x 4 matrix L = 12m D = 0.45m Pile spacing 1.5m

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A:

Q: Determine the allowable bearing load of the pile shown in figure Q1 using all the possible methods…

A: The soil is cohesive. We will only need cohesive soil parameters.

Q: Compare features of cast in place piles: a) Constructed by a driven steel shell with concrete b)…

A: Cast in-situ pile:Cast-in-place (Cast-in-situ) piles are those piles that are cast in position…

Q: A proposed highway bridge will be supported by 180 piles, each about 18 m long. The design load per…

A: Number of piles required for pile load tests varies from 0.5% to 2% of the total piles of the…

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A:

Q: regarding the group pile shown in figure Q3, the piles having a diameter of 457 mm, located at (4) m…

A: The efficiency of pile group as per Converse-Labarre is given by: Where, m = number of columns of…

Q: egarding the group pile shown in figure Q3, the piles having a diameter of 457 mm, located at (4) m…

A: Given:- d=457mm spacing=s=4m c/c depth =16m soil unit weight = 17.9 kN/m3 angle of internal…

Q: Determine the allowable load capacity of the 0.4 m diameter pile shown in Figure 4. The fill is new…

A:

Q: Discuss in your own words with the help of diagram, the load transfer mechanism in skin…

A:

Q: Q # 1. What is pile foundation? Discuss the classification of pile based on materials/composition…

A: Brief concept- Foundation- It is the underground structure and the lower part of a building that…

Q: Relating to the installation of driven piles, provide a brief explanation of spudding,predrilling,…

A: Spudding: Spuds will penetrate scrap or arduous strata therefore the pile will reach the bearing…

Q: What is pile foundation? Discuss the classification of pile based on materials/composition and load…

A: Pile Foundation - Pile foundation is type of deep foundation which is used to transfer the building…

Q: Describe the  pile model used in wave equation analyses with the diagram.

A: Proper modeling of pile driving is important for both planning and inspection of pile driving…

Q: What is pile foundation? Discuss the classification of pile based on materials/composition and load…

A: Pile foundation - Pile foundation is the deep foundation that is employed to transmit the building…

Q: n to the soil as shown below. Calcu

A: