Does the data set of 155.8, 158.4, 194.9, 164.8, 154.5, 184.3, 114.8 and 157.8 ppm contain outlier(s)? (Given that Qcrit.90 % confidence interval(n = 8) = 0.468) %3D %3D O 114.8 ppm is the outlier O All data should be retained O 194.9 ppm is the outlier O Both 114.8 and 194.9 ppm are outliers O It is difficult to judge

Does the data set of 155.8, 158.4, 194.9, 164.8, 154.5, 184.3, 114.8 and 157.8 ppm contain outlier(s)? (Given that Qcrit.90 % confidence interval(n = 8) = 0.468) %3D %3D O 114.8 ppm is the outlier O All data should be retained O 194.9 ppm is the outlier O Both 114.8 and 194.9 ppm are outliers O It is difficult to judge

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter2: Basic Statistical Analysis With Excel

Section: Chapter Questions

Problem 12P

See similar textbooks

Similar questions

If 5 µM enzyme was used to obtain the data in the summary plot below, V-max = ________________ µM sec-1 and Km = ____________ µM for this enzyme (Enter numeric values to the nearest integer; Do NOT write units.)
NH4+ {aq) + NO2(aq) -> N2(g) +2H2O{l} Data Initial [NH4+] Initial [NO2-] rate 1 0.0100 0.200 5.4 x10-7 2 0.0200 0.200 10.8x10-7 3 0.0400 0.200 21.5x10-7 4 0.200 0.0202 10.8x10-7 5 0.200 0.0404 21.6x10-7 6 0.200 0.0808 43.3x10-7 Find x,y,k
can you answer, please? the experimental data are Reference: https://www.youtube.com/watch?v=OOXRkycKEOc&feature=youtu.be and https://www.youtube.com/watch?v=3wLJLm0QLpg&feature=youtu.be
A chemist obtained the following data for percent lindane in the triplicate analysis of an insecticide preparation: 7.23, 6.95, and 7.53%. Calculate the 90% confidence interval for the mean of the the three data, assuming that (a) the only information about the precision of the method is the precision for the three data. (b) on the basis of long experience with the method, it is believed that s---->σ lindane. (c) If s=0.28 is good estimate of σ, how many replicate measurement should be made in order for the mean for the analysis of sample to be within 0.2% of the true mean 90% of the time.
Chemistry An aquifer contaminated with petroleum is found to have the following component concentrations at a particular site: benzene158 ppm toluene124 ppm ethylbenzene91 ppm xylene45 ppm n-heptadecane161 ppm pristane 84 ppm Provide an estimate for the age of the spill at this site using (a) BTEX ratio and (b) nC17:Pr ratio. Show your calculations and use units throughout. Give proper s.f. for the answer.
You are trying to come up with a drug to inhibit the activity of an enzyme thought to have a role in liver disease. In the laboratory the enzyme was shown to have a Km of 1.0 x 10-6 M and Vmax of 0.1 micromoles/min.mg measured at room temperature. You developed an uncompetitive inhibitor. In the presence of 5.0 x 10-5 M inhibitor, the apparent Vmax was determined to be 0.02 micromoles/min.mg. What is the Ki of the inhibitor?
A titrimetric method for the determination of calcium in limestone was tested with the analysis of a NIST limestone containing 30.15% CaO. The mean of the four analyzes is 30.26% CaO with a standard deviation of 0.085%. From the data accumulated from many analyzes, s→ϭ=0.094% CaO was found.a) Do the data indicate the presence of systematic error at the 95% confidence level?b) When a value for ϭ is unknown, do the data show a systematic error at the 95% confidence level?
Chemistry The levels of an organic pollutant (P) in the groundwater at the perimeter of a plant were a cause for concern. A 10 mL sample of the water was taken and the pollutant was extracted with 95% efficiency using 25 mL of diethyl ether. GC was used to analyse the concentration of P in diethyl ether. A calibration curve was plotted for a series of standards of P which yielded the following results: Peak Area Toluene Conc. (µg/ml) 12,000 2.6 23,700 5.0 35,500 7.7 46,800 9.9 31,250 Sample Determine the concentration of P in ppb in the initial groundwater sample.
Here is a use objective for a chemical analysis to be performed at a drinking water purification plant: “Data and results collected quarterly shall be used to determine whether the concentrations of haloacetates in the treated water demonstrate compliance with the levels set by the Stage 1 Disinfection By-products Rule using Method 552.2” (a specification that sets precision, accuracy, and other requirements). Which one of the following questions best summarizes the meaning of the use objective?(i) Are haloacetate concentrations known within specified precision and accuracy?(ii) Are any haloacetates detectable in the water?(iii) Do any haloacetate concentrations exceed the regulatory limit?
If the enzyme lactase has a Vo of 0.111111111111 mM per minute when [S] = 1.0 mM, and a Vo of 0.20 mM per minute when [S] = 5.0 mM, what is its Km? Calculate Vmax of the above enzyme (lactase). Calculate the slope on a Lineweaver-Burk plot (Km/Kmax) for the above enzyme (lactase).
In quality management, it is very important that you have a good background knowledge in both descriptive and inferential statistics. Since you already took up Biostatistics and Epidemiology during your Second Year, answer BRIEFLY the following questions on basic statistics: 1. Compare and contrast the three most common measures of central tendency mean, median and mode. 2. Differentiate standard deviation from coefficient of variation. 3. What is T-test?
A 0.1475-M solution of Ba(OH)2 was used to titrate the acetic acid (60.05 g/mol) in a dilute aqueous solution. The following results were obtained. (See attached image)(a) Calculate the mean w/v percentage of acetic acid in the sample.(b) Calculate the standard deviation for the results.(c) Calculate the 90% confidence interval for the mean.(d) (d) At the 90% confidence level, could any of the results be discarded?