Draw a block diagram of a phase-locked loop (PLL) and briefly explain its operation.

Q: example open loop system

A: In this question we discuss about open loop system

Q: Name 3 applications for closed-loop system

A:

Q: > Home work 6: Draw the developed winding diagram for the stator of a 4-pole, 3-ph synchronous…

A: The rotor of a synchronous machine revolves at the same rate as the spinning field (synchronous…

Q: B: Which type of dispersion phenomenon gives rise to pulse spreading in single-mode fibers? Explain…

A:

Q: Find the poles of the closed loop system-

A:

Q: A DC series generator is supplying a current of 5A to a series lighting system through a feeder of…

A:

Q: Design a winding diagram given the following specifications. • Simplex Wave Progressive Winding •…

A: We need to design a simplex wave progressive winding for the following configuration: number of…

Q: Triaxial has a single core and two shields like a twin-axial coaxial cable. Select one: True False

A: In this question we need to verify the given statement is correct or incorrect.

Q: The emf generated in each conductor of a six-pole simplex-wave armature winding is 0.48 V. If the…

A: V=480 (volts)

Q: 2 Define the term open circuit (no load) and short circuit of a synchronous generator in general.

A: Open circuit of a synchronous generator : When the load on a synchronous generator is open circuit…

Q: A 4 pole wave wound shunt generator delivers 195A at a terminal voltage of 205V. Ra and Rsh are…

A: It is given that: Vt=205 VIL=195 ARa=0.05 ΩRsh=70 ΩP=4

Q: scuss the importance, advantages and disadvantages of generator.

A: The explanation is as follows.

Q: 1. Can we use the phase angle control as an On-Off control? Prove your answer.

A: Can we use the phase angle control as an On-Off control? Prove your answer.

Q: 7. Explain radial distributor.

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: The single - phase ac voltage controller with inductive load. Plot the waveform of output voltage…

A: According to the question we have to plot waveform according to given conditions.

Q: construct an winding diagram with -4 poles -26 conductors -double layer -simplex wave winding, 2…

A:

Q: E) Compare sawtooth generated PWM versus hysteresis technique. ) Explain the switching stages for a…

A: (a)  It is possible to alter both the voltage and the frequency(controlled)       It is possible to…

Q: If the settling time (2% criterion) and the peak time of a 2nd order system are given, find the…

A:

Q: how many closed-loop poles of the system

A:

Q: The DC shunt generator with the terminal voltage 300 V, armature drop 6 V and the each brush drop 4…

A: Please upload only one question at one time for better explanation

Q: A DC series generator is supplying a current of 10 A to a series lighting system through a feeder of…

A: In this question we need to find a power developed in the armature.

Q: 2000V 3-phase 4-pole wye connected SM runs at 1800 rpm. The excitation is constant and gives an emf…

A: In this question slip ring induction motor is given....We have to find out input power and developed…

Q: For a 4-pole armature winding, the span between phases is equal to 90°. Select one: O True O False

A: The correct answer is FALSE

Q: Determine the closed loop poles for a 2nd order underdamped system knowing its settling time (2%…

A:

Q: 9. For a 4-pole, 2-layer, dc lap-winding with 20 slots and one conductor per layer. What is number…

A:

Q: For a close loop system.

A:

Q: Explain the following terms                                    a)     Operating Time b)     IDMT…

A: As per the guidelines, we are supposed to answer the first three-part of the question at a time so…

Q: what is steady state stability? why ground wire is used on the top of tower ?

A: The duration of a process is described by steady-state and unsteady-state processes. When a variable…

Q: Given the current rating of each winding is increased, can the open-delta configuration work as well…

A: The utility simply needs to install two transformers for open-delta. The capacity of the system may…

Q: Using Nyquist criterion, how many closed loop poles are in the right half plane in the given system…

A:

Q: Q2 / explain the operation of spit phase motor

A:

Q: What is a lagging voltage

A: The explanation is as follows.

Q: Rollover Cable using EIA/TIA-568A and EIA/TIA-568A PIN PIN WIRE LABEL WIRE COLORS WIRE LABEL NO. NO.…

A: Given: To find: The wire label and color?

Q: Assume two DC generator is connected to a load via DC bus. Now briefly explain how the power…

A: For the parallel operation of DC generator, The most stable DC generator is, Shunt DC generator is…

Q: a) Compare sawtooth generated PWM versus hysteresis technique. b) Explain the switching stages for a…

A: Pulse width modulation techniques are used to improve the steady and dynamic performance of the…

Q: A TRIAC phase control circuit has a load resistance of 60 and is powered by an AC source of 188…

A:

Q: Explain the installation procedures of a flexible coupling

A: Flexible coupling is used to transfer torque from one shaft to another that is not fully aligned.…

Q: TUTORIAL PROBLEMS LA4gele shunt gmerstor widh wave-wound armature has 41 alots,, ech having 12…

A: As per guidelines we are supposed to solve only first question if multiple questions are asked by…

Q: 8. Give the procedure for time setting of relays on a ring main feeder syst

A:

Q: ineed conclusion for this topic( improvement of transient stability by using turbine fast valving…

A: Turbine fast valving method : Fast valving is a means of reducing turbine mechanical input power…

Q: A 3-phase star connected, 6 pole synchronous machine has 36 slots. Show the distribution of winding…

A: Given: For a 3-phase star-connected synchronous machine, Number of phases m=3, Number of poles P=6,…

Q: Home work 6: Draw the developed winding diagram for the stator of a 4-pole, 3-ph synchronous…

A:

Q: why is there a phase shift in rc cct?how do we make it exactily 90 degree?

A:

Q: Mention three (3) reasons for arcing at the commutator. 2.

A: Carbon brushes at the commutator are the main cause of arcing or sparking. The reasons for arcing at…

Q: Name the component operating with ac power which best compares to the buck chopper.

A: A buck chopper is dc to dc converter which works as steps up and steps down voltage and current…

Q: I have a "4 poles, 26 conductors, double layer, and simplex wave winding", can you construct a…

A: There are two types of winding they are lap winding and wave winding, a lap winding is similar to…

Q: Why Kirchhoff's voltage rule is not applicable for induced current in a close loop?

A: According to Faraday's law of electromagnetic induction, time-varying magnetic flux linked with a…

Q: How does the alternator end voltage change in resistive, inductive, capacitive loads? Please…

A: Alternators are devices that are used to generate electrical energy, and they are also known as AC…

Q: 4 poles -26 conductors -double layer -simplex wave winding Can you do this in "armature…

A: 4 poles26 conductors-double layer-simplex wave winding

Graph theory

It is that part of network analysis where the configuration is called graph or structure of the network system when all of the elements (e.g., R, L, and C) in a network system are substituted with lines having circles/rings or dots across both endpoints. The study of the solution of the networks and circuits with the help of graphs is known as graph theory. The objective is to know the mathematics behind the network analysis.