In a long term adequacy based reliability Evaluation for a generation system, if reliability index calculated is low What should the company do to improve the reliability index ? O a. Improve the efficiency of turbines in generation system O b. Improve the life of the generators O c improve the installed capacity by adding new generators O d. Increase the shutdown maintenance of the generators

In a long term adequacy based reliability Evaluation for a generation system, if reliability index calculated is low What should the company do to improve the reliability index ? O a. Improve the efficiency of turbines in generation system O b. Improve the life of the generators O c improve the installed capacity by adding new generators O d. Increase the shutdown maintenance of the generators

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.11P

See similar textbooks

Similar questions

The fuel-cost curves for two generators are given as follows: C1(P1)=600+18P1+0.04(P1)2C2(P2)=700+20P2+0.03(P2)2 Assuming the system is lossless, calculate the optimal dispatch values of P1 and P2 for a total load of 1000 MW, the incremental operating cost, and the total operating cost.
Choose which answers are correct Reliability evaluation deals with the disturbances arising in the power generation system? a . Adequacy based Reliability Evaluation b . Recursive Technique c . Security based Reliability Evaluation d . Reserve margin Method
The yearly duration curve of a certain plant may be considered as a straight line from 100 MW to 40 MW. To meet this load, three turbo-generators, two rated at 40 MW each and one at 30 MW are installed. Determine: (a) units generated per annum, (b) plant capacity factor, (c) load factor, (d) plant reserve factor and (e) utilization factor.
A power plant comprises three turbine-generators rated 1000 MW, 800 MW and 500 MW respectively. The regulation constant of each generator is 0.05 pu based on its own rating. Each unit is initially operating at one-half of its own rating, when the system load suddenly increases by 300 MW. Calculate the following:a) Per-unit area frequency response characteristic on a 1000 MW system base.b) Steady-state drop in area frequency [CR4]c) The share of the load increase on each generator.d) Total load on each generator after the increase in system load.Assume the reference power setting of each turbine is unchanged.
A synchronous generator is connected to an infinite bus by a transmission line as shown in the figure. The field current IF = 900A when the unloaded generator is synchronized to the infinite bus. a.) P_M is increased to 0.5pu while I_F is held constant at 900A. Find the complex power S_Inf supplied to the infinite bus in per unit. b.) Determine S_Inf in per unit if IF increases to 1600A and PM is held fixed at 0.5pu.
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). 10 points
A power plant comprises three turbine-generators rated 1000 MW, 800 MW and 600 MW respectively. The regulation constant of each generator is 0.05 pu based on its own rating. Each unit is initially operating at one-half of its own rating, when the system load suddenly increases by 250 MW. Calculate the following:a) Per-unit area frequency response characteristic on a 1000 MW system base [CR9]b) Steady-state drop in area frequency [CR4]c) The share of the load increase on each generator [CR9]d) Total load on each generator after the increase in system load [CR3]Assume the reference power setting of each turbine is unchanged.
1- Static synchronous compensator (STATCOM) for powe factor improvement. 2- What is penalty factor? Derive the expression for the penalty factor in economic load dispatch.
1. List out how does a priority method varies from dynamic programming method in Unit commitment problems. 2. Contribution of load flow studies to erect new power station?
Select generator rating as base value
Three-phase, 60-Hz synchronous generator is connected through a transformer and paralleltransmission lines to an infinite bus. All reactances are given in per-unit on a common systembase. If the infinite bus receives 1.0 per unit real power at 0.95 p.f. lagging, determinea) the internal voltage of the generator andb) the equation for the electrical power delivered by the generator versus its power angle δ.
Choose which answers are correct Which of the following is a way to find the order in which generators are brought to the synchronous bus? a. economic load dispatch b. Lambda iteration C. Equal incremental cost rule d. brut force technique