Draw the power factor triangle showing the different labelled sides. Illustrate a lagging power factor using a sinusoidal waveform. (d) List 2 negative effects of a poor power factor (e) How can a lagging power factor be corrected?

Draw the power factor triangle showing the different labelled sides. Illustrate a lagging power factor using a sinusoidal waveform. (d) List 2 negative effects of a poor power factor (e) How can a lagging power factor be corrected?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Determine the RMS magnitude of Current I.

Q: derive the RMS formula for the following a.) b.)

A: The solution is given below

Q: a) An alternating current varying sinusoidally with a frequency of 50HZ has an RMS value of 20A.…

A: Consider the sinusoidal wave to be a sine wave. The frequncy of theAC current is 50 Hz.Therefore,…

Q: average power to the plant shown in the figure is 2474 kW and th power factor is 0.707 lagging. The…

A: In the question, Plant average power = 2474kW at power factor 0.707 lagging. Generator voltage V=…

Q: Find the RMS line voltage VL at the source of the circuit. As shown the RMS load phase voltage is…

A: Given: A three phase circuit in which Zs=2+j3ΩZph=10-j9ΩVload,rms=100V According to question:…

Q: what is the average power absorbed by the load ZL in watts? Assume source is in rms.

A: The solution can be achieved as follows.

Q: Upload answer sheets Find the following parameters of an ac voltage given by the equation…

A: Form Factor: It is the ratio of the RMS value to the average value. It is also known as root mean…

Q: The average power to the plant shown in the figure is 2474 kW and the power factor is 0.707 lagging.…

Q: 3. A series RC circuit with R=4kQ and C=0.40uF is connected to an AC voltage sour v(t)=100sin200t.…

A: In this question, Find the rms current, phase difference between current and voltage. Power…

Q: Consider the following sinusoids, i¬(t) = -4 sin (377t+25°), and i2(t) = 5 cos (377t-40°) Analyze…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: Q8 The average power to the plant shown in the figure is 2438 kw and the power factor is 0.707…

Q: +espa

Q: For maximum average power transfer in the circuit shown in the figure, set the impedance ZL and ZL…

A: In the circuit, For maximum average power transfer in the circuit shown in the figure, impedance…

Q: Calculate the current drawn from the source with and without the capacitor connected. Determine the…

Q: n phase margin why the phase go down for first time then go up?

A: As electronic amplifiers the phase margin (PM) that is the difference between the phase lag φ (<…

Q: Find the impedance ZL and the value of the maximum average power transferred to ZL for the maximum…

A: 4=Voc1-j1 Voc =4-j4 v

Q: Derive an expression for V(rms)» fundamental and harmonic components of the load voltage as a…

Q: Find the impedance Zl and the value of the maximum average power transferred to Zl for the maximum…

Q: i) The maximum and effective (rms) values of v(wt), vi(wt) and i(wt). ii) Write the waveform…

Q: A load is said to have a leading power factor. Is it capacitive or inductive? Is the reactive power…

A: Since power factor is leading that means current leads the voltage and we have the capcitive load…

Q: A 60 Hz sinusoidal voltage v = 141sinwt is applied to a series RL circuit. The values of the…

Q: For the circuit shown, what is the complex power, S. consumed by the load impedance? (Assume the…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ZL and ZL…

Q: 1. v(t) (volt) +V 10 S →t (sec.) 8s (sinusaid) V=20 (a) Determine the Average value (Vwg) for the…

Q: The rms value of a single-phase ac voltage source is V. The voltage source will power two loads in…

A: a)Z,is associated with Resistor (R1) and inductor(L),both are in series Reactance of L, jxL=j 2πf…

Q: The impedance of zl for the maximum average power transfer in the circuit shown in Figure 3 and ZL…

Q: Find the rms value of the current waveform shown in Figure P5.13.

A: Given data: T=4 The expression for the rms value of the current is given as, Irms=1T∫0Ti2tdt

Q: a. Vrms = 120445°,Z = 35 +30j Determine the Real Power, Reactive Power, Complex Power, Apparent…

A: This question belongs to basic electrical . It is about calculation of different types of power when…

Q: Power Factor (PF) = Cos where o is the angle between Vs and Is Real Power (P) = Vs.Is.CosO where Vs…

Q: From the figure, find the average power (Average power) supplied to the elements. When the current…

Q: A dc voltage equal to Vdc V is applied to a resistor of R Ω. Asinusoidal voltage equal to vs V is…

A: Calculating energy delivered to the resistor due to DC voltage source is VDC = Vmax.…

Q: Find the average power delivered to the circuit and Find the power factor of the circuit, and…

Q: A capacitor is connected to an AC source, the current is a) leading or lagging? b) by many degrees?…

A: In this question we will write about inductor ans capacitor voltage and current relationship and…

Q: 1.7 For each of the following RMS cosine referenced phasors write the corre- sponding signal as a…

A: (a) Expression of voltage is given Frequency is given f= 133 Hz Therefore, time period will be,

Q: When calculating the average power delivered to a load by an AC signal, it is not as straight…

A: In this question we will solve active power related questions.... Active power is given by P = RMS…

Q: An industrial process requires a power of 10 kW with a lagging power factor of 0.6 in a single-phase…

Q: The average power to the plant shown in the figure is 2471 kW and the power factor is unity. The…

Q: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

A: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

Q: A current of 10 A rms flows when a single-phasecircuit is placed across a 220-V rms source.…

A: Write the given values in the question.

Q: Calculate the impedance ZL for the maximum average power transfer in the circuit shown in Figure 3.…

Q: For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ??. and…

Q: Q8 The average power to the plant shown in the figure is 2471 kW and the power factor is 0.707…

A: Given, Plant :- Average power absorbed by the plant is P = 2471 kW at 0.707 pf lagging Generator :-…

Q: For the following numeric values (Shown in the picture attached along with the figure) determine the…

A: NOTE: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: How about the average power on each elements? And is it absorbing or delivering power too?

Q: Q8 The average power to the plant shown in the figure is 2423 kW and the power factor is 0.707…

Q: What is the average power in ghe single phase ac circuit with the purely resistive load? It is…

A: According to the Ohm’s law:

Q: Add the two voltages below together (phasor voltages are RMS). ?ଵ =60 ? ∠ 0° ?ଶ =80 ?∠ 270° a) What…

A: a) The two voltages are V1 = 60 ∠0° V2 = 80 ∠270° The resultant Voltage = V1…

Q: A 60 Hz sinusoidal voltage v = 141sinwt is applied to a series RL circuit. The values of the…

A: This question belongs to electric circuit theory . It is based on the concept of current in series…

Question

100%

Draw the power factor triangle showing the different labelled sides. Illustrate a lagging power
factor using a sinusoidal waveform.
(d) List 2 negative effects of a poor power factor
(e) How can a lagging power factor be corrected?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Define the following: a. R.m.s value of a sinusoidal wave. b. Form factor , Peak factor. c. Power triangle ( with figure)
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
The ripple factor for pure dc is Answer:
An ac voltage represents by a sinusoidal waveform as shown in Figure 6 below. a) Define: i. The period ii. The frequency
In DC choppers the wave forms for input and output voltages are respectively a. both discontinuous b. discontinuous,continuous c. both continuous d. continuous,discontinuous
For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and the volt/cm switch is on 1 V/cm. a) the frequency will be Hz b) the r.m.s value will be In CRO the beam can also be shifted vertically by applving a suitable DC voltage to the
How do I find the phase of this sinc function?
2. For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on at 500µs/cm and volt/cm switch is on 5V/cm. The width of one complete cycle is 4cm and peak to peak height is 5cm. Find (a) the frequency, (b) peak to peak voltage, (c)the amplitude and (d) the rms value
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.