e-phase 50 Hz transmission line is 160 km long. A load with a compl VA, 0.8 lagging power factor at 132 KV line-line voltage is connected ng end of the line. The resistance per/km is 0.16 ohm, the inductanc and the capacitance per km is 0.0082 microFarad. Usinf the mediur del answer the following questions)

e-phase 50 Hz transmission line is 160 km long. A load with a compl VA, 0.8 lagging power factor at 132 KV line-line voltage is connected ng end of the line. The resistance per/km is 0.16 ohm, the inductanc and the capacitance per km is 0.0082 microFarad. Usinf the mediur del answer the following questions)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.14P

See similar textbooks

Similar questions

Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
a)We have a two-wire overhead transmission line, powered by a constant voltage source of 700 V. The values for the inductance of the conductors are 2.348x10-3 H/km and the capacitance values are 6.325x10-9 F/km. Assuming an ideal (no loss) line and its length at 130 km, determine the natural impedance of the line. b) What is the transient phenomenon in a transmission line? As an example of its causes.
S.1) The serial impedance per phase of a three-phase 45 km energy transmission line is 2 + j4 / phase. A load with a power factor of cos2 = 0.8 forward is fed from the end of the line. Since the line voltage at the beginning and end of the line of the energy transmission line is wanted to be kept constant at 115 kV, a) Active and reactive powers drawn from the beginning and end of the line, b) Calculating the power consumed along the energy transmission line and the efficiency of the line. S.2) Line constants of an energy transmission line are given as A = D = 0.8746 + j0, B = 0 + j128.34, C = j0.0018316 S. At the beginning of the line, it is desired to write 1920 MW active power and 600 MVAr reactive power lines under 7650kV line voltage. According to this business, a) Calculate the line end magnitudes (U2, I2 and P2). b) What value does the end voltage take when the load fed from the end of the line is deactivated? S.3) The length of a phased energy transmission line with a…
A 3 –phase 50 HZ transmission line have conductors of sections 90 mm2 and effective diameter of 1cm and are placed at the vertices of an equilateral triangle of side 1metre. The line is 20 km long and delivers a load of 10MW at 33kV and p.f 0.8. Neglect capacitance and assume temperature of 20 oC. Determine the efficiency and the regulation of the line
A bundled 500kv, 60Hz three phase completely transposed overhead line having three ACSR 1113kcmil(556.50mm) conductors per bundle,with 0.5m between conductors in the bundle. The horizontal phase spacings between bundle centers are 10,10,and 20m.Calculate the capacitance -to- neutral in F/m. and the admittance -to-neutral in S/km.
Solve this math : A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line. Note: In the below i have added similer type of math and its ans.In the above math, there is just changes of values and Main Change is ACSR ROOK which is given to then question and in the below question which is solved it was ask ACSR Parakeet. So notice that. Follow This Book for help"POWER SYSTEM ANALYSISAND DESIGN;FIFTH EDITION, SI;J. DUNCAN GLOVER" Now solve the math according to the given way solve the math. "A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 25…
A Z0 = 50 Ω transmission line of length l = 4.25 m (with dielectric material with parameters εr = 4, µr = 1) is attached to a time-harmonic generator (V0rms = 30 V, Rg = 20 Ω f = 75 MHz). The line is terminated with a load ZL = 100 + j50 Ω. Find the complex instantaneous voltages and currents along the line and time-averaged losses in the load and generator. Find instantaneous total voltage and current along the line, and plot the complex voltage and current for the line in the following two cases: a) Assume the line is lossless b) Assume the line has a small loss equivalent to R’ = 1.2 Ω/m.
A 50ohm transmission line powered by a 3GHz source and terminated with a load impedance ZL=25-j60 ohms will be matched with the shorted parallel side. What should be the length, in m, of the parallel lateral line calculated using the Smith diagram ?
Consider an ac network with an ideal transformer (with turns ratio of n:1) shown below where ZL=(1+j0) is the load impedance and Zs=(7−j24). Ideal transformer turns ratio n is chosen so that the average power delivered to the load is maximized. Under this scenario, the average power delivered to the load is given by
A Z0 = 50 Ω transmission line of length l = 4.25 m (with dielectric material with parameters εr= 4, µr = 1) is attached to a time-harmonic generator (V0rms = 30 V, Rg = 20 Ωf = 75 MHz). The line is terminated with a load ZL = 100 + j50 Ω.Write Matlab (or similar high level language) code to find the complex instantaneous voltagesand currents along the line and time averaged losses in the load and generator. Use this codeto make a movie of the instantaneous total voltage and current along the line, and plot thecomplex voltage and current for the line in the following two cases:a) Assume the line is losslessb) Assume the line has a small loss equivalent to R’ = 1.2 Ω/m please solve part b
A transmission line with 50 ohm characteristic impedance feeds the ZL = 100 ohm load with a compatible 10 V power supply. For the case where the line is 2.3lambda long and has an attenuation constant a = 0.5 db / lambda, calculate the forces transferred by the source, lost on the line and transferred to the load.
A three phase overhead transmission line has its conductors arranged at the corners of an equilateral triangle of of 2 meters side. calculate the capacitance of each line conductor per kilo meter. given that diameter of each conductor is 1.25 cm. Derive the expression for the capacitance of the transmission line