e. With reference to Figure 3 (b), use source transformations to determine the voltage Va R30 E- -9V 20 120& E₂ -20 V Figure 3(b)

Q: Let D = 6xy ax + 2(xz + 3z2) ay + 3yz az C/m2. Evaluate the surface integrals to find the total…

A: Given D = 6xy ax + 2(xz + 3z2) ay + 3yz az C/m2  rectangular parallelepiped 0 < x < 2, 0 <…

Q: Consequently, power supply and heat dissipation are two other constraints that must be taken into…

A: Electrical Devices and circuit- As we all know that every electrical circuit or device operates on…

Q: It's hard to read, I need a clearly handwrite version

A:

Q: 4 кл 2 кл M 12V Ө IX. 1 ко ч ка 2 ksz

A: Given data A 12 V voltage source is applied in the circuit. Current ix is flowing in the 2 kΩ…

Q: A distributor cable in the form of a ring main ABCDEA, supplies loads of 20, 60, 30, and 40 A taken…

A: The diagrammatic representation is drawn from the given data. This question is based on distribution…

Q: Q2/1 f(t) = u(t) e Find f^-1 Cos (ut) EI

A: In this question we need to find a Fourier transform of the given signal.

Q: In the figure, & = 90.9 V, R₁ = 10.102, R₂ = 21.90, R3 = 32.8 2, and L = 2.84 H. Immediately after…

A:

Q: V10- U20- R₁ ww R₂ R3 ww + U₁ Figure 1: Circuit for Laboratory Experiment 4 1. Derive the expression…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: find the power factor Find the power factor 492 ww 27 V -j252 j5Q2 -j2n Ans pf 0.555 (leading)

A:

Q: 5. Findi, (t). 10 cus(1000) V 4 sin(2000t) A 10μF 30mH %1 www 10092 8092 309 +18V

A:

Q: What is a typical voltage used for capillary zone electrophoresis? a. 2.5 MV b. 250 kV c. 250 MV d.…

A: capillary zone electrophoresis

Q: Y(S) = 1 1.551x10-5s+1

A:

Q: Question 4 Calculate the work done in moving 2 C charge from B(1,0,0) to A(0.3.0) along a straight…

A: given  Q=2C B(1,0,0)  A(0,3,0) E=5 ax -8x ay V/m

Q: Control Systems > Controllers and Compensators Question A phase lead compensating network ha its…

A: Given- A phase lead compensating network, Transfer function- Gcs=101+0.04s1+0.01s, To Find- The…

Q: Using Superposition Theorem Find current l1 answer should be around: -1.32A

A: The given circuit is as shown below,

Q: 2. Simplify the following expressions: cost (a) +) 5 (t) (b) 2t² +1 jw-3 w²+9 *5(w) (Hint: * means…

A: Given expression- a cost2t2+1 δtb jω-3ω2+9*δω   To find- Simplified expression

Q: buses are conductive pathways in a microprocessor's circuitry. Therefore, current may flow among the…

A: Bus is a high speed internal connection and used to send control signals, data between other…

Q: With a block-diagram, write about “TIE-LINE BIAS CONTROL

A: It is asked to write about Tie-line bias control with a block-diagram.

Q: 5. For the circuit below, calculate the current in the 10-ohm resistance. Use Thevenin's Theorem…

A: We need to find out the current for given circuit by using of thevenin equivalent circuit .

Q: -3 The P region of an abrupt junction diode has a resistivity of 0.1 ohm-cm and the N region has a…

A:

Q: 1. There are 4 permutations: natural response and step response for both parallel and for series RLC…

A: Given data A parallel and series RLC circuit is given in the question. Where R, L and C are…

Q: Design the FSK modulator shown in Fig. 16.54(a) to produce frequencies of 1270 Hz and 1570 Hz corre-…

A: Given Required frequencies are f0 mark =1270 Hz f0 space =1570 Hz   Here we need to determine…

Q: Consider the discrete-time system shown in Figure Q1 (b). Determine if the system is (i) time…

A: We need to check whether the given system is time invariant and linear.

Q: 1. Determine the z-transform and ROC for the time signals, (a) and (b). Sketch the ROC, poles, and…

A:

Q: 9.39 For the circuit shown in Fig. 9.46, find Zeq and use that to find current I. Let @ = 10 rad/s.…

A: The total impedance can be calculated by using the reduction techniques and the current can be…

Q: How do I find the Fourier Series coefficients of (1 + cos(2pi*t))(cos(10*pi*t + pi/3)) using…

A: Given below clear explanation

Q: Q1. a) For the circuit shown in figure 1, determine the following: i) The total resistance ii) The…

A:

Q: Select the correct answer for each of the following statements Book Source: Electricity 3 | 10th…

A: Generator, A generator is a machine that is used for the conversion of mechanical energy into useful…

Q: Find Zea- WW 502 -j52 ㅏ 150 -1001- j5Q Zea 502 ww 22 -152

A:

Q: For the circuit shown in the figure below, calculate the following quantities. (Assume & = 4.50 V…

A:

Q: In the following circuit, the complex power supplied by source V₁ is 2000L-30° VA. If V₁ = 200L10⁰…

A: Given, The circuit diagram, The KVA supplied by the source V1 will be, S1=2000∠-30° VA

Q: f(t)= 2 -t { i++ -77 st 50 °<t <=

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 9. A 1-MHz, 40-V peak carrier is modulated by a 5-kHz intelligence signal so that m = 0.7. This AM…

A: We need to find out the power in different components of modulated signal .

Q: A 10 Ω 552 Find the value of R R 4 A 5.0 V Voltmeter

A: We need to find out the value of unknown resistor for given circuit.

Q: A dynamic system is represented by the following equation: 4X(t) + 8 x(t) + 16 x(t) = sin(5t) The…

A: We need to find out the natural frequency for given system .

Q: Using Norton Theorem Find Rn, In and current I1

A:

Q: A 35.1 MHz plane wave with an electric field amplitude of 128.4 V/m propagating in air is incident…

A:

Q: The figure shows a cable through which a current I flows, which is composed of a straight segment of…

A:

Q: A dynamic system is represented by the following equation: 4X(t) + 8 x(t) + 16 x(t) = sin(51) The…

A: 2nd order Differential equation is given  We need to find natural frequency by applying Laplace…

Q: Temperature dependence of resistivity

A:

Q: this version is hard to read， I need a handwrite version

A:

Q: Given the system, obtain the overall system function and the difference equation.

A: Given

Q: An open tank is filled with water and reads 13 psi at the bottom of the tank. How many feet of water…

A: given that it reads 13 psi at bottom of the tank

Q: 4. Findi(t) and vo(t). 10cas(10*t) V + 10Ω ΑΜ ἰ 109 30μF ++ + 10mH Lell Big ΜΕ 10Ω

A:

Q: It's hard to read，  I need handwrite solution

A: Given: To find: For all circuits, i) Transfer function, ii) Magnitude response, iii) Phase…

Q: Q3 - For the simple passive filter shown, find the system equation. Hence, given R = 1, L = 3, and C…

A: We need to analyse the given second order system .

Q: Question-7d, An 8-pole, 50 Hz, three-phase, slip-ring induction motor has an effective rotor…

A: Given- 8-pole, 50 Hz, three-phase, slip-ring induction motor, Effective rotor resistance = 0.08 Ω…

Q: I need answer for part d

A: given

Q: 3. A 230 V series motor is taking 50 A. Resistance of armature and series field windings is 0.2 £2…

A:

Q: For the given circuit, find vo(t) when (0) = 6 A and v(t) = 0 V. 252 i(t) 0.4 H m 3Ω The voltage…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.