Answered: Electric Circuit Analysis 2020/2021 Dr.…

Electric Circuit Analysis 2020/2021 Dr. Yaseen H. Tahir Example: Convert the following quantities into rectangular form. a) 12/30° b) 270/1.7n c) 40 /105°

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: An audio power amplifier delivers a 30 volt RMS 1 kHz sine to a loudspeaker. If the loudspeaker…

A: Given data, RMS voltage Vr=20 V Impedance is given Z=7∠450

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: FN.Q3 – In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R = 470 , C = 220µF and L = 65 mH. Determine…

A: RLC series circuit, If the voltage Vs is given, Find the RMS value of the source voltage power…

Q: For the signals provided below a. Which are periodic? Give their periods. b. Which are power…

A: The signal is said to be periodic if it repeats the output after some equal time interval. The power…

Q: The Upward wind and down wind velocity of a wind turbine are 12m/s and 5m/s respectively. What is…

A: Given: Downward wind velocity, Sd=5 m/s Upward wind velocity, Su=12 m/s

Q: 1: Theory 1.1 Describe briefly a sinusoidal signal and ALL its properties. Give example with…

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The…

A: In this question, An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac…

Q: For the circuit shown below, the average power delivered to the -j5 ohms capacitor is.VAR 10 Ω -j5 Q…

A: Given

Q: 1. How much value of capacitance should you place to correct the power factor of a load consisting…

Q: An emf is represented by the phasor (342 +j380) volts. Extract the cube root of this quantity,…

A: The solution is given below

Q: When the average real power absorbed by an impedance is zero, then the impedance is: Select one: O…

A: The real power is absorbed by the resistor only when there is a combination of inductor and…

Q: An ac motor with impedance Z, (4.0 A40) O is supplied by an RMS value of 220-V, 60-Hz source. You…

A: According to question: The real power taken by the load is calculated as

Q: QI/ Choose the letter of right choice only for the following: 1. Average value of a sinusoidal…

A: In this question, We need to choose the correct options We know V= IZ as per our company guidelines…

Q: 14. In the AC circuit shown, the potential difference across the capacitor and the resistor, V3D, is…

A: The solution is given below

Q: V1 C1 220 Vrms 10uF 60 Hz 0° Computed Values Compute the expected power factor of the circuit given…

Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an AC power supply…

Q: (+2 100 90 80 70 R1 Mwmn 50 Q 10mH V1 220 Vrms 60 Hz 0° Capacitance Real Power (UF) (Watts) 60…

A: The given circuit is shown below. A table is shown below. Write an essay on average power and…

Q: Discuss the following term in reactive circuit? a) Real power b) Apparent power G) Power factor 1.

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: Define Five of the following Heliostats, Primary energy, capacity factor, commercial energ;…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: A voltage v = 120 sin 377t V is applied across a pure capacitance of 100μF, Determine average…

A: In this question, we need to determine the average power supplied by the source from t=0 to t=0.01…

Q: 3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V…

A: The given waveform is shown below:

Q: Sketch the following for the device which is used in high frequency and low power applications. (i)…

Q: Q2. A 50 Q carbon resistor has two lead wires with inductance of 10 nH each. If the stray…

A: Impedance of inductor given byXL= jwL Impedance bof capacitor given by Xc= -j/wC

Q: pure capacitor

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: A superheterodyne receiver is to tune the range 88.IMHZ to 107.1MH2. The RF circuit inductance is…

Q: An AC circuits with 50 Hz voltage of 240V effective value is impressed on an inductance of…

A: Given: An AC circuits with Voltage, Vrms=240 V Frequency, f=50 Hz Inductance, L=sin2+2/5 H=0.717 H…

Q: An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms.…

A: According to the question we have to calculate the inductance of the cable per foot.

Q: Circuit Diagram V1 C1 220 Vrms 10uF 60 Hz 0° Computed Values Compute the expected power factor of…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: calculate the energy spect kat density at The following sisterten XCX) = [. else where Then…

Q: ure inductance of L = 144 mH 118 V, 50 Hz supply. The cure ctor is given by

Q: Q.4. Find the rms value of lo and VAB =? in the circuit shown below.

Q: For the circuit shown, what is the complex power, S, average power, P,av, and reactive power, Q,…

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance. C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: For the circuit shown, what is the average power, Pay, delivered by the voltage source? (Assume the…

Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…

A: To solve above problem, one should have a basic idea about the working of AC circuits. The above…

Q: 2. At the EPC company that you are currently employed, the Engineering Manager has purchased a new…

Q: (c) In an electric power system, it is given that the effective impedance of the generator station…

A: It is Given that:RS=200Ω Rl=300ΩL=250 KmVS=45 kV f=60Hz Pmax=VS2Zth

Q: as i (t ) = 125cos (5000π t −135) mA Determine the period, T, and the time, t1, at which the first

Q: 2 100 Capacitance Real Power (UF) (Watts) 90 80 m 50 Q 70 60 V1 220 Vrms 60 Hz 0° Computed Values…

A: RLC circuit:- A circuit that consists resistor (R), inductor (L), and capacitor (C) is called an RLC…

Q: Q9. Which of the following is one means by which energy or electrical noise can couple from one…

A: Coupling capacitors are used in electronic circuits to pass the desired AC signal and block unwanted…

Q: a) A single-phase AC waveform is represented by the equation; v(t) = 400 sin(3142t + 0.25) V…

Q: Compute the expected power factor of the circuit given the different capacitance.

Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…

Q: Attempt five questions only Q1.) a) Derive the basic S.I units, then write the basic dimensions for…

A: Hii there!! Since there are two different questions in the image, I will be solving the first one.…

Q: Consider a 760 W light bulb that requires an RMS voltage 21 V to operate normally. How large should…

Q: 1. Fill in the table by converting the values into the equivalent forms. Unless otherwise specified,…

Question

Electric Circuit Analysis 2020/2021
Dr. Yaseen H. Tahir
Example:
Convert the following quantities into rectangular form.
a) 12/30°
b) 270 /1.7a
c) 40 /105°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

assume that the voltage drop across the resistor, ER, is 78v, that the voltage drop across the inductor, EL is 104v and the circuit has a toatl impedance Z of 20 ohmas. the frequency of the ac voltage is 60HZ,
Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic impedance of 50 ohms; capacitance is 40 pF/m and an inductance equal to 50 microH/m.
Explore the concept of phasor measurement units (PMUs) and their role in real-time monitoring and control of power systems, emphasizing their contributions to the smart grid infrastructure.
The current in a pure capacitor circuit is i=0.17cos500t. If the rms value of the impressed emf is 80 volts. a) What are the equation for the voltage and power? b) What is the circuit frequency?
1. Discuss the influence of the bypass, coupling, internal, and stray capacitances on the frequency response.
Explain in detail (no mathematical expressions) the following termsused in microwave theory: Characteristics impedance, Dominantmode, Impedance matching, Characteristics admittance
Use the external excitation method for part a.
A ground-mounted photovoltaic module array for a commercial building may be constructed so that it can be used as? A. a storage area B. a covered walkway C. covered vehicle parking D. a break area for building occupants
The feeder is to be used with an antenna for which an inductive reactance is measured as j60 Ohms at 1.7 MHz. The resistive part of the antenna’s impedance is measured as 80 Ohms. Using the online impedance matching calculator, design a suitable impedance-matching network for each of the two cables if the coaxial cable has a characteristic impedance of 75 Ohms and the twin lead cable has a characteristic impedance of 300 Ohms, so that the inductance is in the longitudinal branch, while the capacitor is in the transversal branch of the impedance matching network. Do not round the resulting values.
Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac electric circuit problem solution or analysis
A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance of the cable is ?
Determine the quality factor for Maxwell's inductance capacitance bridge given below, when the bridge is supplied by a frequency of 50 Hz.