The resistance of a conductor 1 mm2 in cross-section and 20 m long is 0.346 Q. Determine the specific resistance of the conducting material. X 10^(8) ОНМ МЕТER NOTE: ROUND OFF TO THE NEAREST HUNDRETHS

The resistance of a conductor 1 mm2 in cross-section and 20 m long is 0.346 Q. Determine the specific resistance of the conducting material. X 10^(8) ОНМ МЕТER NOTE: ROUND OFF TO THE NEAREST HUNDRETHS

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.4P: One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for...

See similar textbooks

Related questions

Q: 14. Find Vo if Vds = 20.24 V 32V 2k Ohm Vo 10 mV VGS(TH) = 5V VGS(ON) = 8V ID(on) = 3 mA yos = 20 us...

A: In this question, We need to calculate the voltage Vo? If Voltage VDS = 20.24V

Q: An electric kettle working at 220 V heats upto 2 liters of water from 20 °C to 100 °C in 2 minutes. ...

Q: 4. A certain common-emitter amplifier has a voltage gain of 100. If the emitter bypass capacitor is ...

A: As per our company guidelines we are supposed to answer only first question kindly repost other ques...

Q: Des:gn the neturk to maintain Lat 12v. for load variation IL from ComA to zoumA) Defermine Rs and Va...

Q: 6. Subtract (78)10 - (45)10 using 8-bit signed 1's complement format and show the result in the deci...

Q: When would you use a pressure transducer coupled to an oscilloscope?

A: Pressure Transducer: Pressure transducer is an instrument which converts an applied pressure into a...

Q: 13. A CE amplifier is driving a 10 kQ load. If Re = 2_2 ill and r; = 10 f!, the voltage gain is appr...

Q: A 30 ft by 40 ft classroom with 8 ft high ceilings will

Q: 3. Apply nodal analysis to solve for Vx in the circuit in Fig.? Vx 20Ω 2 A 10 Ω. 0.2 Vx

Q: Explain the essential features of Indicating Instruments

A: There are three type of essential torques that act in an indicating instruments these are, Deflectin...

Q: 2.A three-phase, three-wire system, with an effective line voltage 100 V, has currents IA Ic = 15.41...

A: This question belongs to electrical power system . It is based on the concept of delta connected bal...

Q: Predict how the operation of this clipper circuit will be affected as a result of the following faul...

Q: KVL 06 What is the total current (1) flowing through the below circ I V2 5ko 1 ko 10 V 15 V 4 kQ V3 ...

A: Given,

Q: Find the complex power and the power factor of the load for the network shown below The voltage at t...

A: In this question we will find complex power of load and power factor of load...

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V

Q: 2 v, ww I5V

Q: What Transistor AC Equivalent model is the most preferred for analysis, based on our text references...

A: AC equivalent model A theoretical circuit that contains all the external characteristics of a given ...

Q: What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's approxima...

A: Given, Three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter.

Q: In the figure is shown a battery having an emf of 12 Volts and an internal resistance of 0.40 Ohm. ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: 1. Sketch the waveform of vo. Indicate the maximum and minimum values. R 10 Vpx E 4 V

Q: 5Ω ww 6Ω ww 20Ω 600 100 40 a 15 0 300 15Ω

Q: Write the differential equations for this circuit then change this circuit so that The voltage at V...

A: The given circuit diagram is shown below, Here,V2=9.0 VRipple = 500mVppf=60HzVp=20Vα=45°

Q: The figure below shows a battery connected to a circuit. The potential difference across the battery...

Q: We are going to sample several signals with different maximum frequencies at 10rad/s. Let's assume t...

A: We need to find out cut off frequency of LPF to reconstruct original signal from sampled signal

Q: Given the following voltages: e1 = -100sin(wt-π/3), e2 = 250cos(wt+ π/6), e3 = 150sin(wt+ π/4), e4 =...

Q: Find the approximate increase by the use of differential, In the volume of the sphere if the redius ...

A: Given,Rinitial=2R'(final)=2.05Change in radius dR=0.05 ∆R=0.05

Q: P 10.8-8 Determine the voltage v(t) for the circuit of Figure P 10.8-8. Hint: Use superposition. Ans...

Q: PiJ A series Circuit. Consistis of three resistors R2=65k, R3= 80 kr. 17 the Yoltage drop ac is lov,...

Q: The value of 8(2t +3)dt is, t² +1 0. (a) 0 (b) -0.15 (с) -0.46 (d) -0.23 8.

A: Limits and boundaries in series- These are the values which enables the execution of the series upto...

Q: 1. Using Y-A or A-Y fransformations, determine the equivalent resistance and total current. 20 за 60...

A: Star-Delta connections- Electrical elements can be connected either in star or delta depending on th...

Q: Quèstion 11 The current gain(a) is greater than the current gain(B). O True False

Q: In the magnetic circuit shown in the figure, the coil has 431 turns and carries a current of 6 A. Th...

Q: Determine the bandwidth of the amplifier Vcc +9 V BDc = Bac= 125 Cpe = 25 pF Che = 10 pF Rc 220 N C3...

Q: design a shift register which performs 1. Parallel load function, when input 00 will be applied in S...

A: It is required to construct a shift register that accomplishes the following functions: (a) When in...

Q: Design Vo Itage Regulator will maintain output vo ltage of 20v acnss IK loadwith on in put that will...

Q: The corner or break frequency of the transfer function H= 100 (1+jw/2) is at rad/s. A 0 в) 0.2 2 (D ...

Q: Find I in the network of I 1 A vit 3 V + 4 A 9 V 9 V 6 V A

Q: For a semiconductor with a constant mobility ratio b=μ n /μ p >1independent of impurity concentra...

A: Resistivity: It is the property of a material measures that how strongly it resist the current. Its ...

Q: Quèstion 11 The current gain(a) is greater than the current gain(B). True False

Q: Draw a full adder using only NAND gates.

Q: 5. Can an MCB provide personal protection from electrocution? Explain.

A: According to the given question, it is required to explain whether an MCB provide personal protectio...

Q: 2. Add 588 + 214 using BCD addition method. 3. What is the Gray code of binary (10110101)2. 4. What ...

Q: 3) Find The transient currentin KLC urui1 C: 0. 125 farad -|c L: 8 henrys E= 300 cos at volts

Q: 5. An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When current of 0.5 ...

A: We need to find out inductance of given coil

Q: An antenna used for transmitting has a power gain of 20, directive gain of 22, and an input power of...

A: Note: As per the guide lines of the bartleby we are supposed to solve 3 questions, when they are ...

Q: Which of the following audio types has the highest bit resolution and sampling rate? A.FM boardcast ...

A: In this question, We need to choose the correct option Which of the following audio types has the h...

Q: What is the peak-to-peak voltage out of a positive clamper whose input is a 10 V peak-to-peak sinuso...

A: The clamper is a circuit that shift the DC line of the signal. If the circuit pushes the signal in t...

Q: Fill in the blanks Ge Si 1.2 kQ -1D Vo- What is the status of Ge Diode? ON or OFF Vo1= V ( Previous

Q: 4.8.2 In the circuit shown in the image below, if V1 = 4.2 V and R1 = 4.9 Q, according to the superp...

Q: 1- Determine the values of Kp and Ka of the closed-loop system shown in Fig. below so that the maxim...

A: In this question, We need to determine the value of Kp and Kd of the closed loop system. If oversh...

Question

The resistance of a conductor 1 mm2 in cross-section and 20 m long is 0.346 Q. Determine the specific
resistance of the conducting material.
X 10^(8) ОНМ МЕТER
NOTE: ROUND OFF TO THE NEAREST HUNDRETHS

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points Aand B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to bemoved from A to B, determine the following:
The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??
The resistance of a conductor 1 mm^2 in cross-section and 20 m long is 0.346 Ω. Determine the specific resistance of the conducting material
Two lengths of conductors are made from, i) a single solid copper wire of radius 5 mm, and, ii) a bundle of 25 solid copper wires each of radius 1 mm. For each conductor, estimate the resistance per unit length at a frequency of 1 MHz. You may assume a conductivity of σ = 6.7 × 107 Ω −1m−1 and that the skin depth, δ, is given by δ = r 2 µ0σω .
The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals. [0·0094 μF/km]
A conductor 0.5 m long is moved at right angle to a uniform field strength of 0.12 Wb/m^2 at a speed of 0.2 meter per second. Find the value of emf induced.
The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to-neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals.
The inner conductor in a coaxial cable has a diameter of 2.5 mm while the outer conductor has an inner diameter of 15 mm. If a dielectric with relative permittivity of 3 separates the two, determine the capacitance of a 5 meter length of this coaxial cable?
Determine the capacitance of: (a) a 1-ft length of 35B/U coaxial cable,which has an inner conductor 0.1045 in. in diameter, a polyethylene dielectric(r = 2.26 from Table C.1), and an outer conductor that has an inner diameter of0.680 in.; (b) a conducting sphere of radius 2.5 mm, covered with a polyethylenelayer 2 mm thick, surrounded by a conducting sphere of radius 4.5 mm; (c) tworectangular conducting plates, 1 cm by 4 cm, with negligible thickness, betweenwhich are three sheets of dielectric, each 1 cm by 4 cm, and 0.1 mm thick, havingdielectric constants of 1.5, 2.5, and 6.
The inner conductor of a long coaxial cable has radius a. The inner radius of the outer conductor is b. Inner conductor V0, outer conductor at 0 potential. Determine the electric potential and electric field strength in the insulating material.
Which of the following is an effective tool to determine directly the conductor surface equation? the electric field at the conductor boundary; (The answer cannot be found on the other choices.) the surface charge density of the conductor; the potential field in the region;
two conducting coaxial cylinders are located at rho =1 cm and rho = 1.5 cm. The inner conductor is maintained at 50 V while the outer one is grounded. If the cylinders are separated by a dielectric material with e = 4eo, find the surface charge density on the inner conductor.