Environmental Engineering The air quality standard for ozone (O3) is 80 ppbv. Express that standard in micrograms per cubic meter at 1 atm pressure and 25oC. At the elevation of Denver, the pressure is 0.82 atm. Express the sulfur dioxide standard at that pressure and a temperature of 15oC.

Environmental Engineering The air quality standard for ozone (O3) is 80 ppbv. Express that standard in micrograms per cubic meter at 1 atm pressure and 25oC. At the elevation of Denver, the pressure is 0.82 atm. Express the sulfur dioxide standard at that pressure and a temperature of 15oC.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 34P

See similar textbooks

Related questions

Q: 17-A refrigerator is to remove heat from the cooled space at a rate of 300 kJ/min to maintain its…

A: Let us estimate the Input power required by the refrigerator.

Q: 7. The emissions from a stack were measured by collecting a sample on a filter. The sampler was…

A: Given- Inlet area=12.5cm2Inlet Velocity=20m/sStack Gas temp =340KPressure=1.018 atmVolumetric flow…

Q: Inside a building, the temperature is 40°C, and the relative humidity is 44 percent. How much water…

A: Temperature= 40°C= 313.15K Relative humidity =44% Volume = 1m3

Q: Why positive corona is used for all indoor air-cleaning applications even though it is less…

A: In an Electrostatic precipitator, an electrical breakdown of electrons happens near the wire when…

Q: Solve,

A: Given: Effluent BOD concentration=80 ppm=80 mg/L Volume of filter, V=825 m3 Discharge, Q=50 L/sec…

Q: A mass of air is at temperature of 30 °C and is having relative humidity of 75 %. Determine the…

A: Given: Temperature, T = 30°C Relative humidity, RH = 75%

Q: 7-7 A monomedia anthracite filter has an effective size of 1.0 mm and media density of 1650 kg/m. a.…

A: Data Given: Effective size of the filter D10= 1 mmMedia density = 1650 kg/m3 Asked: Backwash rate…

Q: Find the dew point temperature for the following air/water vapor mixture for 85°F dry bulb and 50%…

A: Given data- Current temperatue(T)=85oFRelative Humidity(RH)=50% To Find- The dew point temperature.

Q: 12. If an air/water vapour mixture starts at 30% relative humidity, and you add more water vapour to…

A: For questions 12, 13 In both the cases, If we keep temparature and moisture constant by changing…

Q: Suppose the ambient atmospheric temp profile of an area is given by the following equation: ɼ (°C) =…

A: The variation coeffecient is a statistical indicator of the data points' relative dispersion. Mostly…

Q: Turnover time for the humidity in the atmosphere is equal to? A- Evapotranspiration rate/volume of…

A: Given data : - Turnover time for the humidity in the atmosphere is equal to? A- Evapotranspiration…

Q: MAXIMUM AVAILABLE CONCENTRATION (MAC) CO2 FOR AIR OF RESIDENTIAL AND PUBLIC BUILDINGS 1. 0,5 2. 0,1…

A: There are different categories of the buildings in civil engineering. These buildings are having…

Q: Q4)) A reservoir has an average area of 500 km2, its evaporation estimated to be 75% of class A pan…

A: Given data Average area=500 km2Evaporation from reservoir=0.75×calss A pan evaporationNet radiation…

Q: Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a…

A: The given data is shown below: Efficiency=99.4 %Discharge=30,000 m3/minResistivity=7.1×1010 ohm-cm

Q: A water treatment plant is being designed to process 50000m3/day of water. Jar testing indicate that…

A: The given data is: Q= 50000 m3/day =50 MLD Alum dose=40 mg/l The velocity gradient is not given,…

Q: Find the wind speed needed (in miles/hour) to obtain a daily evaporation of 0.163 in/day, if the air…

A: Given Data: Daily Evaporation is EL=0.163 in/day. Air temperature is T=80°F =26.67°C Relative…

Q: State the theoretical principle on which each of the following air pollution control devices…

A: The theoretical principle on which following air pollution control devices operate. 1. absorption…

Q: BOD 6A waste water stream (flow = 2 m³/s,ultimate = 90 mg/l) is joining a small river (flow = 12…

Q: The term for an urban or metropolitan area that is significantly warmer than its surrounding rural…

A: Urban sprawl is an urban development with low-density housing, both residential and commercial,…

Q: Climatic condition data in Mountain Province for the months of July, August and September are…

Q: For a particular location, the average net radiation is 185 W/m2, air temperature is 28.5 deg C,…

Q: If the air temperature on the ground is 25˚C, and the dry adiabatic lapse rate is 10˚C, and the…

Q: 3. Compute the formula weight and density of exhaust gas which contains 72% N2, 1% Ar, 12% H2O, and…

Q: irrent Attempt in Progress Small droplets of carbon tetrachloride at 68 °F are formed with a spray…

A: Given - Diameter of Droplet = 170 um Temprature = 68 °F Find - Difference in pressure btw the…

Q: asap pls 10 mins The volume of atmospheric water is 12669km3. The evapotranspiration from land is…

A: Volume=12669km3 To fund residence time in month

Q: If the air quality standard for CO is given as 9.0 ppmv, express this standard as percent by volume…

A: Solution: We know that, 1 ppmv=1 part of pollutant106 parts of…

Q: 8) Which of the following is often used as the indicator of indoor pollutants? A: CO B: NO C: CO2 D:…

A: this question is from environmental engineering

Q: 1. A single story- home with infiltration rate of o.5 ach has 200 m? of floor space and a total…

A: The given data is as follows: Infiltaration rate=0.5 achFloor space=200 m2Volume=500 m3Emission of…

Q: 1 Which of the following produces pure water day and night? a. Passive solar water still b.…

A: The process of cleaning water is depending on the removal of the dirt, and the pathogenics in the…

Q: Water in a 35-cm dia. has 62°F temperature and the discharge is measured as 0.3 m/s and the pressure…

A: Please refer the attached image for complete solution.THANK YOU.

Q: When a refrigerant vaporizes, it takes heat from its surroundings. The latentheat of vaporization is…

A: Solution: Given: Temperature, T = 5oF Weight of R-124, W1=38.5 poundsW2=1 pounds Latent heat of…

Q: 8. Explain the reason for salinity levels shown in the diagram below. Baltimore Chter Washington…

A: The area near the Norfolk is darkish blue showing most saline area in the figure. The reason for…

Q: What is the pH of a solution made by dissolving 3.71 grams of calcium fluoride in enough water to…

A: Given Data: The mass of the calcium fluoride is M=3.71 g. The volume of resulting solution is V=450…

Q: 10. In a building, to provide ultimate comfort to occupants can be used. А. О АС В. О HVAC C.…

A: In a building , to provide ultimate comfort to occupants can be used

Q: If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what…

A: Given: The mass of the Al rod is 136.51 g. The specific heat of the Al rod is 0.9 J/ g°C. The…

Q: 1. A mass of air is having temperature of 26.9 oC. The Relative humidity of this mass of air is 71…

A: Temperature of air (T)= 26.9 Degree Celsius Relative humidity (Rh) = 71 % Determine : Saturation…

Q: 1. Current mean temperature is 27°C. Current Vapor pressure is 2.337 kPa. (a) What is the dew point…

Q: The Downwash effect at the top of the chimney can occur in cases of high wind speeds. In this…

A: option 2nd is correct

Q: If the air pressure at 18°C is 102.6kPa abs, determine the specific humidity of the air. Air Density…

A: According to given data

Q: Air enters an adiabatic nozzle steadily at 300 kPa, 200°C, and 30 m/s and leaves at 100 kPa and 180…

Q: 2. Consider a "tight" 300 m³ home with o.2 ach infiltration rate. The only source of CO in the home…

A: Considering a tight 300 m3 home with 0.2 ach infiltration rate. The source strength of oven…

Q: Q3: Calculate the steady-state CO2 concentration of a single family home with 3 bedrooms, 3 people,…

A: Cin=Cout+GNKQ

Q: UT's Civil and Environmental Engineering department is considering the purchase of an ice machine.…

A: Given data: Ti=-6 °C=267 KTo=31 °C=304 K Ideal COP=7.22 Actual COP=30% of ideal=0.3×7.22=2.166

Concept explainers

Total Energy Consumption

The term energy consumption signifies the consumption of electricity. Energy consumption as electricity is a primary demand for households, factories, industries, complexes, and commercial places. According to a report, the total U.S. energy consumption for 2018 was 101 BTU (British Thermal Units). It accounted for 17% of the total energy consumption of the world. The total energy demand for the U.S. as oil equivalent was estimated to be about 6804 kg of oil equivalent.

Question

Environmental Engineering

The air quality standard for ozone (O₃) is 80 ppbv.

Express that standard in micrograms per cubic meter at 1 atm pressure and 25^oC.
At the elevation of Denver, the pressure is 0.82 atm. Express the sulfur dioxide standard at that pressure and a temperature of 15^oC.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Trending now

This is a popular solution!

Step by step

Solved in 6 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The 1-hour National Ambient Air Quality Standard for nitrogen dioxide (NO2) is 0.10 ppmv. Calculate the corresponding concentration in mg/m3 at a temperature of 25°C? show all work
The primary air quality standard for NOx expressed as NO2 as an annual average is 100 micrograms/cubic meter. What is the equivalent concentration in ppm at 25 degree Celsius?
Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a resistivity of 7.1(10)10 ohm-cm.
If the air quality standard for CO is given as 9.0 ppmv, express this standard as percent by volume and in mg/m3 at 1 atm and 25 °C
Turnover time for the humidity in the atmosphere is equal to? A- Evapotranspiration rate/volume of atmosphere. B- volume of atmosphere/ Evapotranspiration rate. C- Evaporation rate. D- volume of atmosphere. What is the correct answer??
Calculate the AQI and give a description of air that contains 5 ppm CO (8-hour average), 300 pg/m3 PM-10 {24-hour average), and 0.10 ppm SO2 (24-hour average).
List three characteristics of the atmospheric conditions that affect evaporation of the body
The filter for a room air-conditioning unit has an area of 1,600 sq cm. Howmany square inches are there in the filter?
Consider a 300 m3 home with an infiltration rate of 0.2 ach, temperature of 25oC, and pressure of 1 atm. Assume carbon monoxide (CO) is a conservative pollutant, the only source of CO in the home is the gas range, and the ambient concentration of CO is always zero. Suppose there is no CO in the home at 6 PM, but then the oven and two burners are turned on for one hour. Estimate the CO concentration in the home at 7 PM and again at 10 PM (3 hours after turning off the range). Use Table 7.13 as needed Does this system exceed the 8-hr NAAQS for CO (9 ppm(v))?
Predict the total pressure drop for a wood chip and compost bio-filter that is 1,5 m deep with 50% voids. The biofilter has an area of 500 square meters* and is treating a gas flow of 30,000 m3/hr. Assume the ducting and humidifier cause a pressure drop of 500 Pa prior to the biofilter, Give your answer in Pa and in inches of Н2O.
Problem 5An analysis of the gas in an underground utility vault revealed 30 mg/m3 of hydrogen sulfide, which a workcrew discovered before entering the vault to perform repairs. Due to the permissible exposure limitationof 14 mg/m3, the work team started using a blower to ventilate the vault (cellar). Suppose the vault has a200 m³ capacity and the predicted duration of detention is 15 minutes. determinea) The flow rate of contaminant-free air in (m3/s) to lower the hydrogen sulfide level to a level thatwill allow the work crew to enter the vault?b) How long will it take to lower the hydrogen sulfide level to a level that will allow the work crew toenter?Assume the system behaves as a CSTR and that hydrogen sulfide is nonreactive in the time considered.Note: This is a case of flushing a nonreactive contaminant from a CSTR.
Suppose the ambient atmospheric temp profile of an area is given by the following equation: ɼ (°C) = 30 – 0.005 (z), when z = altitude in m. If the maximum surface temperature is 34°C and average wind speed is 5.7 m/s, estimate the ventilation coefficient and comment on the pollution potential.