Ethyl alcohol flows into a 6 cm ID pipe through a well-rounded entrance. After 20 cm of pipe length, measurements taken in the pipe show that the flow is fully developed. Determine the volume flow rate in the pipe, assuming laminar flow exists.

Ethyl alcohol flows into a 6 cm ID pipe through a well-rounded entrance. After 20 cm of pipe length, measurements taken in the pipe show that the flow is fully developed. Determine the volume flow rate in the pipe, assuming laminar flow exists.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Nitrogen is to be liquefied in a simple Linde process. The feed and recycle are mixed. compressed to 64 bar, and precooled to 135K. The vapor then passes through a heat exchanger for additional cooling before beinng throttled to 1 bar. The unliquefied fraction leaves the seperator at the saturation temperature and passes through the heat exchanger, then exits at 120 K. a. What fraction of the gas is liquefied in the process? b. What is the temperature of the high pressure gas entering the throttle valve?
In a solid - liquid extraction process operated according to the principle of continuous reverse current, the oil of a nutrient will be extracted with pure hexane. A mixture containing 7000 kg of inert solid, 1500 kg of oil and 500 kg of hexane enters the process per hour. The upper stream leaving the total stage contains 65% hexane and 35% oil by weight. A total of 85% of the oil in the inlet current will be recovered. The underflow is constant at N=2.0 kg inert solid/kg solution; a. Find the amount and composition of the output current
Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm below the top of the tube, which is open to atmosphere. The following properties of benzene are given: 1) Boiling temperature is 353K at 1 atm. 2) MW of benzene is 78.108 kg/kmol. 3) hfg is 393 kJ/kg at 353K. 4) Density is 879 kg/m^3 5) Diffusivity rate (D) is 0.88x10^-5 m^2/s at 298K. Determine the following: A) The mass evaporation rate of benzene knowing that Psat is 0.145 atm and Yf at infinity is zero B) How long does it take to evaporate 0.5 cm^3 of benzene
23 ft^3 of air was drawn from a ventilation duct and measured by means of a dry gas meter. the meter's temperature averaged 60 F and the meter gage pressure was -1.9" H2O. Barometric pressure during the sampling was 752 mm Hg. Calculate the volume in standard cubic feet and in standard cubic meter (25C, atm) this is an ideal gas problem
Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator. The evaporator is operated in a vacuum at an evaporation temperature of 80 ° C, and 90% quality steam is supplied at 169.06 kPa. The desired concentration of the final product is 40% total solids. The rate of concentrated product leaving the evaporator is 2000 kg / hour. The specific heat of fruit juice is 4.05 kJ / (kg ° C), and the concentrated product is 3,175 kJ / (kg ° C). Count a. The required steam rate is = Answerkg / hour. b. Steam economy when the condensate temperature is released at 90 ° C. = Answer(kg of water evaporated / kg of steam)
Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator. The evaporator is operated in a vacuum at an evaporation temperature of 80 ° C, and 90% quality steam is supplied at 169.06 kPa. The desired concentration of the final product is 40% total solids. The rate of concentrated product leaving the evaporator is 2000 kg / hour. The specific heat of fruit juice is 4.05 kJ / (kg ° C), and the concentrated product is 3,175 kJ / (kg ° C). a. The required vapor rate is = kg / hour. b. Steam economy when the condensate temperature is released at 90 ° C. = (kg of water evaporated / kg of steam)
A solution containing 100 lbm KNO 3/100 lbm H 2O at 80°C is fed to a cooling crystallizer operated at 25°C. Slurry from the crystallizer (KNO3 crystals suspended in saturated solution) is fed to a filter, where the crystals are separated from the solution. Use the solubility data in Figure 6.5-1 to determine the production rate of crystals (lbm/lbm feed) and the solid-to-liquid mass ratio (lbm crystals/lbm liquid) in the slurry leaving the crystallizer.
A hydrocarbon stream composed of 40 mol% n-butane and 60 mol% n-octane is fed at 100 kmol/h to a flash vessel operating at 5 bar and 145°C. The liquid outlet stream of the flash vessel is then sent to a distillation column with a partial condenser to further separate the components. 90% of the butane in the feed to the column is recovered in the overhead vapor product (distillate), along with small amounts of octane. The bottoms product contains octane which accounts for 75% of the octane in the fresh hydrocarbon feed (to the flash vessel). The condenser and reboiler operating temperatures are 136.7°C and 165.7°C, respectively. Determine the compositions of the liquid outlet stream of the condenser and the vapor outlet stream of the reboiler.
Please I need help. Be as detailed as possible. Thank you! An ideal gas is placed in a cylinder with a movable heavy piston. The gas inside the cylinder has an initial pressure of 1.2 x 105 N/m2 , an initial temperature of 280 K, and an initial volume of 1 x 10-3 m3. A stove underneath the cylinder transfer energy to the gas through heating, causing the volume of the gas to increase to 2 x 10-3 m3. Assume that the gas expands isobarically (at constant pressure). 1) Draw a qualitative energy bar chart showing the changes of the energy within the system.
L-lysine is produced by Corynebacterium glutamicum in a bioreactor using glucose as the carbon source and ammonia as the nitrogen source. All streams of this process are aqueous. In the inflow, 8 grams of glucose per 100 grams of flow fluid flowing at a rate of 500 kg / hour is included. The glucose flow rate in the exit steam is 1 kg / hour. The reaction takes place at 25 °c.What is the mole percentage of glucose that was consumed during cell growth inside the bioreactor? -Does the growth of Corynebacterium glutamicum cells inside this bioreactor release or absorbheat? Should heat be supplied to the bioreactor, or removed from, to maintain the operation temperature? I want the solution of both options.
(II) A 1.0-L volume of air initially at 3.5 atm of (gauge)pressure is allowed to expand isothermally until the pressureis 1.0 atm. It is then compressed at constant pressure to itsinitial volume, and lastly is brought back to its originalpressure by heating at constant volume. Draw the processon a PV diagram, including numbers and labels for the axes
one and half pond of water within piston cylinderassembbly execute carnot cycle. During isothermal expansion water is heated at 500F from saturated liguid to saturated vapour. the vapour then expand adiabatically to TEMp 100F and quality 70.38% sketch cycle on p v cordinate. evaluate heat transfer and work for each evaluate efficency