Answered: Ex.4 A 3500-pF capacitor is connected…

Ex.4 A 3500-pF capacitor is connected in series to a 55 uH coil of resistance R=4 Ohm What is the resonant frequency of this circuit?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 25PQ: A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH...

See similar textbooks

Related questions

Q: The “power cube” transformer for a portable CD player has an output of 4.5 V and 600 mA (both rms)…

Q: An RLC series circuit has a 1.00 k2 resistor, a 156 mH inductor, and a 25.0 nF capacitor. (a) Find…

A: Given : RLC Series Circuit : Resistance, R = 1 KΩ = 1000 Ω Inductance, L = 156 mH = 0.156 H…

Q: A transformer is used to supply a 12-V model trainwith power from a 110-V wall plug. The train…

A: Given:Vp(primary winding voltage)=110 VVs(secondary winding voltage)=12 VPout(output power)=50 WNow,…

Q: An engineer proposes to store 75 kJof energy by flowing 1.5 kA of current through a…

A: Given: The energy to be stored is 75 kJ. The current flowing through the superconducting solenoid is…

Q: A transformer has a primary voltage of Vp= 600 V and primary current of Ip= 2.5 A. If the measured…

Q: An RLC series circuit has a 200 Ω resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is…

A: Resistance, R = 200 Ω Inductance, L = 25 mH frequency, f = 8000 Hz phase angle, A = 45º

Q: A coil of inductance 0.50 H and resistance 100 Ω is connected to a 240 V, 50 Hz ac supply.(a) What…

A: Given: Inductance, L = 0.5 H Resistance, R = 100 ohm RMS voltage, Vrms = 240 V frequency, f = 50…

Q: Consider a series RLC circuit where the resistance R = 753 2, the capacitance C = 4.25 µF, and the…

Q: An RLC series circuit has a 1.00 kΩ resistor, a 150 µH inductor, and a 25.0 nF capacitor. (a) Find…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A series RLC circuit is driven by a generator at a frequency of 2000 Hz and an emf amplitude of 170…

A: Given,

Q: An RLC series circuit has a 22-ohm resistor, an inductor 'L' and a capacitor 'C'. At 220 volts, the…

A: I =V/Z

Q: An RLC series circuit has a 2.50 Ω resistor, a 100 μH inductor, and an 80.0 μF capacitor. (a) Find…

A: Dear student, this question contains more than three sub-parts. We will answer first three…

Q: At 2, 500 Hz, the reactance of a 7.0 mH inductor is equal to the reactance of a particular…

A: Given : Frequency (f) = 2500 Hz Inductance (L) = 7 mH = 7 x 10-3 H

Q: A coil of inductance 0.5H and resistance 100n is connected to a 240V,50HZ ac supply. a) What is the…

A: Given value--- inductance = 0.5 H. resistance = 100 ohm. Voltage = 240 V frequency = 50 Hz. We…

Q: The LC circuit of a radar transmitter oscillates at 17.5 GHz. (a) What inductance is required for…

A: Given data: The frequency of oscillation is f=17.5 GHz. The capacitance is C=1.10 pF.

Q: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF . During the current…

A: An L-C circuit has an inductance of 0.450 H and a capacitance of 0.240 nF . During the current…

Q: A current i(t) = (2A/s)t flows through a conducting coil which results in an emf of 5 = -6V.What is…

A: solution as

Q: The current in an RL circuit increases to 97% of its final value2 10 s after the switch is dosed.…

Q: A transformer has an input voltage amplitude of 200 V and an input power of - W. The primary side…

Q: A transforms has a voltage of 5000 V that comes out of it. If there are 3500 turns of wire on the…

A: Output/Secondary voltage (V') = 5000 volts Number of turns on output/secondary side (N') = 3500…

Q: 5. Consider the circuit below, where the capacitor carries an initial charge Qo. R

Q: A 115@Ω resistor, a 67.6-mH inductor, and a 189@mF capacitorare connected in series to an ac…

A: (a) The current in the RLC circuit is maximum at the resonant frequency. The capacitance of the…

Q: A capacitor C=25μF is charged by a 40 volt battery. When the capacitor is fully charged, it is…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: An RLC series circuit has a 2.12 kQ resistor, a 155 mH inductor, and a 32.9 nF capacitor. (a) What…

Q: A 500 mH inductor is connected across an AC generator that produces a peak voltage of 5.0 V.a. At…

A: Given: The inductance is 500 mH. The peak voltage is 5.0 V. The peak current is 50 mA.

Q: mH A charged 30 uF capacitor inductor. What is the angular frequency of free oscillations of the…

A: The angular frequency refers to the angular displacement of any wave element per unit of time or the…

Q: In the AC circuit shown in Figure P output voltage of the AC source is A 0,250 AV for the first time…

Q: A series RL circuit has a 1 k ohm resistor and a 5 mH inductor. What is the time constant for the…

Q: Use the worked example above to help you solve this problem. An AC generator consists of eight turns…

A: Since you have asked multiple questions we will solve the first question for you. If you want any…

Q: Inductive battery chargers, which allow transfer of electrical power without the need for exposed…

A: This question is based on Electromagnetic induction topic. The emf induced in the coils are in…

Q: Find the waveform for the voltage induced across a 300mH coil if the current through the coil is as…

Q: The values of the phase constant f for four sinusoidally driven series RLC circuits are (1) -15°,…

A: Given: The values of the phase constant for different sinusoidal wave is, (1) -15°, (2) +35°, (3)…

Q: An LC circuit is composed of a 100.0 mH inductor and a 4.0 µF capacitor. If the capacitor can have a…

Q: A transformer has an input voltage amplitude of 200 V and an input power of 40 W. The primary side…

A: The relation between the number of turns in primary(Np), number of turns in secondary(Ns),primary…

Q: A neon sign transformer has a 450 W AC output with an rms voltage of 15 kV when connected to a…

A: Given: The output voltage is V2=15 kV. The power is P=450 W. The number of turns in primary coil is…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Ex.4 A 3500-pF capacitor is connected in series to a 55 uH coil of resistance R=4 Ohm
What is the resonant frequency of this circuit?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An ac source of emf delivers 5.0 mW of power at an rms current of 2.0 mA when it is connected to the primary cod of a transformer. The rms voltage across the secondary coil is 20 V. (a) What are die voltage across the primary coil and the current through the secondary coil? (b) What is the ratio of secondary to primary turns for the transformer?
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.
A step-down transformer has 65 turns in its primary coil and 10 turns in its secondary coil. The primary coil is connected to standard household voltage (Erms= 120.0 V, 60.0 Hz), a. What is the rms voltage in the secondary coil? b. If, instead, the transformer is connected to a 6-V DC battery, what is the rms voltage in the secondary coil after the first few milliseconds?
A 7.0-mH induct is connected across a 60-Hz ac source whose voltage amplitude is 50 V. (a) What is the maximum current through the inductor? (b) What is the phase relationship between the current through and the potential difference across the inductor?
In an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz, respectively, an R = 5O0. L=0.20H, and C=2.0F . (a)What is the impedance of the circuit? (b) What is the amplitude of the current from the source? (C) If the emf of the source Is given by v(tt)=(100V)sin , how does the current vary with time? (d) Repeat the calculations with C changed to 0.20F .
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
(a) What current flows when a 60.0 Hz, 480 V AC source is connected to a 0.250 (F capacitor? (b) What would the current be at 25.0 kHz?
(a) Find me current through a 0.500 H inductor connected to a 60.0 Hz, 430 V AC source. (b) What would the current be at 100 kHz?
A resistor and inductor are connected in series across an ac generator. The emf of the generator is given by v(t)=V0cost , where V0=120V and =120rad/s ; also, R=400 and L = 1.5 H. (a) What Is the impedance of the circuit? (b) What is the amplitude of the current through the resistor? (C) Write an expression for the current through the resistor. (d) Write expressions representing the voltages across the resistor and across the inductor.
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?