Ex.5.10 An elevator starts from rest and rises 40 m to its maximum velocity in Ts with the acceleration recorded as shown. Determine the (a) required time T, (b) max velocity, (c) velocity and position of the elevator at t = T/2.

Ex.5.10 An elevator starts from rest and rises 40 m to its maximum velocity in Ts with the acceleration recorded as shown. Determine the (a) required time T, (b) max velocity, (c) velocity and position of the elevator at t = T/2.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Problem 2.268 A top-slewing crane is lifting an object C at a constant rate of ż = 5.3 ft/s while…

Q: 2/29 A model rocket is launched from rest with a con- stant upward acceleration of 3 m/s2 under the…

Q: You may assume that the acceleration due to gravity on the Moon is gmoon = 1.62 metres per second…

A: Given initial velocity, u = 18 m/s acceleration, a = 1.62 m/s2 at maximum height, final velocity…

Q: 3. An automobile moving at a constant velocity of 45 ft per sec passes a gasoline station. Two…

A: for automobile A, VA = 45 ft/s for automobile B, a = 6 ft/s2

Q: The elevator in an office building, starting from rest at the first floor, is accelerated 0.75…

Q: Q.1: For the figure below, knowing that the angle 0 = 60° and l = 0.6 at points A and B, (a):the…

A: Consider the free body diagram shown below for the body.

Q: A moving car accelerates uniformly from 75 m/s at time t=0 s to 135 m/s at t = 10 s. Define: (i)…

A: Given: u = 75 m/s V = 135 m/s t = 10 s

Q: 5. A train accelerates from rest at station A at rate of 0.8 m/s² for 24 s, then travels at constant…

Q: A jet plane is launched from a catapult on an aircraft carrier. In 2.0 s it reaches a speed of 151…

Q: 2) A car travels along a circular road with aradius of curvature of 75 m, and velocity of 10 m/s.…

A: Given Acceleration at 15 m can be determined as

Q: The 2013 World Record for the 100 m sprint is 9.75 seconds and belongs to an American runner named…

A: Given Data⇒World Record for the 100 m sprint is 9.75 secondsProblem definition⇒Problem says…

Q: Human centrifuges are often used to simulate different acceleration levels for pilots. When…

A: The forces acting on the pilot are gravitational force vertically downward, Mg and the normal…

Q: A brass (nonmagnetic) block A and a steel magnet B are in static equilibrium in a brass tube under…

Q: A car accelerates uniformly from rest and reaches a speed of 28.0 m/s in 8.00 s. If the radius of a…

Q: A bullet is fired with muzzle veloity of 600 m/s. If the length of the barrel is 750 mm. What is the…

A: Given:

Q: (7) A particle of mass 2kg is moving with velocity V= (51+4j-2 k) what is its angular momentum about…

Q: 7. A horizontal force F= 20.0 N is applied on block m₂ = 6.00 kg, as shown. If m, = 1.00 kg and…

Q: A car is traveling from point A, B, C, D and E The car started from Point A with a speed of 5.5 m/s…

A: Given dataAt point A, velocity=vA= 5.5 m/sTime taken for car to reach point B from point A = 60…

Q: At the back of a truck, there is a rolled sheet metal which is initially at rest. This truck moves…

A: Given dataa=4 ms2L=32 mTo find the distance 'x'

Q: An automobile moving at a constant velocity of 45 ft/s passes a gasoline station. Two seconds later,…

A: The distance travelled by the car 1 is s1=45×t The distance travelled by the car 2 is…

Q: Consider an aircraft in a maneuver. At an instant in time, the angular velocity of the aircraft…

A: Solution:

Q: 4. A car accelerates uniformly from rest at point A to a speed of 30 m/s is 5 seconds along a…

Q: Q.1: For the figure below, knowing that the angle 0 = 60° and = 0.6 at points A and B, (a):the value…

A: Friction Friction is the force resisting the relative motion of solid surfaces, fluid layers, and…

Q: A cyclist on a circular track of radius 800 feet is traveling at 27 ft/sec. His speed in tangential…

Q: 2.A train moving with a constant acceleration travels 7 m/sduring the 10th sec of its motion and 5…

Q: 3. An automobile moving at a constant velocity of 45 ft per sec passes a gasoline station. Two…

A: Given:Velocity of 1st car, v1=45 ft/sacceleration of 2nd car, a1=6 ft/s2

Q: Two stations A and B are 10 km apart in a straight track, and a train starts from A and comes to…

A: Given, Total distance between A and B = d = 10 km = 10000 m Total time of journey = t = 15 min = 900…

Q: Q.1: For the figure below, knowing that the angle 0 60° and = 0.6 at points A and B, (a):the value…

A: Solution:

Q: Q) A driver is driving a car in a circular ring which is 120 m in diameter. At one instant, his…

A: Given: The diameter of circular ring, d = 120 m The resultant acceleration, a = 12 m/s^2 The…

Q: 7. A horizontal force F=20.0 N is applied on block m₂ = 6.00 kg, as shown. If m, = 1.00 kg and…

Q: The motion of a train of mass 340M is opposed by a tractive resistance to motion of 190N/Mg. The…

A: given data; ⇒mass of train (m)=350Mg=350*106kg⇒resisting force or opposing force (F)=190N/Mg⇒total…

Q: 2. A car accelerates uniformly from rest at point A to a speed of 30 m/s in 5 seconds along a…

Q: In a pulley system shown, find the tension on the cable and the acceleration of pulley B and the…

A: Solution: To Find: Acceleration of load (al-m/s²) TENSION (N) Acceleration of pulley (aB-m/s²)

Q: The peripheral speed of the tooth of a 10-in.-diameter circular saw blade is 150 ft/s when the power…

A: Given data: The diameter of the circular saw blade, D = 10 in. Initial velocity of blade, u = 150…

Q: An automobile weighing 4000 lb is accelerated at the rate of 3ft/s^2 along a horizontal roadway.…

Q: Starting from rest at home plate, a baseball player runs to first base ( 90 ft away). He uniformly…

Q: Find the acceleration of the system shown( 2 no friction). Use g = 10 m/s

Q: Question: Using a powerful air gun, a steel ball is shot vertically upward with a velocity of 80…

Q: At A, a 907.1848-g slider is pushed upward along a fixed curved bar in a vertical plane. Determine…

A: Write the given data: For proceeding with the calculation following assumptions are taken into…

Q: Human centrifuges are often used to simulate different acceleration levels for pilots and…

A: Given data centrifugal acceleration experienced by human(ac) = 3g = 3*9.81 = 29.43 m/s2 distance…

Q: A 150-m-wide river flows due east at a uniform speed of 2.0 m/s. A boat with a speed of 6.0 m/s…

A: Given data: w=150 mv→WG=2i m/sv→BW=6cos120i+6sin120j=-3i+5.2j Need to determine the magnitude and…

Q: An automobile accelerates uniformly from rest on a straight level road. A second automobile starting…

A: Given data as per question

Q: velocity of slide B is constant, Vb = 25 m / s, find the acceleration of slide

Q: town water tank is draining its water thru a 15cm dia hole on its side at a rate of 18 L/s.…

A: Given:Discharge, Q=18L/sQ=0.018 m3/sDiameter of hole, d=15 cm or 0.15 m

Q: Consider a satellite on a trajectory around Earth. Th welocity of the satellite is 0.1 ê, + 8.1 êg…

Q: Table Q4(b): The upward velocity of rocket at different time t (sec) v (ms') 20+4 40+A 70+A (i)…

A: For solution refer below images.

Q: A bullet is fired through a board 10.0 cm thick in such a way that the bullet's line of motion is…

A: Given Data: The thickness of the board, d=10 cm Initial speed, V1=400 m/s Final speed, V2=300 m/s

Q: A motorcycle starts from rest at t=0 and moves along a circular track with a radius of 400 m. The…

A: Given , tangential acceleration at=2 ms2we know , centrifugal acceleration=v2Rwhere v : tangential…

Q: The passenger in a car observes a telephone pole appearing to move 20.0 m/s to the west, while a…

A: Given VT = 20 m/s VC = 22.4 m/s

Concept explainers

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.

Question

100%

Ex.5.10 An elevator starts from rest and rises 40 m to
its maximum velocity in Ts with the acceleration
recorded as shown. Determine the (a) required time T,
(b) max velocity, (c) velocity and position of the
elevator at t = T/2.
a (m/s)
0.6
T/3
T t(s)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The elevator in an office building, starting from rest at the first floor, is accelerated 0.75 m/sec2 for 5 secs. It continues at constant velocity for 12 secs, more and is then stopped in 3 secs with constant deceleration. If the floors are 3.75 m apart, at what floor did the elevator stop?
consider the slider-crank mechanism shown. Crank AB is 0.300 m long. Rod BD is 0.600 m long. The velocity at point B is 3.00 m/s, ⬅. speed of the piston at D?
1. Using Lagrangian Mechanics, find the acceleration of the double Atwood machine assuming the pulley is massless
Slides A and B, connected to each other by a rope of L = 4 m length, slide on the arms at right angles to each other. If the upward velocity of slide B is constant, Vb = 25 m / s, find the acceleration of slide A.
3kg ball connected to horizontal AB with cable. AB rotates with constant angular velocity w about vertical axis. if angle of cable with vertical is theta= 30 degree, find angular velocity and tension of the cable.
4. A concrete weight of 125 kg is released from standstill and a log of mass 200 kg is moved along an inclined area of 30° to the horizontal.When the concrete weight is moved down 5 m, find that 1. What is the speed of the log? 2. What is the movement time of the concrete drum?
A particle moves in a circle with a diameter of 120 cm. If its linear velocity is given by v = 4.5t where v is in mps and t is in s, find the radial, tangential and the resultant acceleration of the particle.
A nozzle is designed to move a liquid from V1 velocity to V2 in a linear fashion. The linear relationship here is V = ax + b and a and b are constant. As the flow is constant with V1 = 10 m / s at x1 = 0 and V2 = 25 m / s at x2 = 1m; a) local (local) acceleration, b) Convective acceleration (convective acceleration), c) Determine the acceleration of the liquid at the points x1 = 0 and x2 = 1 m.
A tire 0.400 m in radius rotates at a constant rate of 170 rev/min. Find the speed of a small stone lodged in the tread of the tire (on its outer edge). (Hint: In one revolution, the stone travels a distance equal to the circumference of its path, 2?r.)____m/sWhat is the acceleration of the stone?_____m/s2 away from the center of the path? tangent to the path? toward the center of the path?
An airplane starts from rest at t=0. During a curvilinear flight path, airplane’s acceleration in cartesian components is defined by ax= 0.46t + 0.2 m/s2 and ay= 0.6t m/s2. At t = 4 sec, Given the mass of aircraft is 1500 kg, calculate a) Normal and tangential forces
The case where the rocket has alinear air drag force F= cV , where c is a constant. Assumingno burnout, solve for ω ( t ) and find the terminal angularvelocity—that is, the final motion when the angular accelerationis zero. Apply to the case M 0 = 6 kg, R = 3 m, m =0.05 kg/s, V e = 1100 m/s, and c = 0.075 N ? s/m to find theangular velocity after 12 s of burning.
7. If the sports car in problem number 1 is approaching the exit tollgate with a velocity of 100 m/s and decelerates at 5 m/ss to a full stop, find the displacement of the car.