Answered: Example: Find Thévenin's equivalent…

Example: Find Thévenin's equivalent circuit between a &b for the network in Fig. 2.32. Then find the current through R, for values of 2 2, 10 2, and 1002. R1 E, 9V R, 360 RL Fig 2 32

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: (c) A 50 kVA, 2300 V/460 V transformer has a primary winding resistance and reactance of 3.5 2 and 8...

Q: A series RLC circuit is shown in Figure Q4 (b) where R=42, L = 0.5H, C= 0.1F,E(t)=10 V and i(0)= 0. ...

A: For the given circuit, we have to form the differential equation and then convert the equation into ...

Q: 1. S 1-5 KA 30v a. what is , the T CTime constant) ? b. How long will it take for the capacutor TO r...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for y...

Q: Inductance is often described as . (circle all that apply) The ability of a component to oppose a ch...

A: 1) The ability of component to opposes a change in current

Q: Discuss the operation of the control circuit diagram for Wye-Delta Starter No plagiarism. Pure an...

Q: A transformer has a 30 V input and a 10:1 turns ratio. Determine the secondary voltage

A: The transformer turns ratio is used to find the secondary voltage. (V1/V2) = (N1/N2) = (10/1) Here ...

Q: α 2 V 2Ω 2Ω 2 A

Q: Calculate the modulation indexes

Q: 3.8 Using nodal analysis, find v, in the circuit of Fig. 3.57. 6Ω 20 Ω 60 V 4Ω : 20 Ω Figure 3,57 +

Q: What is stability analysis? Explain in detail.

A: Stability analysis: This is done to check the system is stable or not.

Q: A wire of resistivity 2.8 x 10^-8 ohm. m and length 20-m must dissipate electrical energy at a rate ...

A: In this question resistivity of wire and current in wire with wire length is given....We have also g...

Q: A substation is supplying four towns whose peak loads are 10 MW, 5 MW, 8 MW, and 7 MW. The diversity...

Q: Sketch the transfer and drain curve characteristics for an n - channel JFET defined by Ipss = 12 mA ...

Q: 3. The length of a Germanium material is 10 cm and its area is 5 cm2. Check in slide 30 the resistiv...

A: Resistance: In the resistance, the power dissipation occurs in the form of heat. Its unit is Ohm.

Q: Calculate the all-day efficiency of a 100-kVA transformer operating under the following conditions: ...

Q: Determine the values of the node voltages, v1, V2 and v3 in the circuit shown. 15 V 50 Ω 10Ω 20Ω 25 ...

A: In this question, 3 independent voltage source is given. Find the Voltage at the 3 nodes as shown ...

Q: b on 2, and f = 1000 Hz, write ZR, ZL, 5-35. A two-branch circuit consists of the com- ponents show ...

A: Given information: R=50 Ω. L=3 mH=3×10-3 H. C=1.2 μF=1.2×10-6 F. f=1000 Hz. ω=2πf rad/sec. The given...

Q: b. A system is characterised by a signal flow graph shown in figure 1.Use Mason's gain formula to pr...

A: In this question we will find transfer function of given system using Masons gain formula.... Note:-...

Q: Example 5 – For a non-ideal amplifier and the foll parameters, Input signal power = 2x10-10W Input n...

Q: This LR circuit has a transfer function of 1 %3D Ls+R 1/L s+R/L R V(s) The switch closes at time t=0...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: An a.c. generator consists of a coil of 1000 turns and cross-sectional area of 3m2 , rotating at a c...

A: Given: An a.c. generator consists of, Number of turns, N = 1000 turns Cross sectional area, A = 3 m2...

Q: Example 5 – For a non-ideal amplifier and the following parameters, Input signal power = 2x10-10W In...

Q: A В Ci Co

Q: Sketch the transfer and drain curve characteristics for an n – channel JFET defined by IDSS = 12 mA ...

A: JFET (Junction Field Effect Transistor ) This is a three terminal semiconductor device namely the so...

Q: Routh-Hurwitz stability criterion

A: RH criteria is uses characteristic equation or we can say denominator of closed loop system transfer...

Q: A 30 ohms resistor is connected in parallel with a variable resistor R. The parallel combination is ...

A: From the given information, the circuit diagram is given as follows,

Q: Exercise 2.17 Compute va, Vb e ve using superposition theorem. Data: E = 12V, E2 = 10 V, R1 = 12 N, ...

A: This question belongs to circuit theory . It is based on the concept of super position theorem . In ...

Q: can you explain the operation and need for voltage regulators and tap changers

A: The electrical power system is designed in such a way that its voltage and current supplied to the s...

Q: 3. Describe i'n your own words the conditions estable'shed by forwarel and reverse bias cond'ons on ...

Q: (b) Figure Q1(b) shows an AC circuit. Given the voltage, Va across the impedance Za is 111.803 L- 41...

Q: draw the Microwave level sensor and Laser displacement sensor and explain its operation in detail

Q: On a base of 25 MVA , 11 kV the generator has reactances X,=X;=X;=0.2 pu and X = 0.06 pu . It is Y c...

Q: a shunt motor running on no-load takes 5 A at 200 V . The resistance of the field circuit is 150 ohm...

A: Motor: A motor is a rotating machine that converts electrical input into mechanical output.

Q: A point charge Q1 = 300 μC located at (1, -1, -3) m experiences a force F1 = 8 Ix – 8 Iy + 4 Iz N, d...

A: By Columbus law force between the two charges Q1 and Q2 which are separated by distance r is (Q1×Q2...

Q: 9. Determine Ve, and V, for the networks of Fig. 2.159. Si Ge Si 4.7 ka 1.2 ka 2vo -10 Vo GaAs 3.3 k...

Q: (1) a 1.33-H inductor in series with a 3-F capacitor (2) a 1.33-H inductor in parallel with a 3-F ca...

Q: 1)An electric dipole of 100 az pC.m is located at the origin. Find V and E at point (0, 0, 10)

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: i) find the impedance parameters, I1, and I2. ii) if the 15 2 resistor is removed from the network, ...

Q: Q-3) Find the range of gain, K, for the system that will cause the system to be stable, unstable, an...

A: In this question , we will find range of K for system stability by making routh array....

Q: 17. tor the netwoyk i determine the range of v; that will RS=912 maintain V,at 8v and not exceed 个十 ...

A: Solve the problem

Q: (c) For the circuit shown in Figure Q1(c), (i) Write the loop/mesh equations for loop i, loop iz and...

Q: R SW Vo In the circuit diagram above, Vo= 5V, R=1Q, and Switch (SW)= ON. a. Derive the equations and...

A: Solve the problem

Q: Q1/ Reduce the following blóčk diágram Y (s) R(s) G3 H3 H, H

A: Block Diagram- Block diagram is the diagrammatic representation of any system or process in form of ...

Q: Vx 2Ω + ,2vx 2 A ( | 2Ω V

Q: c Given the causal system y(n) – y(n – 1) = x(n) + ¤(n – 1) Find the response to r(n) = u(n). Use co...

Q: Solve the problem using Laplace transform of the following problem

A: To Find:- L{3tcos(2t)}

Q: AND NO NOT AND NOT NOT NOD O AND

Q: blow-dryer and a vacuum cleaner each operate with a voltage of 120 V. The current rating of the blow...

Q: When you are solving for circuit problems from the data obtained from experiments, what is the signi...

A: When you are solving for circuit problems from the data obtained from experiments, what is the signi...

Q: Give an example of an interface module used in a communications system, then explain its basic opera...

A: Interface module- Interface module is a hardware device which is used for the transferring of data b...

Concept explainers

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.

Question

Example: Find Thévenin's equivalent circuit between a &b for the network in Fig. 2.32.
Then find the current through R, for values of 2 2, 10 2, and 1002.
R1
E,
R 360
9V
Fig 2.32

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q2:-For the circuit shown in Fig.(2) , find Q-point . Assume : Ing = ( 1+ Vs )* X 10
9. In the network shown in Fig. 2.177 find the current that would flow if a 2-Ω resistor was connected between points A and B by using.(a) Thevenin’s theorem and (b) Superposition theorem. The two batteries have negligible resistance. [0.82 A]
25. Four resistance each of R ohms and two resistances each of S ohms are connected (as shown in Fig. 2.50) to four terminasl AB and CD. A p.d. of V volts is applied across the terminals AB and a resis- tance of Z ohm is connected across the terminals CD. Find the value of Z in terms of S and R in order that the current at AB may be V/Z. Find also the relationship that must hold between R and S in order that the p.d. at the points EF be V/2. [Z= R(R+2S);S=4R]
9. Using KCL, find the values V,p, 1, 1 and I, in the circuit of Fig. 2.43. All resistances are in ohms. (YAp=12 V ; 1, =2/3 A; L, = 1A; I, = 4/3 AI
a) The power, P, consumed by a resistor of resistance R, is given by P = E^2R Given that E = 20 V and R = 1000ꭥ, using partial derivatives, find the approximate change inpower if E is decreased by 0.5 V and R is increased by 50ꭥ.b) Check and compare your findings using standard electrical principles.
10. Use Superposition principle to find current in the 10-Ω resistor of Fig. 2.125. All resistances are in ohms. [1 A]
Determine v, for each network of Fig. 2.157 for the input shown. 20 V 2V ldeal Ideal I ka 22 k2 -5 V
11. State and explain Superposition theorem. For the circuit of Fig. 2.126. (a) determine currents I1, I2 and I3 when switch S is in position b. (b) using the results of part (a) and the principle of superposition, determine the same currents with switch S in position a.[(a) 15 A, 10 A, 25 A (b) 11 A , 16 A, 27 A]
For the network in Fig 2:(a) Calculate RT. (b) Find IS, I1 and I2. (c) Calculate V3.
23. State and explain Kirchhoff’s current law. Determine the value of RS and RI, in the network of Fig. 2.49 if V2 = V1/2 and the equivalent resistance of the network between the terminals A and B is 100 Ω. [RS = 100/3 Ω. RP = 400/3 Ω]
For the network in Fig. 2 a. Convert the voltage source to a current source. b. Reduce the network to a single current source, and de- termine the voltage V1. c. Using the results of part (b), determine V2. d. Calculate the current I. + V2 - R2 2.2 kn 8 mA V,R6.8 kN 3 mA 18 V FIG. 2
11. State and explain Thevenin’s theorem. For the circuit shown in Fig. 2.179, determine the current through RL when its value is 50 Ω. Find the value of RL for which the power drawn from the source is maximum.