EXPERIMENT 01 10V- 8V- 6V- 4V- 2V- OV- -2V- 4V- 6V- 8V- 10V- 0.00ms EXPERIMENT 01 V(n002) \^^^^^^^^^^^ 30.00ms 60.00ms 90.00ms V SINE(0 10 60 0 0 0 100) .tran 2 Diode 1N914 # 120.00ms V(n001) Resistor 10K 150.00ms 180.00ms OOX

Q: The single line diagram of a power system is shown in Figure Q2.1 including generator and…

A: Given length of line =50 km MVA base = 100 MVA For line , base voltage =11 kV

Q: Question No.55 The 4-bit Gray code for decimal number 5 is:

A: Given- Decimal number = 510 To find- The 4-bit gray code.

Q: Q8 :A 0.25 hp; 110-V; 60 Hz; 4 poles single phase induction motor has the following Circuit…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Question 3 Refer to figure below. E-230 V/0 f=50 Hz Determine the current 7. 15333256* A 3.45256* A…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Tomography is a well-established imaging technique by obtaining cross-sectional images or sectioning…

A: Tomography:  Tomography is well established  imaging technique by obtaining cross-sectional Images…

Q: An industrial load consumes P = 25 kW with a power factor PF = 0.8 lagging. The motor in 2a is…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: For the network with CE in placed, determine Rin in ks (using appropriate approximations). V₁ HH 1₁…

A: We need to find out the input impedance for given circuit , first we will do DC analysis then small…

Q: • A 440V, 3-phase ac motor has a power output of 11.25kW and operates at a power factor of 0.8…

A: Given data: VL=440VP0=11.25kωcosϕ=0.8lagη=0.84

Q: (i) By applying Kirchhoff's laws to loops ADCA and BCDB, deduce an expression for the resistance of…

A: Given circuit,

Q: b) An analog signal given by the equation v(t) = 10 sin(1000nt) + 10sin (2000nt) is sampled as shown…

A: Given: An analog signal, v(t)=10sin(1000πt)+10sin(2000πt), To do: To analyze the analog signal to…

Q: Does the capacitor and resistor values matter in the output amplitude of an envelope detector: what…

A: It is given that:

Q: When Selenite children, who have only 4 fingers (the middle finger, the ring finger, the little…

A: According to the question, for the given finger to binary conditions as shown below When Selenite…

Q: 13) are set to 111. design a synchronous counter count as follows: 1,7,2,4,6,3. The unused states…

A: Counter:-

Q: what is intended audience of novel air borne Anteena ?

A: Airborne antenna systems are designed for use in an array of standard commercial, scientific and…

Q: Consider that you have the following state representation system, Determine the Transfer function by…

A: Given: x1˙x2˙x3˙=-5-30200010x1x2x3+200u, y=016x1x2x3

Q: Question 4 The waveforms of the supply voltage e(t) and current i(t) of a circuit are shown in the…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Determine V3 using Thevenin's equivalent circuit. 60/30° V ( + j10 Ω m -j4Ω 8 Ω V2 j10 Ω m -j4Ω Ι V3…

A:

Q: A circuit in Figure Q.2a compares 2-bit binary numbers, P and Q represented by PiPo and QiQo…

A: We need to find out condition for Z = 1 , we need to design the given circuit by using of decoder .

Q: 2. Assuming an ideal diode, sketch Vin. The input is a sinusoidal waveform. Sketch Vout. (Indicate…

A:

Q: d) 460- -V, 50-Hz, two-pole induction generator connected to grid, has a slip of 4 percent when…

A: Here it is asked to solve subparts (d), (e) and (f). So we are solving only these three subparts.…

Q: Explain deterministic and random signals

A: We have to explain deterministic and random signals

Q: Question 9 Refer to the figure below. sin(314 e(t) 200 sin(3140) Determine the voltage V₁. 00…

A: We need to find out the voltage and capacitance for given circuit .

Q: 16) The characteristic polynomial of a system is given as below a(s)-5² +25² +25² 4² 115-10 How many…

A: We need to find out number of poles lies in  right hand side of s plane .

Q: PHASORS Example 1. Evaluate these complex numbers: (a) (40/50° +20/-30%)¹/2 10/-30° +(3-j4) (2 +…

A:

Q: Question 7 Refer to the figure below. e(t)-200 sin(3140 V 3.032-31 A 4.29231 A 3.03231 A R=400 ww Va…

A:

Q: (22) 4. Code in 2's complement on 8 bits the following signed numbers: (i) 34; (ii) -23; (iii)- -…

A: We need to find out the 2's compliment of given number .

Q: c) Design (Find the values of R₁ and assume C₁=C₂) timer 555 IC as a monostable multivibrator…

A: it is asked to design 555 timer IC as a monostable multivibrator circuit for given output

Q: b) 4(x+12) 14) What is the equivalent open loop transfer function required for drawing root locus…

A:

Q: A piezoeletcric tranducer has a crystal material with a 2 mm thickness and a relative permitivity of…

A:

Q: → Тоја X ₂(t) = x₁(t - To/4) k a) y(t) = D.C = ? b) y(t) ➡ RMS = X, (+)1 Xz() fo=250KH₂ Modulator…

A:

Q: I) A speaker vibrates at a frequency of 80 Hz and produces = pressure amplitude of 10 Pa 1 m from…

A: We need to find out the displacement amplitude and intensity level at given point .

Q: 15.0 V 500 Q Ο 165 mA 0 175 mA C 55 Α ο 1ος ΠΑ 2 ΚΩ

A:

Q: K value

A:

Q: Example 1. Find v(t) and i(t) in the circuit shown in Figure 8.

A: The required parameters can be calculated by converting the capacitor into its equivalent impedance…

Q: Q1. (a) ALL questions. With the aid of suitable diagram, explain the concept of electricity…

A: Synchronous generator is widely used to generate electricity. Synchronous generator consists of…

Q: Example 3. Given the sinusoid, calculate its amplitude, phase, angular frequency, period, and…

A: Introduction Amplitude: The waveform's maximum separation from its vertical location and horizontal…

Q: Act) dt Lito.5 cos Bt+ 0.5 cos 20€] Find the derivative with respect to t, and set the resulting…

A:

Q: A 440V, 4-pole, lap-wound DC series motor has 510 conductors in its armature. It has a combined…

A: Given data, Number of conductors Z = 510. Number of poles P = 4. Armature resistance Ra=0.5 Ω…

Q: 1. An AC voltmeter indicates a reading of 50V across the load of a full-wave rectifier. What will be…

A: We need to find out the reading od DC voltmeter for given ac reading.

Q: Determine the Boolean function and truth table of the given logic diagram. ( A- B C D - F₁ F₂

A:

Q: Simulate in tinkercad. Create a program that controls the direction of rotation of a DC motor. Use a…

A: Given  Create a program that controls the direction of rotation of a DC motor.

Q: If current source is replaced by resistance R then find the value of R, to maintain same current…

A:

Q: In the circuit below, is = 4 Amps, R₁ = 40 and R₂ = 40. Find i, in Amps to 2dp. Answer: R₁ R₂

A: Given data, is=4 A, R1=40 Ω, R2=40 Ω. Circuit diagram is given as,

Q: 12-phase ∆-connected 3200 V (line-to-line), 12,000 kW, 50 Hz, twelve-pole squirrel-cage induction…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: al For representation of relative integers absolute value, the coding on 8 bits and b) What are the…

A: In the sign-magnitude form, 1st MSB bit tells about the sign of the number, and the rest bit tells…

Q: Find the magnitude of the currents 13, 14, 16 & 17? 12₂=12 A 4 = 10 A ww b www 13 C Is=8 A d 17 www…

A: Note: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits.…

Q: (d). In a dynamic random access memory (DRAM) unit cell, what is the minimum number of devices for…

A: We need to tell about DRAM ans compare with SRAM .

Q: 8- Using Fourier Transform property, find the Fourier transform of x(t)? 1.5 1 X₁ (t) x(t) 2 3 Given…

A:

Q: Why is an oscilloscope the preferred test instrument when checking inductive type sensors? (40 - 60…

A: We need to find out why oscilloscope preferred test instrument.

Q: What are the expected voltages at points C and D of this circuit? 三三三三三季 O 6 V and 0 V 12 V and 12 V…

A: Note Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.