Explain metrology science and what it comprises, as well as the skills and training required to complete a Metrology degree. Define the terms descriptive, diagnostic, and predictive measurements.

Q: Due to architectural requirements, a column in a non-sway frame is of T-section as shown in the…

A: Following are the given data. As1=6-25 mm diameter bars As2=4-25 mm diameter bars h1=250 mm h2=450…

Q: 2) The cable is subjected to a uniform loading of w = 500 lb/ft. Determine tension in the cable at:…

A:

Q: A CLOSE COILED HELICAL SPRING IS TO HAVE A STIFFNESS OF 1 N/MM OF COMPRESSION UNDER A MAXIMUM LOAD…

A:

Q: Why some volcanos are near a subduction zone?

A: A volcano is a fissure in the crust of the Earth through which molten rock, gases, and debris can…

Q: Determine the force in members AB, BD, BE, and DE of the Howe roof truss shown below.

A:

Q: If the bearing of line AB is S 42° 30' 15" E and the bearing of CB is N 38° 42′ 25" E, find the…

A: Given, Bearing of line AB=S 42° 30' 15''EBearing of line CB=N 38°42'25''E

Q: Determine the support reactions for the following structures. Q2. A I/m B B is an internal hinge 12…

A: Given that, Three hinged semicircular arch  Which is a determinate structure and hence equilibrium…

Q: Q3: A U-tube containing mercury is used to measure the pressure of an oil of specific gravity 0.82…

A:

Q: L = 1268.46 ft 2567 = 2560 + 2.5(L/2) − 2.5(L/2 − 1) + (1.5 + 2.5)/(2L) (L/2 − 1)2 L2 −13L+4=0 BVC…

A: Given:- The initial grade = -2.5% The final grade = +1.5% The elevation of point VPI = 2560.00 ft…

Q: Question Foundation soil at the toe of dam has void ratio of 0.7. The specific gravity of soil…

A: Given data- Void ratio e=0.7 Specific gravity G=2.6 Upward gradient should not exceed 30% of the…

Q: Design a square column for the given concentric axial loads. The column is applied with total dead…

A:

Q: Let strain rosette shown in figure computed the values of strains at the built in end and in NA of…

A:

Q: A Laboratory scale treatability study was done to determine kinetic constants with results shown in…

A: The maximum specific growth rate (µm) is a measure of the growth potential of microorganisms under…

Q: The analysis of a water sample for MPN calculation in Multiple Tube Fermentation Test is given…

A: Given: Multiple tube fermentation test is given below,

Q: The plan area of a reservoir is 1 km². The water level in the reservoir is observed to decline by 20…

A:

Q: Two Pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A and…

A: Given: Two pegs A and B were fixed on opposite banks of a 50 m wide river. The level was set up at A…

Q: Suppose that in addition to the 2 at point D, a 2.20-kN downward Figure 1)

A:

Q: Design an open well in coarse sand for a yield of 0.004 cumecs when operated under a depression head…

A:

Q: A beam is simply supported and has a span of 12 m. The beam is a W33x240 with Ex-345 MPa. Compute…

A: Answer  Since we are not given any data related to lateral bracing let us consider that bracings are…

Q: Q2. As shown in Fig. Q2, a simply supported beam with overhang over the support B is supposed to…

A: Given: LL = 75 kN/m DL = 55 kN/m fc = 35 MPa fy = 500 MPa b = 325 mm h = 725 mm d = 550 mm d' = 75…

Q: solve for the reactions and draw the shear and moment diagrams

A:

Q: The compound beam (Figure 1) is pin supported at B and supported by rockers at A and C. There is a…

A:

Q: Determine the approximate axial forces, shears, and moments for all the members of the frames shown…

A:

Q: Solve An ISA 125 x 75 x 8 is welded with the flange of a column ISHB 300. The bracket carries a…

A:

Q: Situation C. A cantilever beam 5 m long carries a concentrated load P at 3.75 m from the fixed end.…

A:

Q: The wheel base of a vehicle moving on a B.G track is 6100 mm and the diameter of the wheel is 1524…

A: Given data , Depth of flanges below top of rail, h = 32mm Diameter, D = 1524 mm wheel base, B = 6100…

Q: A 25-mm-diameter steel [E = 202 GPa; a = 11.9x106/°C] bolt is used to connect two rigid parts of an…

A:

Q: For the beam section shown in Fig. 2, determine the steel areas required to resist the ultimate…

A:

Q: Section 1: Infiltrability a. How would you describe the essence of infiltration and the basic…

A: (a) Soil water management is an essential aspect of agriculture and land management. The efficient…

Q: The solid spindle AB has a diameter ds = 1.69 in. and is made of a steel with G=11.2 x 106 psi and…

A: Given, ds = 1.69 in  For steel : G = 11.2 x 106 psi and τall = 12 ksi For brass : G = 5.6 x 106 psi…

Q: find A ↓ 70 m ↓ 6 all beam. four Also B I ↓ ↓ ↓ + 100m reachion for 353.38 KN / m som D above find…

A:

Q: The shear diagram is shown in the figure, determ 90KN 2m -30KN 2m 1m

A:

Q: An aerial photograph is taken from a flight at a height of 3.5 km above mean sea level, using a…

A: Given data- Flight height H=3.5 km=3500 mfocal length f=152 mm=0.152 maverage elevation havg=460 m…

Q: 8 The 180-lb rock climber is lowered over the edge of the cliff by his two companions, who together…

A: Following are the given information. Weight of rock climber =180 lb Horizontal pull =75 lb

Q: mas Sad SALLE Two types of asphalt cement (I and II) were tested with different temperatures to…

A: Answer  (1) Let us first plot the viscosity Vs temperature chart in a semi-log paper Convert…

Q: Periodic code audits provide what benefits?

A: Periodic code audit is a process of reviewing and analyzing software code on a regular basis to…

Q: Draw A Am the influence E It 2 B + line of moment at point D 1. S 0.5 с

A:

Q: A propped beam of length 6m carries a concentrated load of 130kN, 2m from the fixed support and…

A: A Propped cantilever beam, loaded 130 kN at 2 m from the fixed end and 40kN at 4 m from the fixed…

Q: Let strain rosette shown in figure computed the values of strains at the built in end and in NA of…

A: Answer  Calculation of poisson's ratio Poisson's ratio is given by μ = Lateral strainLongitudinal…

Q: CITIE MATK o Na B: A coarse aggregate sample has been collected from a quarry to be used in a…

A: To determine if the course aggregate sample complies with the Iraqi specification, we need to…

Q: Problem 1. Use slope-deflection method and determine the following unknowns on the beam shown below.…

A:

Q: Q3] For the given beam, neglecting self weight, find: (1) The equation of the deflection curve. (2)…

A: INTRODUCTION: The analysis of slope and deflection is determined using one of the method of double…

Q: Use direct integration of load to solve for the shear and moment equations for the beam bel- The…

A:

Q: The inflow and outflow hydrographs of a reservoir routing are shown below inflow(m/sec) 27…

A: Given data- Inflow hydrograph- Outflow hydrograph- To Find- The values of the peak attenuation…

Q: ▼ Part A Determine the magnitudes of the axial forces in the members of the truss. (Figure 1) Enter…

A: Given Data m = 20 kg  Determine the forces in each member and it's nature.

Q: Determine the location of the shear center for the following section. Determine the shear stress at…

A: Data Given: h1= 25mm h = 100mm b = 50mm Thickness = 4mm V = 20 kN Asked: Determine the location of…

Q: 2300 ft equal tangent crest vertical curve is currently designed for 60 mph.this curve connects an…

A:

Q: a) Calculate the service shear force applied on the connection. b) Calculate the service tensile…

A: Given data: Section of tee bracket = WT 6*32.5 is attached to a column flange  Section of column =…

Q: The 7/8-in.diameter pins at A and C that support the structure are in single shear. Find the largest…

A: I have explained this question in detail but please see the figure carefully to know the value of…

Q: 3. The beam below is supported by a pin at A and a roller at B. Determine the reactionary forces.…

A:

Basic Concepts of Water Resource Sustainability

The majority of the earth's surface is composed of water. The water which is available for use by the living beings on earth comes from various water resources. Water resources are the naturally occurring water bodies that are intended to be used by the living beings on earth for drinking and other uses. Water resources provide 3% as freshwater, 97% as saltwater, two-thirds of which are frozen as glaciers and ices. The remaining water which generally doesn't remain frozen are the water resources found underground, precisely known as groundwater. The majority of these water sources act as non-convention sources of power generation, like in hydropower stations.