Explain the operation of the accelerator position sensor
Q: Question: How can we change the pressure valve of the hydraulic transmission system?
A: A hydraulic power transmission system uses a pressured flow to transport the energy needed to…
Q: A throttle position sensor has _________ . a- a 0-5 volts signal output terminal b- a 5-volt…
A: all answers are correct hence c option is correct. Explanation → →A throttle position sensor signals…
Q: The main job of the idler arm is to __.a. support the left side of the center linkb. support the…
A: The idler arm is designed to keep the center link parallel to the road surface while allowing the…
Q: Which of the following is considered to be an "accelerator" in an automobile? * All of them. gas…
A:
Q: B2. Explain the transducer elements with block diagram and mention the different types of…
A: The transducer comprises two imperative parts. The transducer has numerous other parts like…
Q: While discussing the fail-safe function: Technician A says that the 4WS indicator light is…
A: The statement given by technician A is correct as when the fail-safe function that is when the any…
Q: Dicuss the power train of four wheel tractor.
A:
Q: What is the maximum torque? to avoid damage from throttle r LAB T
A:
Q: Which component allows the vehicle to maximize engine torque? A- Torque converter B- Differential…
A: Option A is correct.
Q: 43) Technician A says the transmission hydraulic pump operates only when the vehicle is in motion.…
A: The function of the transmission hydraulic pump is to convert mechanical energy into pressure and…
Q: While discussing SFI systems: Technician A says that when the injection system fires according to…
A: The SFI system stands for Sequential Fuel Injection System. Within the SFI system, a specially…
Q: Identify the speed sensor. a. Tachogenerator b. Diaphragm sensor c. Rotameter d. Potentiometer
A:
Q: D1) How the power drop hummer accelerate?
A: Power drop hammer is accelerated with the help of the force of pressurised air or steam.
Q: What are the advantages of the hydraulic ram?
A: A hydraulic ram is an instrument that can transfer liquid (especially water) from a lower energy…
Q: What can throttle pressure be used for in automatic transmission?
A: The throttle pressure in an automatic transmission is used to control and lubricate the…
Q: clutch is fully engaged, the driven disc does not rotate at the same speed as the driving members *
A: Slipping occurs when the clutch is fully engaged and the driven disc does not rotate at the same…
Q: The typical RWD drive shaft rotates how many times faster than wheels
A: The typical Rear Wheel Drive (RWD) shaft rotates three times faster than the wheels,
Q: Describe the normal pedal feel when the ABS is activated during hard braking?
A: Anti braking system(ABS): Anti braking system(ABS) allows a driver to apply the brakes quickly…
Q: Explain three different methods of clutch pedal adjustment.
A: Clutch plays an important role to help the driver in controlling transmission i.e. gearshift while…
Q: We want to keep this vehicle speed constant As manipulation we want automatically adjust gas\brake…
A: Given Car To find Block diagram to maintain uniform velocity
Q: Which of the following is not a voltage-generating type sensor? vehicle speed sensor OSS MAP ISS
A: Voltage generating type sensors This type of generators consists of different types of speed sensors…
Q: The torque (in Nm)
A: Given data: Forces F1 and F2 in a brake band and the direction of rotation of the drum are shown in…
Q: The following instruments are considered gyroscopic. * Tachometer VSI Altimeter Fuel…
A:
Q: The torquemeter system may be ysed also for automatic propellre feathering propeller pitch…
A: The torquemeter system may be used also for automatic propeller feathering.
Q: Technician A says hypoid gearset are only used in RWD vehicle drivetrains. Technician B says hypoid…
A: Hypoid gear is spiral bevel gear in which the axes doesn't intersect and it is not parallel. This…
Q: Analytically determine the range of transmission angle crank blade
A:
Q: List the main components of the internal combustion engine.
A: Internal Combustion Engine: Internal combustion engine mainly known as IC Engine. In this kind of…
Q: If an electrical defect occurs in the electronic power-steering (EPS) system_ a. the system…
A: If an electrical defect occurs in the electronic power-steering (EPS) system, the system continues…
Q: give 10 Troubleshooting for IC engin
A:
Q: catic coefficient of mallest acceleration
A: Draw the free-body diagram as follows.
Q: andard efficiency & brake thermal efficiency of engin
A: given:brake thermal efficiency=24.4%air thermal efficiency=53.4%
Q: what is the purpose of having two accelerator pedal signals in an electronic throttle control system
A: The accelerator pedal signals are used to control the throttle valves in an electronic throttle…
Q: Describe the procedure for checking clutch pedal free travel
A: Clutch pedal free travel is a specific distance that a clutch has to travel to reach the point where…
Q: In an Airbus A320 these instruments are presented in the PFD (Primary Flight Displays).
A: Primary Flight Display ( PFD) Primary flight display mainly consist of combines data from several…
Q: neat diagram, explain the wind turbine components such as Rotor, Drivetrain and Control System
A: The kinetic energy of wind waves when converted into electrical energy this mechanical process is…
Q: explain briefly which input signals to the ECM control the turocharger ?
A: Turbocharger :- The turbocharger is used to boost the intake air temperature of an internal…
Q: A digital speedometer constantly reads 0 mph : TechnicianA says that the problem may be the…
A: Given Speedometer To find Which technician is correct
Q: Muffler is used in Select one: a exhaust system b. lubrication system O c. cooling system O d.…
A: Mufflers: It is a device which is used to reduce the noise produced by an engine. The mullers are…
Q: Explain the operation of the accelerator position sensors?
A: Principle of operation as follows. The application of alternating voltage to the transmission coil…
Q: rchar
A: introduction: A supercharger is a type of air compressor that boosts the pressure or density of air…
Q: An electronically controlled transmission has erratic shifting: Technician A says that a poor PCM…
A: Shifting of the gear is caused by producing voltage across the terminals where the pressure is…
Q: Amount of fuel consumed by the engine for each horsepower or pound of thrust Fuel Consumption Weight…
A: Now defined each term as follows. Fuel consumption weight is defined as fuel consumed by the engine…
Q: What are the different sensors and probes used in aircraft engine
A: Probes are used to collect information and sensors are supposed to perceive the information and…
Q: ECU collects and processes signals from O various engine sensors. controls the fuel level in the…
A: ECU - Engine control unit. It is basically electronic circuits which collects the input from various…
Q: used to change of the power force steering to liners movement *
A: Box steering Rear wheel
Q: Technician A says that the throttle position is an input to the PCM. Technician B says that the…
A: When brake pedal switch is pressed it sends an input to the PCM to maintain idle speed of a…
Q: woltage Induced. speed and torque.
A: In a synchronous generator, the waveform of generated voltage is synchronized with (directly…
Explain the operation of the accelerator position sensor
Step by step
Solved in 2 steps
- While discussing throttle-by-wire systems: Technician A says that a spring on the throttle shaft provides the limp-home feature. Technician B says that most systems have redundant processors and the TP and accelerator pedal sensors send redundant input signals. Who is correct?A. Tech A B. Tech B C. Both A and B D. Neither A nor Bwhat is the purpose of having two accelerator pedal signals in an electronic throttle control systemExplain about sensors using for speed, throttle position and crank shaft position with the help of neat diagram.
- Which of the following is not part of the running gear? Differential Steering Suspension BrakesWhile discussing how to test a Hall-effect crankshaft position sensor: Technician A says that a logic probe can be used. Technician B says that a DMM can be used. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor BTechnician A says that negative caster provides directional stability . Technician B says that pos caster results from excessive positive cam ber . Who is correct ?
- What is the name for the gas-filled pressure chamber that is part of the antilock braking system's pump and motor assembly? Control module Accumulator Sensor ReservoirWhich sensor is used for misfire monitoring on OBD II systems? Oxygen sensor Camshaft position sensor Crankshaft position sensor DPFE sensorThe typical RWD drive shaft rotates how many times faster than wheels
- While discussing SFI systems: Technician A says that when the injection system fires according to crankshaft position and speed, it is operating in the synchronous mode. Technician B says that one of the advantages of SFI systems is that they are always in the synchronous mode. Who is correct?A digital speedometer constantly reads 0 mph: Technician A says that the problem may be the vehicle speed sensor. Technician B says that the problem may be the throttle position sensor. Who is correct? Technician A Technician B Both A and B Neither A nor BWhich of the following is the most likely cause of a lean condition during acceleration and cruising speeds? a. A defective oxygen sensor b. A defective PCM c. A defective ECT sensor d. A defective MAF sensor
