F2 = P,A2 F, = P,A, 1. What is the force required in newton (N), to lift a car weighing 1000 -kg, using a hydraulic car jack with a piston area ratio (A2/A1) of 10. 2. The large piston in a hydraulic lift has a radius of 250 cm2 . What force (kgf) must be applied to the small piston with a radius of 25 cm2 in order to raise a car of mass 1500 kg? 3. A trash compactor pushes down with a force of 500 N on a 3 cm2 input piston, causing a force of 30,000 N to crush the trash. What is the area of the output piston that crushes the trash?

F2 = P,A2 F, = P,A, 1. What is the force required in newton (N), to lift a car weighing 1000 -kg, using a hydraulic car jack with a piston area ratio (A2/A1) of 10. 2. The large piston in a hydraulic lift has a radius of 250 cm2 . What force (kgf) must be applied to the small piston with a radius of 25 cm2 in order to raise a car of mass 1500 kg? 3. A trash compactor pushes down with a force of 500 N on a 3 cm2 input piston, causing a force of 30,000 N to crush the trash. What is the area of the output piston that crushes the trash?

Name: F2 =P2A2F, = P,A,1. What is the force required in newton (N), to lift
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: F2 =P2A2F, = P,A,1. What is the force required in newton (N), to lift a carweighing 1000 -kg, using a hydraulic car jack with apiston area ratio (A2/A1) of 10.2. The large piston in a hydraulic lift has a radius of 250 cm2. What force (kgf) must be

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A hydraulic lift system utilizes two 5" diameter cylinders. Workers must determine how mic the system is capable of lifting before deciding how much weight can be lifted safely. The system runs at a gauge pressure of 2000lb/in2 How much is the system capable of lifting?
A hydraulic lift system utilizes two 5" diameter cylinders. Workers must determine how mic the system is capable of lifting before deciding how much weight can be lifted safely. The system runs at a gauge pressure of 2000lb/in? What is the area of each piston?
Absolute pressure is the actual existing pressure, independent of the environment, while gauge pressure is the pressure relative to the exterior environment, which is usually the atmosphere (with a pressure of 1 atm). Convert an absolute pressure of 7.25 × 105 N/m2 to gauge pressure, in pounds per square inch. Pg= ?
4. Assuming standard condition, what is the altitude in ft where the density is 0.001845 slug/ft3?
What is the magnitude of the net torque on the sale from an axis of rotation labeled as ? in figure 2, if the following values are indicated: a =2,5 m, L = 1,1 m, g = 9,81 m/s2 y p(density of water) = 1000 kg/m3
An iceberg weighing 57 lb/ft3 floats in the ocean (64 lb/ft3) with a volume of 21,000 ft above the surface. What is the total volume of the iceberg?
A body of dimensions 1.5 m x 1.0 m x 2 m, weighs 1962 N in water. Find itsweight in air. What will be its specific gravity?
In a car service station, a force of 100 N is required to raise the car on the hydraulic lift. If the diameter of the hydraulic lift is 20 times as the radius of the piston where the force must be applied, what is the mass of the car to be lifted?
Suppose the pressure in a car tire is specified as 3 bar, what will be the absolutepressure in SI unit (kPa)?
Rover weight capacity 35 kilo grams (payload)Rover measurements:Wheel distance - 14.5 inches and 8.5 inchesRover platform size (width & length) 14.4 inches x 10.4 inchesHeight- 15.8 inches Water tank selectionMore or less 25 liters*For tank selection we need to justify the size with the center of gravity, proving that is themaximum dimension or liters of the tank because the center of gravity will be higher makingthe rover prone to topplingPump selection*Our sprayer design has two nozzles which splits using a tee splitter, we need to find thesize of the pump to obtain the same discharge rate of a normal sprayer. A normal sprayerhas a 12V pump and a pressure from 0.2 to 0.45 mpa (30-65 psi)The application rate of the main pesticide is 9.6 - 19.2 fl oz/A (Brigade Insecticide for sweetpotato)Thai was the initial deign where the water tank is above the battery and pump, but wechanged our mind, now it is the battery and pump above the waterBattery selection* once the size of the pump…
1. A water vessel was designed to go 149 miles underwater, with the surrounding fluid having a density of 1,030,000 g/m^3. What is the pressure difference between the outside and inside of the wall?
As illustrated, a mercury manometer is attached to the side of a nearly full water tank. The reading of the mercury column is 15.5 in. Hg gage. Although air on the water maintains the pressure, the other 10-in. leg of the manometer is full of water, for H2O , ρ = 62.3lb/ft3 ; for Hg, ρ = 846lb/ft3 If the location is at standard gravity and the temperature of both the water and mercury is 60°F, what is the pressure (psia) in the tank at the level where the manometer is attached? If the tank extends 10ft below this level, what is the pressure at this depth?