Figure 1 shows the manometer apparatus with different fluids. It is given that the specific density of the mercury and oil are 13.56, and 0.9 respectively. Solve, a. The liquid level, Az when the area of the reservoir on the left limb of the manometer is 100 times the area of the manometer tube in right limb. The volume X is equal to Volume Y. b. The pressure at point A. Oil Volume Y 45cm 18cm Mercury Az olume X ÷

Figure 1 shows the manometer apparatus with different fluids. It is given that the specific density of the mercury and oil are 13.56, and 0.9 respectively. Solve, a. The liquid level, Az when the area of the reservoir on the left limb of the manometer is 100 times the area of the manometer tube in right limb. The volume X is equal to Volume Y. b. The pressure at point A. Oil Volume Y 45cm 18cm Mercury Az olume X ÷

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

For the manometer set up shown, determine the difference in pressure between A and B.
In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m as shown. Determine the pressure difference between A and B.
1) A glass manometer with oil as the working fluid is connected to an air duct. Which of the following picture is CORRECT? a or b 2) A device measured stagnation pressure is called? a) barometer b) Piezometer c) Pitot tube d) manometer
6. Freshwater and seawater flowing in parallel horizontal pipelines are connected to each other by a double U-tube manometer, as shown in figure. Determine the pressure difference Pfresh water- Psea water= ?(kPa) between the two pipelines. Take the density of seawater at that location to be P = 1035 kg/m³. (2 decimal)
A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined inan internal reservoir inside the closed tank, the height of mercury is 450mm. An openmanometer is placed on the bottom left part of the tank with liquid “X” as its gage liquid , thedeflection from the gage liquid shows 800mm. Determine the following:a) Height of the oil from point A up to point c if height A to C is 5 times the height of y.b) Pressure at point B in kPa. c) Pressure at point C in psi.
flow of water in the below diagram is from point X to Y. The oil is in the e inverted U-tube manometer. The mercury is in the bottom of the manome ressure difference P -P in kPa?
What is the mass (lbm) of an object that has a base area of 4 inch2 which exerts a pressure of 25 psi? 2.) Determine the dynamic viscosity (Pa-sec) and kinematic viscosity (m2/s) of water with a specific weight of 9.81 kN/m3, if a Falling Sphere Viscosimeter test is conducted using an aluminum sphere that has a diameter of 10 mm and a specific weight of 28.06 kN/m3. The theoretical terminal velocity of the sphere is 0.650 m/s. Round off your answer to 3 decimal places. 3.) Given the water tank A in an orifice setup that transfers water to tank B, determine the theoretical and actual velocity and flow rate if the time it takes to fill up tank B is 20 sec. 4.) Given the computed velocities and flow rates in Question 3, determine the coefficient of contraction, velocity, and discharge. Assume the diameter of vena contracta to be 4mmø.
The inverted U-tube manometer contains oil (0.90) and water as shown. If the pressure differential between pipes A and B, is (-5) kPa. Determine the differential reading, h in centimeters.
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8
b) The U-tube manometer can be used to determine pressure difference between two systems.This type of manometer is called a differential U-tube manometer. Consider the differentialmanometer connected to a pipe, as shown in Figure 1. Explain step by step on how you cancalculate the pressure difference between point A and B.
For the inclined manometer containing mercury, shown in the figure, determine the pressure in pipe B if the pressure in pipe A is 10 kPa and the reading along the inclined leg of the manometer is 11 cm instead of 9 cm. Pipe A has water flowing through it, and oil is flowing in pipe B.
A U-tube manometer is attached to a water pipe as shown in Figure 5.1. Given specific gravity of mercury, S.G = 13.6 and assume Patm is set to zero. Estimate the pressure in the water pipe in kPa.