A cylindrical object 84mm diameter, 158mm height and a mass of 593g, is placed in the tank, which contains oil(51mm thick) and water. Calculate the height(in mm) above the surface of the oil at which it will float if maintained in the vertical position. Take density of oil equals 973 kg/m³. Answer in two decimal places.

A cylindrical object 84mm diameter, 158mm height and a mass of 593g, is placed in the tank, which contains oil(51mm thick) and water. Calculate the height(in mm) above the surface of the oil at which it will float if maintained in the vertical position. Take density of oil equals 973 kg/m³. Answer in two decimal places.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A hydraulic jack contains 2.0 litres of oil as the working fluid. The compressibility of the oil is 1.98 × 10^-10/ Pa. Given that,compressibility of a liquid = 1/ bulk modulusof the liquid Calculate the absolute decrease in the volume of the oil when it is under a constant pressure of 1.50 × 107 N/m^2.
Convert the following air pressure readingsfrom cm H2O to Pa.a. 1.5 cm H2Ob. 3.7 cm H2O
A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 Nper cubic meter enters the bottom of the tank with a uniform velocity of—assume values with decimals between 3 to 4 m per second—enters thestack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Please add the figure , thank you!
A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3 . Determine (a) the totalvolume of the fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specificweight where g = 31.9 fps2
Determine the diameter of an orifice that permits a tank of horizontal crosssection 1.5m2 to have its liquid surface draw down at the rate of 160 mm/sfor a 3.35-m head on the orifice. Use C=0.63.
3. The system in Figure 2-5 is at 20oC. If atmospheric pressure is 101.03 kPa and the absolute pressure at the bottom of the tank is 231.3 kPa, what is the specific gravity of olive oil? Note: density of water=9.79 kN/m3 (specific gravity SAE oil is 0.89, h SAE oil is 1.5m, h water is 2.5m, H olive oil is 2.9m, h mercury is 0.4m) and use g=9.79m/s2. a) 1.39 b) 1.29 c) 1.49 d) 1.59 e) none of the above
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
An open rectangular tank 2m by 2m and 3.5m high contains 3 layers of liquids with specific gravities of 1.3, 1.0, and 0.9, and heights of 1.0m, 1.5m, and 0.5m respectively. An opening with an area of 25 cm2 and coefficient of discharge of 0.711 is situated at the bottom of the tank. 1. How long will it take to discharge the bottom layer of the liquids? in seconds 2. What is the total time to discharge the bottom and the middle layers of the liquids? in seconds 3. What would be the total time to discharge all the liquids? in seconds
An open rectangular tank 3.8m high, 2.5m wide and 6m long is filled with water at a depth of 2.2m. If it is accelerated at 2.3 m/s^2 and is moving at a plane inclined 15 degrees from the horizontal, determine the following: a. acceleration of the vessel along the horizontal; and b. angle of fluid inclination. Note: Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3.
An open circular vessel is 1m in diameter and 2m height. It contains water filled to a depth of 1.5m. If the cylinder rotates about its vertical axis, what constant angular velocity can be obtained without spilling? Unit of the Correct Answer: rad/sec Decimal Places required in the final answer: 3 PLS 3 DECIMALS..
An elevated water tank consists of an upper cylindrical part (4.88 m in diamwter and 6.10 m high) and a lower hemispherical part, at the lowest point of which is an orifice 310 mm in diameter (C=0.60). If, at time t=0, the tank is full of water, when will the water level drop down 6.71m, after opening the orifice? 35 seconds 415 seconds 235 seconds 260 seconds
A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose densityis 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds andslugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .