Figure 13 illustrates liquid level monitoring using radar type level transmitter. Describe how the level of the liquid can be measured using the mentioned transmitter. Radar type level transmitter 11/ 13

Q: Explain the status flags for the operation AEH+37H

A: I have provided an explanation for 8086. This result can also be applied to 8085 ignoring overflow…

Q: 1. When is the counter EMF at a minimum?

A:

Q: Draw the ladder diagram of the given relay diagram

A: Two relay logic diagrams are given. We need to draw the ladder diagram.

Q: Describe about the smoke alarm experiment.

A: Smoke detectors are used to detect the smoke. When there is a fire and smoke arises, then these…

Q: Discussion: 1. Explain the operation of envelope detector shown in figure (1).

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Choose the correct answer:

A:

Q: What is the frequency at which commercial microwave ovens operate?

A: The solution is provided in the following section:

Q: Draw the block diagram for the light pupil system using close loop system

A: The block diagram for the light pupil is drawn below:

Q: Question 2. Select the correct statement regarding the modulated ASK waveform. a. There is no…

A: The answer is provided below:-

Q: Choose the correct answer.

A: given a 1.5 hp motor has input current of 10A at a voltage of 120 V. Here we have to find the…

Q: Draw a block diagram of generalized communication system. Write the functions of each of the…

A: communication system: It is a system in which the message signal is transmitted through the channel…

Q: 3. The radar in which both transmission and reception is done using the same antenna are called:

A: The correct option along with the explanation is provided in the following section.

Q: Please read the following questions carefully and then elaborate on cach of 1-Describe wireless…

A: Some technical challenges that a wireless communication faces are  i)multipath propagation…

Q: 8. Which of the following properties describes the transmitters and receivers in paging system?

A: The solution is provided in the following section.

Q: Aircraft lighting What type of device is often used on radio systems for automatically controlling…

A: Solution:Photo sensors monitor the ambient light and maintain the brightness level over various…

Q: A single-phased load is located 2800 ft from its source. The load draws a current of 86 A and…

A: Maximum voltage drop is 3% Edrop=480×3100=14.4 V So maximum allowed resistance is…

Q: At what frequency commercial microwave ovens operate?

A: Commercial microwave ovens operate at 915 MHz, 2.45 GHz and 5.8 GHz. Commercial ovens can be used…

Q: Describe the graph of the oscilloscope

A: Electrical devices are used for measuring electrical parameters. Current, voltage, and power are…

Q: Which statements are correct regarding the picture?

A: Image shows Airbus electrical system.

Q: Create a circuit diagram for the given armature: (the circle one): 4 poles, 26 conductors, double…

A: 4 poles26 conductors-double layer-simplex wave winding

Q: Give the other names of depletion region? (At least Two)

A: At the junction of p-type semiconductor and n-type semiconductor, in which there  is neither an…

Q: You are asked to select an appropriate antenna for each of the following two wireless systems. Give…

A: (i). In the first case, directional antenna is used. A directional antenna is a wireless radio…

Q: Can a Type TW cable be used in an area that has an ambient temperature of 65 degrees Celsius?

A: Ambient temperature of a TW type cable is 60 degree Celcius so that it can not be used where ambient…

Q: The minimum burial depth for a Type UF cable feeding a pole light in a residential application is…

A: Section 680.26 in article 680 of the NEC covers this requirement under the installation requirement…

Q: How many wires must be run between an incandescent lamp and it's dimmer contorl?

A: According to question, How many wires must be run between an incandescent lamp and its dimmer…

Q: Answer number 8 only

A: Control systems are represented by transfer function. This  can be written in both time domain and…

Q: QUESTION 46 HIRF is? A strong transmitted electromagnetic field. O The ability to detect…

A: Note: As per our policy we can solve only one question, please reupload the remaining question as…

Q: What is the difference between the white and pink noise ?

A:

Q: Is the laser beam brighter than the sun?  Yes  No  Probably

A: The answer of the above question is 'Yes'. The explanation is given in the next step.

Q: Question 3: why do we use the envelope detector ASK signal?

A: Envelope detector : envelope detector is a electronic circuit that takes a high-frequency amplitude…

Q: X) Answer the following questions  (d)For a positive going pulse, mention the leading edge and…

A:

Q: What is the distance (miles) to the radio horizon for an antenna that is 45 ft. above the top of a…

A: It is given that: Antenna=45ft.mountain=3737ft.

Q: Describe at least 5 equipment’s used in Microwave measurement set up. 2. Describe two useful…

A: In microwave measurement set up conventional instrument like voltmeter and ammeter won't work due to…

Q: Why it should be used in both sides (transmitter and receiver) in the radar system.

A: Radars- Radars have very large wave length. Since radio waves can have very length and also the…

Q: Pre-Laboratory Assignment 1-) What are the basic purposes of using an oscilloscope and a multimeter?

A: According to the guidelines which can answer first question   Oscilloscope is a device which is used…

Q: To what range should you shift if your readings are at the crowded end of the scale?

A:

Q: applications of Automatic Light Fence Circuit Diagram with Alarm

A: Automatic light fence circuit with alarm: The automatic light fence circuit is a sensitive device…

Q: How Know the Q is lasing leading to thow

A:

Q: Question: BJT's have switching frequencies since their turn-on and turn-off time are low Option 1:…

A: The solution is given below  the answer is option 2

Q: When selecting conductors, from where is the motor full - load ampere rating to be taken

A: During the selection of the conductors, the motor full-load ampere rating is taken in the squirrel…

Q: Explain whether the solar dish is two axis tracking system or one axis tracking system? Compare two…

A: Single axis solar tracking system is used for the tilted solar panel for solar dish we can use two…

Q: (c) Explain any two methods of reducing interference. marks)

A: In power system, the transmission lines discharges emit radiation due to corona. This may introduces…

Q: 3. Which factor determines the color of the emitted light of the LED?

A: The explanation is as follows.

Q: Which of the following is not used for communications? Select the correct response: A. X-rays B.…

A: In this we will write which way is not used for communication...

Q: Explain the operation of central receiver solar power plant with neat diagram.

A: According to question we need to discuss about central power plant with a neat diagram.

Q: Compare the principles of RADAR and LASER.

A: RADAR stands for Radio Detection And Ranging. LASER stands for light amplification by the stimulated…

Q: 1111

A: The image provided by you is not clear , so as much I can understand from figure is that is a…

Q: 16. Name three parts of a simplex fiber optic cable which are removed before you can attach a…

A: As per company policy we have suppose to answer only 1st question. I requested to you please upload…

Q: Prepare an assembly chart for a table lamp.

A: An assembly chart is model that shows which part are to be fitted together and the overall view of…

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.