Answered: Two point charges exert force of 0.49…

Two point charges exert force of 0.49 grams on each other. If the charges are 3.2 cm apart and with the same value. what is the value of each charge? Q- statCoulomb Note: Use g = 980 cm/s².

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter1: Atomic Structure

Section: Chapter Questions

Problem 1RQ: What are the three principal parts of an atom, and what charge does each carry?

See similar textbooks

Related questions

Q: A coil takes 12 A from a 60 Hz, 200 V source. A 100 µF capacitor is connected across the coil and…

A: The parallel configuration of an Inductor and a Capacitor can exhibit continuous discharging -…

Q: a When setting the Q-point of a JFET amplifier why is the bias circuit shown in Figure 3.1 (b) used…

A: Brief description: In the above given question we need to justify importance of the voltage divider…

Q: QUESTION 9 A lightning bolt strikes an airplane with 30 kA for 2 ms. How many coulombs of charge are…

A: Given, A lightning bolt strikes on airplane with Current, I=30 kA For time, t=2 mA

Q: 5. A 50-hp synchronous motor has a full-load efficiency of 91 per cent and operates at a power…

A: given a 50-hp synchronous motor has a full load efficiency of 91 % and power factor is 0.8…

Q: An FM wave uses a 2-5 V. 500 Hz modulating frequency and has a modulation index of 50. The deviation…

A: Frequency deviation The difference between the minimum and greatest extent of a frequency modulated…

Q: b) Find the capacitance of a parallel plate capacitor if the area of each plate is 0.1 m² and the…

A: Given: A parallel plate capacitor with, A=0.1 m2d=2 mmεr=5ε0=8.854×10-12 F/m

Q: [20] Using nodal analysis, find Va, V6, and ly. LOV 5 кл хкл m укл H aplov ww 2mA x=14kΩ y=15kΩ

Q: A three-phase 20 MVA, 11 kV generator has a reactance of 10% and is connected via a bank of three…

A: Selected MVA base is 10 and KV base is 15KV impedance base, ZB=VB2SB=15210=22.5ΩCurrent base,…

Q: From the following circuit obtain the Thevenin equivalent of the network connected to ?L Next obtain…

A: Brief description: For the above given question we need to calculate the value of Vth & Rth.

Q: 9) Solve the nodes and order the matrix of the following way: [AB] What is the value of A and B?…

A: The required parameters can be calculated by using kirchhoff's current law to the nodes.

Q: List the factors Which affects the amount of Electromotive force generated by seebeck effect plz…

A: Given We need to List the factors Which affects the amount of Electromotive force generated by…

Q: An FM wave uses a 2-5 V. 500 Hz modulating frequency and has a modulation index of 50. The deviation…

A: Given an FM wave uses, Modulating frequency, fm=500 Hz Modulation index, μ=50 Frequency deviation,…

Q: Determine the voltage gain for a NPN CB stage with base resistance (without early effect) (You must…

Q: A 1.5 KVA 50 Hz single-phase transformer has turns ratio 40/50. The primary winding is connected to…

A: Given data, A single phase transformer has S=1.5 kVAf=50 HzN1N2=4050V1=230 V

Q: 10. The full-load losses in a 5,000-kva three-phase 6,600-volt synchronous condenser are 160 kw.…

A: For the above given question we need to calculate the value of full load current and power factor of…

Q: Find the half-range cosine series of f(x)= x(7-x)in (0,7). Hence find the sum of 11 the series 8

A: Given,The function is,fx=xπ-x

Q: AJFET data sheet specifies Vas(off) = -6 V and loss = 8 mA. The value of lp when VGs = -3 V is Blank…

Q: Q2: An AM modulator shown in figure below: a) Sketch the amplitude spectrum of Þ(t). b) Find the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Two transformers are required for a Scott connection operating from a 440-V, 3-phase supply for…

A: Given: The primary voltage is 440 V The secondary voltage is 200 V The output is 150 kVA

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Transfer function is the ratio of Laplace transform of output to the Laplace transform of input.…

Q: b) When setting the Q-point of a JFET amplifier why is the bias circuit show in Figure 3.1 (b) used…

A: b. To stabilize the Q-point (operating point) bias the circuit. We know that JFET input resistance…

Q: Design a circuit using an n-channel E-MOSFET with the following datasheet specifications: Ixon) =…

A: MOSFET:- It is a semiconductor device which is used for switching purpose. It is a voltage control…

Q: VNO- Vcc 15V 2 ka

A: BJT is the three terminal transistor. it is amplify and magnify the signal and it is consist two P-N…

Q: 8. Reduce the parallel subsystem below into its equivalent transfer function C(s) / R(s). X₁(s) =…

Q: 1. Calculate the lc in figure below with beta = 80 Vcc= 12 V 550k Select one: O a. 0.174mA O b.…

Q: Which element (capacitor or inductor) should be placed in parallel with the circuit to achieve unity…

A: In this question we need to find which element should place in parallel to make the overall power…

Q: 3. Explain where “sources” of error exist in this experiment. How could these sources of error be…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Sendent current s pute 100 mH Sketch the current waveform b. At what instant of time is the current…

A: Given Current source current at t<0, i=0 at t>0 , i=10…

Q: \ direct mapping cache memory of 46 line, main memory consists of 4K block of 128word 1. Show the…

A: Direct mapping: Each memory block in the main memory is assigned to a specific line in the cache…

Q: A series-connected circuit has R = 4 22 and L = 25 mH. (a) Calculate the value of C that will…

Q: A 3-phase, 4-wire system which has a system voltage of 254-V L-N with loads connected in wye; Za =…

A: Power:- Machine's output power is referred as the rate of doing work. Active power, apparent power…

Q: a) The n-channel JFET and the D-MOSFET have very similar I-V output characteristics. Which of these…

A: a. n-channel JFET can be operated in enhancement mode. If JFET has a small doped channel that is…

Q: A metal rod is 2m long and 8mm in diameter. Compute its resistance if the resistivity of the metal…

A: Resistance- The electrical resistance, R of this simple conductor is a function of its length, L and…

Q: From the following circuit, determine the load impedance ?? necessary to ensure that the load…

A: In this question, We need to determine the impedance ZL for the maximum power transfer? Maximum…

Q: Help please with this. Determine the propagation coefficient when the attenuation is 7.5. Using…

A: Given,Attenuation coefficient is,A=7.5The expression for attenuation is,A=eαxWhere,x=1

Q: 8-14 Find the steady-state current in the RLC-circuit in Fig. 61 for the given data. Show the…

Q: A four wire, three phase system has a balanced supply voltage of 208V. Three wattmeters are…

Q: The Impulse Response of a System is found to be t^e²t find the Transfer Function G(s).

Q: w R + 30 V For the circuit shown above, if the 30 resistor Ris (a) 12Ω (b)10Ω (c) 6 Ω ΖΩ V voltage…

A: Given circuit: Power delivered by source, P=150 W

Q: 8) Solve the meshes and order the matrix of the following way: [AB] Then, what is the value of Vo…

Q: 01) For the Oscillation circuit shown in Figure (1), derive an expression for the frequency of…

A: Oscillator Oscillator is a electronic or mechanical device, its based on working of oscillation. we…

Q: result from: Ex6: Find the unknown currents x 1 = 1₁, X 2= 12, X 3 = 13 in the electrical network…

Q: (2 201 : لا M SIW 514 1010 510 V₂ = 10V 1014 w 1010 M Find Vo 1010 w it. Yo ร

Q: 2. From the given circuit, solve for the complex power, apparent power, average power, reactive…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power. The…

Q: Q2) A parallel-plate waveguide is known to have a cutoff wavelength for the m= 1 TE and TM modes of…

A: Given Cutoff wavelength of a parallel plate waveguide.we need to determine the no of modes possible…

Q: a) The n-channel JFET and the D-MOSFET have very similar I-V output characteristics. Which of these…

A: 3. a. n channel JFET is an enhancement mode. Unlike MOSFET, JFET has a pre-made channel that can…

Q: A resistance of 100 2 in series with a 20 µF capacitor is connected in parallel with a 0.3 henry…

Q: . Convert the following decimal numbers to binary Then multiply 357 10 X 5810

A: for binary multiplication first convert decimal to binary then multiply

Q: Q3. For the system shown in Figure 3, find , .. percent overshoot, peak time, and settling time.…

A: The system block diagram is shown below,

Q: A 3-phase transmission line, 160 km long, has the following constants: Resistance/phase/km= 0.2 ohm…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

find the total charge lying in the sphere

Two point charges exert force of 0.49 grams on each other. If the charges are 3.2 cm apart and with the same value, what is the value of each charge? Q =
statCoulomb Note: Use g = 980 cm/s².

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two point charges, QA = -12 C and QB = -5 C, are separated by a distance r = 10 cm. What is the magnitude of the electric force in terms of K (Coulomb’s Constant)? a. 0.6K b. 6000K c. 600K d. 6K
A sphere of radius 1cm contains a volume charge density -1 (C/m^3), the total charge contained in the sphere is a. 0 C b. 13.3 nC c. -13.3 nC d. 10 nC
The potential difference between points in a wire 75.0 cm apart is 0.938 V when the current density Is 4.40 x 107 A/m2. What is a) the magnitude of Electric field E in the wire? b) the resistivity of the material of which the wire made. (with explanation on how to solve it)
A current-carrying gold wire has diameter 2.76 mm. The electric field in the wire is 6.6 V/m. What is the current carried by the wire in kA? Note that the resistivity of gold is p= 2.44x10-8 ohms*m
Two conductors carrying 60 A and 75 A, respectively are placed 10 cm apart. Find the force between them per meter length.
Write all pertinent solutions including illustrations and box your final answer. 1. Determine the electric field strength and potential in air at a distance of 3 cm from a charge of 5 X 10-8 C.
What is the charge density at the point (1, 4, 1) if the electric field intensity in a region is E = 3x2zax + 2xyay - yz2az N/C? Choose from the following: 0 62 pC/sq.meter 7 C/cu.meter 790 GN/C
Determine the resistance of a bus bar made of aluminum at 50°C if the length is 15 meters long and cross section is 9cm2
15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between conduction band and valance band b. A semi-conductor material does not allow the flow of electrons at all time. c. A good insulator material has 8 valance electrons d. A good conductor material has 3 valance electrons.
Two small charged spheres are placed in vacuum on the x-axis: q1 = +3.63 µC at x = 0 and q2 = -6.57 µC at x = 18.54 cm. A third charge is placed at x = a such that the net force it experiences due to q1 and q2 is zero. What is the value of a in cm? Express your answers accurate to two decimal places.
A wire 4.0 m long and 6.0 mm in diameter has a resistance of 15.0 mΩ. A potential difference of 23.0V is applied between the ends. (a) What is the current in the wire? (b) What is the current density? (c) Calculate the resistivity of the wire material
An object of mass 25kg accelerates at 1m/s2 in an electric field of 4.5 N/C. Determine the charge of the object.