Find the C, and the "apparent" OCR for a superficial clay stratum that is 4m thick. The water is at the surface. A sample of the clay has a water content of 27.9%, and a specific gravity of 2.65. An oedometer test showed the following results: Voids Ratio 0.736 0.733 0.73 0.675 0.638 0.6 Vertical Effective Stress 15 28 60 230 480 930

Find the C, and the "apparent" OCR for a superficial clay stratum that is 4m thick. The water is at the surface. A sample of the clay has a water content of 27.9%, and a specific gravity of 2.65. An oedometer test showed the following results: Voids Ratio 0.736 0.733 0.73 0.675 0.638 0.6 Vertical Effective Stress 15 28 60 230 480 930

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.9P

See similar textbooks

Similar questions

Refer to Problem 6.1. Using Eqs. (6.3) and (6.29), estimate the average stress increase (Δσav) below the center of the loaded area between depths of 3 m and 6 m. 6.1 A flexible circular area is subjected to a uniformly distributed load of 150kN/m2 (Figure 6.2). The diameter of the load area is 2 m. Determine the stress increase in a soil mass at points located 3 m below the loaded area at r = 0. 0.4 m, 0.8 m, and 1 m. Use Boussinesq’s solution. Figure 6.2 Increase in pressure under a uniformly loaded flexible circular area
A consolidated drained tri-axial test was conducted on normally consolidated clay. The results were: the confining pressure is 300 kPa and the deviators stress is 300 kPa. Compute the angle that the failure plane makes with the major principal axis in degrees. show free body diagram. a.54.74 b.16.3 c.24.72 d.19.47
A consolidated drained tri-axial test was conducted on normally consolidated clay. The results were: the confining pressure is 300 kPa and the deviators stress is 300 kPa. Compute the angle that the failure plane makes with the major principal axis in degrees. a.54.74 b.24.72 c.16.3 d.19.47
A triaxial test conducted on cohesionless soil gives the following results: Deviator stress at failure = 410kPa The angle of shearing resistance = 32 degrees Determine the following: a. Confining pressure in kPa b. Shear stress at failure plane in kPa c. Angle that the failure plane makes with the principal plane (degrees)
Water flows at a rate of 0.09 m3/s upward through a sand sample with a coefficient of permeability of 27 cm/s. The thickness of the soil is 0.24 m and the area is 0.54 sq. m. Saturated unit weight is 18.9 kN/m3. a) Determine the hydraulic gradient (Ans. 0.617) b) Compute the effective stress at the middle of the sample (Ans. 354 N/m2) c) Compute the effective stress at the bottom of the sample. (Ans. 728 N/m2)
A consolidated drained tri-axial test was conducted on normally consolidated clay. The results were: the confining pressure is 300 kPa and the deviators stress is 300 kPa. Compute the shear stress in kPa on failure plane. a. 550 b. 119.03 c. 208.9 d. 141.42
Data from an oedometer test using a clay specimen are plotted in the graph shown below. If the compression index is equal to 0.6, calculate the void ratio (e2) missing at Point C, which is associated with a vertical effective stress equal to 105 kPa
The stresses on a failure plane in a drained triaxial test on sand are as Follows: Normal Stress nf = 100 kN/m2 Shear Stress τf = 40 kN/m2 Required: a) Determine the angle of internal friction and angle of failure plane b) Find the major and minor principle stresses (1 , 3 )
A specimen of saturated sand was consolidated under an all-around pressure of 105kN/m2.The axial stress was then increased and drainage was prevented.The specimen failed when the axial deviator stress reached 70 KN/m2.The pore water pressure at failure was 50 KN/m2.Determine:i. Consolidated-undrained angle of shearing resistance, ɸii. Drained friction angle, ɸ′iii. Sketch Mohr’s circles and Failure Envelops in terms of total and effective stress.iv. Assuming soil specimen to be homogenous, sketch a network of failure planes.
For a given consolidated clay: Gs= 2.71; LL= 45; In situ average effective overburden pressure = 120 kPa; In situ void ratio= 0.80 ; Thickness of clay layer = 4m ; average increase of effective stress on clay layer= 40 kPa; Effective pressure at the mid-height of clay layer= 60 kPa; Swell Index (Cs)= 1/5 Cc. Compute the pre-consolidation pressure in kPa. Show free body diagram a.92.9 b.100.5 c.49 d.87.64