Find the Centroid with respect to the origin shown

Q: P3.4 The condensing and evaporating temperatures of a standard vapor compression cycle using R134a…

A:

Q: Saturated steam at standard atmospheric pressure is injected into a passing air stream in an amount…

A: Given data: DBT=21°Cabsolute humidity from 0.0057 to 0.0143 Kgwater vapour/kg dry air

Q: A leaf spring of semi-elliptical type has 11 plates each 9 cm wide and 1.5 cm thick. The length of…

A: given : n = 11 b = 9 cm = 90 mm t = 1.5 cm = 15 mm L = 1.5 m = 1500 mm σ = 650 MN/m2 = 650 N/mm2 F =…

Q: A crate of 67 kg simply stands on the moving cart with constant acceleration a. The height from the…

A:

Q: 1. Solve the following initial value problems, and determine the natural frequency, amplitude and…

A: Given

Q: The apparatus sketched in the figure below serves as a viscometer i.e. it can be used to measure the…

A: Given Data: The apparatus sketched in the figure below serves as a viscometer i.e. it can be used to…

Q: Find Rotation matrix from base to End-Effector of the manipulator shown in Fig.1 below. Find…

A: Given: To find: Rotation matrix Displacement vectors Homogenous transformation matrix

Q: The system is made up of the 1-m, 6.4-kg uniform rod AB and the two uniform disks (each of 0.14 m…

A: Write the given data. LAB=1 mmAB=6.4 kgθ=60°rA=rB=0.14 mmA=mB=2.1 kgg=9.81 m/s2

Q: (2/149) A jet plane flying at a constant speed u at an alti- tude h = 10 km is being tracked by…

A:

Q: The motion of a particle is defined by the parametric equations ax =0.8t, ay =2–0.3t, az =5 where…

A:

Q: Pipe (2) is supported by a pin at bracket C and by tie rod (1). The structure supports a load P at…

A:

Q: 2. Use only the MD below to solve this Item; use it by plotting data and process to determine items…

A:

Q: For each of the following - choose the best response. Coarser structure Less expensive Traditional…

A: Ceramic: A ceramic is basically Nonmetallic and Inorganic material. These are formed by the mixing…

Q: The specific weight of the cone and scoop of ice cream are Ycone 10.0 lb/ft³ and Yice cream= 45.0…

A: Givenγcone=10 lb/ft3γice cream=45 lb/ft3

Q: Dimension this object.

A: Find Provide the dimension of the given project.

Q: A 0.5m³ rigid tank containing hydrogen at 20°C and 600 kPa is connected by a valve to another 0.5m³…

A: given : VA = 0.5 m3 TA = 20⁰C = 293 K PA = 600 kPa   VB = 0.5 m3 TB = 30 ⁰C = 303 K PB = 150 kPa…

Q: In detail what are water fog systems

A: Water fog is the process in which water is made in the form of fine spray of water droplets. This…

Q: free hand sketch the isometric view, choose the appropiate scale. given: front and right view.

A: Given Front and right view

Q: A thin plate is shown below and it is composed of a square plate which has a mass of 102 kg and a…

A: Given question is related to mechanics.   Given data:   Mass of square plate = Ms = 102 kg Mass of…

Q: Learning Goal: To understand and apply the formula T = Ia to rigid objects rotating about a fixed…

A: Given data:- Mass of object at left side= m1 Mass of object at right side =m2 Mass of the bar =mbar…

Q: In detail describe and discuss gearless traction elevators

A: Gearless Traction elevators: The gearless traction elevators are described by the given parameters,…

Q: Multiple forces distributed loads and concentrated loads are acting on a 10m length simple beam…

A:

Q: Air from a line at 12 MPa, 15 deg. Celsius, flows into a 500 L rigid tank that initially contained…

A:

Q: Β • 0.5 m ω, α

A: Given system,

Q: Pressure of a gas changes from 20 to 120psia according to the relation P = aV + b, where a = 5.2…

A:

Q: Determine the weight of block B for the 250N block A not to slide down in the inclined plane. Given…

A:

Q: F = 15 N If the rod of negligible mass is subjected to a couple moment of M=24t2 N;M where t is the…

A:

Q: point. B Ө A 0.5 m 0, α

A: Given system,

Q: The 213-kg wheel has a radius of gyration about its center O of ko = 240 mm, and radius r = 0.4 m.…

A:

Q: A 3 kN/m -6 m- Prob. 7-51 10 kN B

A:

Q: SAE 50W oil at 20°C flows from one tank to another through a tube 220 cm long and 5 cm in diameter.…

A:

Q: 1. A. Using the Steam Tables, determine the amount of cooling water needed by a condenser in kg/sec…

A:

Q: 9) Draw the shear force and bending moment diagrams. A 8 kN/m 1.5 m- 1.5 m 6 kN

A:

Q: Let the pressure gradient in the pipe be 1500 Pa/m and the diameter of the pipe be 4.0 mm. What is…

A: Given : dP/L = 1500 pa/m d = 4 mm = 0.004 m

Q: The uniform 71-kg slender bar is initially at rest on a smooth horizontal plane when the forces are…

A:

Q: The rigid bar of negligible weight is supported as shown in the figure. If W = 80 kN, compute the…

A:

Q: write Natural gas manufacturing process flow diagram

A:

Q: 5. A four stroke gas engine develops 4.2 kW at 180 r.p.m. and at full load. Assuming the follow- ing…

A:

Q: PQRS is a four bar chain with link PS fixed. The length of the links are PQ = 62.5 mm, QR = 175 mm,…

A:

Q: A flat plate of 10ft span and 6 ft chord is placed in an airstream of 100mph under SSLC. If the…

A:

Q: (A) Two buses start at the same time towards each other from terminals A and B, 8 km apart. The time…

A: (A) given : for Bus-x : ( A to B) tₓ = 8 minutes = 8*60 sec   for Bus-y : ( B to A) ty = 10 minutes…

Q: 4. A sine wave has a frequency of 50 kHz. How many cycles does it complete in 10 ms?

A:

Q: What Law can be verified using the Force Table experiment? 1-Newton's 2nd Law of motion 2-Newton's…

A: The force table method is used to determine the equilibrant forces of one or more known forces and…

Q: ▶2/211 Abatter hits the baseball A with an initial velocity of vo = 30 m/s directly toward fielder B…

A:

Q: On October 9,1992, a 27-pound meteorite struck a car in Peekskill,NY,creating a dent about 22cm…

A: Given data as per the question Mass =27 pounds Depth of dent =22 cm Initial speed of the meteorite =…

Q: 4. Considering the state of stress at a certain location of a structure, as shown in Figure 4, a)…

A: Note - As per our company guidelines we are allowed to answer only the first 3 sub-parts. Kindly…

Q: For the mechanism in the image below, the end A of the bar is moving downward along the slotted…

A:

Q: If the large ring, small ring and each of the spokes weigh 95 lb, 12 lb, and 22 lb, respectively,…

A:

Q: It has been suggested that refrigerant R-134 be used instead of water for a new type of thermal…

A:

Q: In verse Find Graphical Kinematics method, of the Robot using

A:

Center of Gravity and Centroid

The term center of gravity indicates the position or location of a point about which the whole weight of a body or system is supposed to be concentrated, which means the whole weight of the body or system works through this point. It is closely related to mass distribution. For all positions of the body, the center of gravity would be a single point.