Find the charge on the capacitor in an LRC-series circuit when L n, R-10 0,C-0.01, Et) 150 V, e(0) - 1C, and K0) -0Ao(t) -What is the charge on the capacitor after a long time?Nood Help?Raat

Given:- LCR series circuit L=12hR=10 ΩC= 0.01 F Et=150 V q0=1 C i0=0 A Find:- What is the charge…

Answered: Find the charge on the capacitor in an…

Find the charge on the capacitor in an LRC-series circuit when L , R-100, c-0.01 et - 150 V, ec0) =1C, and Ko)-0A What is the charge on the capacitor after a long time

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 37P: The resonant frequency of RLC series circuits is 2.0103Hz , If the self-inductance in the circuit is...

See similar textbooks

Related questions

Q: A series RLC circuit has a 200 kHz resonance frequency. What is the resonance frequency if the…

Q: A capacitor is connected across the terminals of a (1.600x10^2)-V rms, 69-Hz generator. For what…

Q: What is the phase difference between the current and voltage in a RLC series circuit with a 469 Ohm…

A: Given: The capacitance of the circuit is 64 microFarad. The resistance of the circuit is 469 Ohm.…

Q: Calculate the impedance and admittance of the Branch AB and CD of the circuit shown in Figure 6.…

A: When the steady current flows through the circuit, the resistance gives the measure of the…

Q: For the circuit of , what is the resonance frequency in 10 Ω (10 V)cosot 1.0 mH 1.0 μF

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: An RLC circuit has R= 460 ohms, the L= 0.340 henrys, Part A and C = 2.00x102 microfarads. What…

Q: An RLC series circuit has a 2.25 Ω resistor, a 95 μH inductor, and a 77.5 μF capacitor. a) Find the…

A: Note: As per rules of Bartleby, only first three parts, (a), (b) and (c) would be solved here.…

Q: AC sine wave

Q: The partial phasor diagram (not to scale) in the picture represents a series RLC circuit with…

A: From the phasor diagram, the angle between voltage and current is Maximum value of voltage supplied…

Q: An 19.0-µF capacitor is connected across an AC source with Vmax = 80.0 V oscillating at 45.0 Hz.…

A: C = 19μF Vmax = 80 V f = 45 Hz

Q: In a certain series RLC circuit, I rms = 9.00 A, ΔV rms = 180 V, and the current leads the voltage…

A: Given Irms = 9. 00 A Vrms = 180 V Phase difference = 370

Q: Suppose you have a number of capacitors. Each is identical to the capacitor that is already in a…

A: Given resistor, inductor and capacitor are connected in series resistance of resistor = R inductance…

Q: When the phase difference is negative in an R.L.C. series circuit then O a. Voltage lags Ob. phase…

A: Required : When the phase difference is negative .

Q: A 120-V ,60Hz power source is connected across an 800ohms noninductive resistance and an unknown…

Q: Phasors and alternating current. A 200 resistor is connected in series with a 4.00 µF capacitor and…

A: Given, v_{A} = (5.00V) cos [(800rad / s) * t] Capacitance=4.00 µF

Q: Q4. A resistor of resistance 7 ohm is connected in series with a capacitor of capacitance 50 micro F…

Q: A series RLC circuit has a resistance of 37.0 N and an impedance of 67.0 N. What average power is…

Q: You have a resistor of resistance 200 2 and a Construct the phasor diagram. 6.00-µF capacitor.…

Q: Find (a) resistance of resistor R from impedance? (b) rms current (I rms) through the entire…

A: we know that the total impedance of the RL circuit which is given by Z = R2 + (ωL)2 where R =…

Q: AL-C-R circuit as shown in figure is connected with a source 120 V ms and 50 Hz frequency. 100 Q 50…

Q: (II) A 3.5 kΩ resistor and a 3.0μ F capacitor are connectedin series to an ac source. Calculate the…

A: Given quantities: Resistance (R) = 3.5 kilo ohm capacitance (C) = 3.0 micro Farad Let, the impedance…

Q: A capacitor C is connected in series with a 40 2 resistor across a supply of frequency Problem 14.…

Q: 4. A series RC circuit is connected to a voltage source, Vms 750 mV with series resistance, R = 50 Q…

A: Impedance and phase angle are calculated as below. Also circuit current is given as I= Vrms/Z ,where…

Q: What is the impedance of a series combination of a50-Ω resistor, a 5.0-µF capacitor, and a 10-µF…

A: Given Data: The resistance is, R = 50 Ω. The first capacitance is, C1 = 5 μF. The second…

Q: Question 2 You have a resistor R = 51.0 2, an inductor L= 2.31 mH, and an AC generator. What value…

Q: What is the RMS current in milliamps (mA) in a series circuit with a resistor R= 125 2, a capacitor…

Q: For the series circuit of Fig. 20.50: a. Find the value of X1 for resonance. b. Determine the…

Q: Find the total capacitance of the given circuit. di ian JuF 3uF 2uF 3 volt

A: C1 = C2 = C3 = 3 μF (connected at the top most branch of the circuit) C4 = 2 μF C5 = 3 μF

Q: In an A.C circuit, if the phase difference () is -35°, then it it will be an RL circuit. Select one:…

Q: If the phase difference between voltage and current is -47', then the circuit will be series RL…

A: This statement is False This will be RC circuit because our phase angle is negative (-47⁰) that is…

Q: A circuit contains a light bulb and a capacitor (RC circuit) in series connected to an AC power…

Q: Both 1) A capacitor is charged by a constant current of 4.0 mA for 0.80 s. If the potential…

A: Dear srudent The Capacitance is given by : C = Q/V Where Q= total charge and V= Potential difference…

Q: What is the RMS current in milliamps (mA) in a series circuit with a resistor R = 125 N, a capacitor…

Q: Q.1 When a parallel plate capacitor was connected to a 80Hz AC supply, it was found to have a…

Q: In a series RLC circuit, at resonance, voltage leads the current

A: Given:- In a series RLC circuit, at resonance, voltage leads the current Find:- Select one: True…

Q: 750 mV with series 4 A series RC circuit is connected to a voltage source. V resistance. R = 500 and…

A: We have a series RC circuit with resistance R=50 ohm, Capacitance C=20 uF=20*10-6F which is…

Q: If multiple capacitors are in a series circuit, describe how the total charge can be found. What if…

Q: Consider a series RLC circuit where R = 549 ohms, C = 5.25 μF, and L = 35.0 mH. Determine the…

A: Given: R = 549 ohm C = 5.25 micro farad L = 35 m H V = 48 V

Q: In the circuit shown, if the voltage measured across the resistor is 3 Vrms and the voltage across…

A: Given: The voltage across the resistor VR=3Vrms The voltage across the capacitor VC=1 Vrms

Q: Two capacitors with C1 = 200 μF and C2 = 850 μF are connected in series. What is the reactance of…

Question

100%

Find the charge on the capacitor in an LRC-series circuit when L n, R-10 0,C-0.01, Et) 150 V, e(0) - 1C, and K0) -0A
o(t) -
What is the charge on the capacitor after a long time?
Nood Help?
Raat

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
The current in the RL circuit shown here increases to 40% of its steady-state value in 2.0 s. What is the time constant of the circuit?
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
Presbycusis is a hearing loss due to age that progressively affects higher frequencies. A hearing aid amplifier is designed to amplify all frequencies equally. To adjust its output for presbycusis, would you put a capacitor in series or parallel with the hearing aid's speaker? Explain.
A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house or car without hearing other unwanted frequencies. How would someone design such a circuit?
In this chapter, most examples and problems involved direct current (DC). DC circuits have the current flowing in one direction, from positive to negative. When the current was changing, it was changed linearly from I=ImaxtoI=+Imax and the voltage changed linearly from V=Vmax to V=+Vmax where Vmax=ImaxR .Suppose a voltage source is placed in series with a resistor of R = 10 that supplied a current that alternated as a sine wave, for example, I(t)=(3.00A)sin(24.00st) . (a) What would a graph of the voltage drop across the resistor V(t) versus time look like? (b) What would a plot of V(t) versus I(t) for one period look like? (Hint: If you are not sure, try plotting V(t) versus I(t) using a spreadsheet.)
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
Apply the loop rule to loops abgefa and cbgedc in Figure 21.47.
Check Your Understanding Circuit breakers in a home are rated in amperes, normally in a range from 10 amps to 30 amps, and are used to protect the residents from harm and their appliances from damage due to large currents. A single 15-amp circuit breaker may be used to protect several outlets in the living room, whereas a single 20-amp circuit breaker may be used to protect the refrigerator in the kitchen. What can you deduce from this about current used by the various appliances?
Check Your Understanding In considering the following schematic and the power supplied and consumed by a circuit, will a voltage source always provide power to the circuit, or can a voltage source consume power?