Find the electric field at P( 6,-3, -4) due to  Q1 = -30uC at (2,3, -6) Group of answer choices a. -576 ax + 863 ay - 1439 az V/m b. -288 ax + 524 ay - 834 az V/m c. -576 ax + 724 ay - 346 az V/m d. 834 ax + 632 ay - 782 az V/m

Q: 7- Simulation tests all the logic a. Gate speed b. Functions c. Tools

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Q3)For the circuit shown below determine the value of current (I) through the resistance R-242 if cu...

A:

Q: What do you understand by the term phase containment of errors? Explain with example.

A: Given: Phase containment of error

Q: 8. The standard measurement data table of a thermocouple is developed when the thermocouple's refere...

A: thermocouple circuit with one end in an ice bath (0°C) and the other in an unknown temperature. This...

Q: Determine if a load (impedance) is capacitive or inductive, given the following 4 cases: a. pf = 0.8...

A: Given: Consider the following cases: a. pf = 0.87, leadingb. pf = 0.42, leadingc. v(t) = 42 cos(ωt) ...

Q: Find the corresponding transfer function G(s) = Vo (s) / Vi (s). %3D 110 kΩ 600 k2 4 µF ",(1) v;(t) ...

A:

Q: 30. If output voltage measurement V, = VA - Vgof the Wheatstone bridge circuit is equal to -0.365 mV...

A:

Q: Q3)For the circuit shown below determine the value of current (I) through the resistance R=2N if cur...

A:

Q: 4. Line Regulation is determined by: a. Load current b. Changes in the load resistance and output vo...

A:

Q: 37. A windmill-powered generator and a battery work together to supply DC power to a light bulb. Cal...

A:

Q: Consider an AWGN channel with bandwidth 50 MHz, received signal power 10 mW, and noise density No (N...

A:

Q: create of your own three problem set and solution for inductors.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 1) What is a Link? 2) Write the task of all layers of OSI reference model? ( 3) What is a LAN? 4) Wh...

A:

Q: 8)Draw the truth table for the gate shown below and write a valid logic expression for it. +SV A.

A:

Q: Three zones of a single-phase circuit are identified in Figure. The zones are connected by transform...

A: per unit system The ratio of actual value to the base or reference value in the same unit is called ...

Q: 34. For the circuit shown, use superposition to find the value of vR1. * R, 6 kQ R, 9 kQ + + V, RI R...

A: Since you have posted the multiple questions so we are supposed to answer first one.  

Q: Two silicon diodes are connected in parallel and in series with resistor 0.33kohms and a battery of ...

A:

Q: What is the function of Positioning and Orientation System (POS – GNSS+IMU) in LiDAR system, when th...

A: The main function of positioning and orientation ( POS ) system is to determine the position and ori...

Q: Using a constant 4.5 V source, three bulbs, wires, and a double throw switch design a circuit that w...

A:

Q: Draw the block diagram for a common bus system for 16 registers of 32 bits each. The bus is construc...

A: Multiplexer It is a data selector. It has many inputs and one output.

Q: The yearly load duration curve of a certain power station can be approximated as straight line; the ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: If a full-wave bridge circuit is used with a transformer whose secondary provides 50 V rms, the PIV ...

A:

Q: O) For the following CT signal, determine whether it is periodic or aperiodic. If periodic, find the...

A: Given X(t) = 2cos(6πt)+3sin(4πt+(π)/(3))+cos(8πt) Determine whether X(t) is periodic or not, Determi...

Q: Fig. 4.85. 30 Ω 10 Ω 20 Ω Vx 90 V 60 Ω () 6 A 30 Ω 40 V Figure 4.85 +,

A:

Q: A. Find the resistance Thevenin and the resistance Norton. B. Find the Voltage Thevenin and the Curr...

A:

Q: When testing the twisted pair cable through cable tester, if the LED lights are jumping back and for...

A: Cable Tester- Cable tester is a device which is used to test a cable. Cable tester detects the fault...

Q: A sine wave voltage has peak value of 110Vp. For one cycle, what is the instantaneous voltage v at t...

A:

Q: A noise signal having a power 0.12 pW is amplified by a circuit which has a gain of 100 and a noise ...

A:

Q: 2. The voltage measuring function V = f(V,) that is implemented by a differential op-amp circuit in ...

A: Operational Amplifier   A three-terminal device consists of two high impedance (Inverting and Non-in...

Q: Why op-amp integrator output is linear?

A: The solution is given below 

Q: Q3)For the circuit shown below determine the value of current (I) through the resistance R=212 if cu...

A: In this question Find the current I as shown in the circuit?  If current in OA branch is zero.  We k...

Q: A 20 KVA transformer has a maximum efficiency of 98% when delivering three quarter load at 1.0 pf. D...

A: In this question, We need to determine All-day efficiency of the transformer If 20 KVA transformer I...

Q: 25 V 5i, 342

A: We need to find out node voltage for given circuit

Q: Given: Common-Emitter Voltage-Divider Swamped Amplifier Configuration. +10 V Re 3.3 kО R 33 kN 1 µF ...

A: This is a basic problem of BJT The solution is given below

Q: 1. Determine if the CF bit of the Status Register is set or reset given the following addition X+Y: ...

A:

Q: copper wire of 2mm diameter with conductivity of 5.8*10 7 S/m and electron mobility of 0.00032m 2 / ...

A: We need to find out charge density , current density and current and drift velocity for given Copper...

Q: V2 6.0kO V1 30Vpk 50H2 VT 1.Solve IT V1 V2 VT 2.lL and Ir in Polar Form

A:

Q: Calculate the current flowing through the 2.2k Q, 6.3M Q and 125 O resistor when supply voltage is (...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: The output noise of the resistor is amplified by a noiseless amplifier having a bandwidth of 16 kHz ...

A:

Q: Three impedances Za = 4 - j3 ohms, Zc = 4 + j4 ohms and Zr = 3 +j ohms are connected in parallel. So...

A:

Q: 2. A balanced, three phase circuit is characterized as follows: a. Wye – Delta connected b. Source i...

A: As the given system is balanced so we can convert three phase system to single phase equivalent circ...

Q: 4. Given vectors T = 2ax - 6ay + 3az and S = ax + 2ay + az, find: (a) the scalar projection of T on ...

A: (a) The scalar projection of T on S is given as: Projection=T.SS=2-12+312+22+12=-76 (b) The vector p...

Q: 8. Check whether given vector is Irrorational or not? xax + yay + zaz A = (x² + y² + z?)½

A: To check whether a given vector is irrotational or not we will find its curl. If the curl comes out ...

Q: edefine the avuage 4. How do f an ACO wavefloum.? Determine the aaverage value of a full "sectified ...

A: Rectifier: This is an electrical circuit that converts ac into dc. This is used where dc input is re...

Q: E. Prove the following Boolean equation using Boolean algebra: a. ABC + ABC + ABC + ABC + C = 1 b. A...

A:

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH inductance. The co...

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: Date: . For the network of Figure 4, determine: a. VB 12 V b. VC c. VE d. IE 5.6 kf2 e. IB f. IC g. ...

A:

Q: ed at each step. C'F +F(A+B')+C = C +

A: Here we will some fundamental law like commutative and distributive law

Q: 37. A windmill-powered generator and a battery work together to supply DC power to a light bulb. Cal...

A:

Q: Describe the process for controlling maintenance requests. Should all requests be handled in the sam...

A: Maintenance is a basic part of every system or any operational thing because they need maintenance p...

Polar and exponential representation

Since the polar representation of a point is based on a triangular form, we can use the simple geometry of the triangle and especially the trigonometry and Pythagoras theorem of the triangle to determine both size and complex number angles. As we recall in school, trigonometry refers to the relationship between sides and triangular angles so that we can define relationships between sides.