Answered: Find the ratio of population in the…

Find the ratio of population in the higher energy state with respect to that in the lower energy state for a He-Ne laser that produces light of wavelength 6328 Angstorm at 37° C.

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter6: Photons And Matter Waves

Section: Chapter Questions

Problem 40CQ: Speculate as to how the diffraction patterns of a typical crystal would be affected if -rays were...

See similar textbooks

Related questions

Q: For red light of λ = 660 nm , what are f, ω , and k?

A: The frequency is, f=vλ =3×108 m/s660×10-9 m =4.545 Hz

Q: O Find the maximum frequency of X-rays produced by 30 kV electrons.

Q: In the Davisson-Germer experiment using a nickel crystal, a second-order beam is observed at an…

A: GIVEN: θ=55°m n=2 (for second order) d=0.91A∘ (Nickel lattice spacing) Bragg's Law: It is used to…

Q: A light-emitting diode made of a semiconductor material with a refractive index of 3.77 that emits…

A: If angle of incidence is greater than critical angle then total internal reflection takes place.

Q: Find the typical de Broglie wavelength associated with a He atom in helium gas at room temperature…

Q: In the electric effect, the work function of the any metal independent on the light Intensity ylgn…

A: Work function is the energy an electron needs to have in order to leave the surface of the metal. it…

Q: What minimum frequency of light is needed to ejectelectrons from a metal whose work function is 4.8…

A: work function, W = 4.8 x10-19 J

Q: Light hes of angular freguency J Calculete the linear fregueney. rad 6000 T an ss Calculate the…

Q: If a metal surface has a work function of 3 eV, find the largest wavelength of light which will…

A: work function(W)=3 eV 1eV=1.6 x 10-19 J W=3 x 1.6 x 10-19 J=4.8 x 10-19 J Formula for work function…

Q: If a light ray strikes a smooth surface with an angle of 30 degrees to normal, what will the…

Q: Estimate the angular spread of a laser beam due todiffraction if the beam emerges through a…

A: The wavelength of laser λ=694 nm=694×10-9 m The diameter of the mirror d=3 mm=3×10-3 m The angular…

Q: A laser has an effective output aperture diameter of 1.6 mm at 488 nm. Find the beam divergence

A: Given value--- diameter = 1.6 mm. wavelength = 488 nm. We have to find--- beam divergence?

Q: Not all metals are the same. If a beam of light produces electrons when shown on a block of cesium,…

Q: Find the wave number of photon having an energy 2.09 eV.

Q: Does the Ray band towards or sway from the outgoing side of the surface normal?

A: Refraction of light occurs when it passes from one medium to another medium .

Q: Find the wave length of the of the electromagnetic radiation, which emitted, when a photon of energy…

Q: What is the work function of the metal light of wavelength 4000 Å generates

A: Givenλ=4000 Ao=4000×10-10 mve=6×105 m/sme=9×10-31 Kgc=3×108 m/sh=6.626×10-34 Jsqe=1.6×10-19 JeV-1

Q: Find maximum frequency and minimum wavelength of X-ray radiation, if the potentialdifference between…

A: The required maximum frequency is,

Q: A student is using a 100 lasers that he bought from e-bay. If each source produces a wave of…

Q: Ql- A Nd:YAG rod, 6 mm in diameter, 7.5 cm long, with 1 atom.% Nd, is cw pumped by a high pressure…

Q: In an argon laser, find the energy difference between the two levels involved in the production of…

A: Given data: λ=514.5 nm Need to determine the energy difference between two levels involved in the…

Q: Show that the hydrostatic equation and gradient Richardson number are dimentionless.

A: The hydrostatic equation is Here, P is the pressure, is the specific weight, z is the elevation…

Q: Qy whet is the expectal ian value of findwg aplatan of the photonicstete 147=3 IV> + H> in ver ticl…

A: |ψ>=13|V>+23|H> probability of finding photon in vertical polarization or in state |V>…

Q: Given the Dispersion relation n=1+2pi*(B/wavelength) where B is 10nm, find the group and phase…

Q: Calculate the occupancy ratio between two power levels in a laser that generates a beam of light…

Q: A CO2 laser produces a cylindrical beam of light with a diameter of 0.850 cm. The energy is pulsed,…

A: Given data: Diameter of cylindrical beam (d) = 0.850 cm Time (t) = 2.00 Ns = 2.00 × 10-9 s Total…

Q: A CdTe planar wafer has an absorption coefficient of 3.2 × 10^4??−1for light of wavelength 530 nm…

A: Given Coefficient of absorption for 530 nm wavelength of light is (α) = 3.2 × 104 let thickness of…

Q: Is it necessary to have at least three energy levels in a laser material? If that's the case, why or…

Q: Calculate the coherence length for CO2 laser whose line width is 10-5 nm at IR emission wavelength…

A: (given) Line width of CO2 laser = 10-5 nm = 10-5×10-9 m =10-14m Emission wavelength = 10.6 μm =…

Q: Find the ratio of population of higher energy state to lower energy state when the optical pumping…

A: The ratio of population of higher energy (E2) state to lower energy state (E2) at temperature T is…

Q: A Q-Switched Nd:YAG laser with a wavelength of 1064 nm. Its active medium is a cylindrical solid of…

Q: Discuss the interference pattern of two separate but identical laser sources?

A: Laser sources release photons & beam coming from each of laser source can pass through a…

Q: Assume hydrogen atoms in a gas are initially in theirground state. If free electrons with kinetic…

A: Given, Kinetic energy, E=12.75 eV.

Q: Compute for the following wavelength of the following frequency: 5. 50Hz

A: The frequency of the sound wave is f = 50 Hz The wavelength of a wave is given by λ = vf, where v =…

Q: Calculate the separation (Hz) between two consecutive modes of LASER with cavity length L = 10 cm.…

A: Given Cavity length L=10cmRefractive index=R.I =1

Q: For laser action, the lasing atom must have at least three energy levels. Why?

A: Electrons in the atoms of the lasing material normally reside in a steady state lower energy level.…

Q: A laser pulse of energy 4 mJ and the pulse duration 1.5 ns is focused on a target of radius 0.02 mm.…

A: The expression for find laser intensity is I=PA=Etπr2=Etπr2

Q: Calculate vakio of Fmal to imidial if 12 dB? Can Xeduce intersity of level to eas plag Wave

Q: A 15.0 mV helium-neon laser emits a uniform beam of circular cross section with a diameter of 2.0…

A: It is given that

Q: What is the work function for the metal (in eV), if the maximum wavelength of light to produce…

Q: The characteristic K, and K, lines for titanium have wavelengths of 0.275 nm and 0.251 nm,…

A: The answer to the given problem is as follows.

Q: Determine the backscattering energy loss factor (S) for the case of nonnormal incidence: incident…

A: Backscattering (or backscatter) is the reflection of waves, particles, or signals back to the…

Q: A laser whose wavelength is 1.06 µm has an effective output aperture diameter of 1.65 mm. Where are…

Q: Show that for those waves whose angular frequency o and wave number k obey the dispersion relation…

Q: late the coherence length for CO2 laser whose line width is 10^−5nm at IR emission

A: Given: Line width =10-5 nm Wavelength, λ=10.6 μm

Q: Calculate the separation of the longitudinal modes of a GaAs laser, when the length of the laser is…

Concept explainers

Blackbody

Q.5 A blackbody radiates how much energy when the temperature of the body is elevated?

Question

Find the ratio of population in the higher energy state with respect to that in the lower energy state for a He-Ne laser that produces light of wavelength 6328 Angstorm at 37° C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For a He-Ne laser at 1 m and 2 m distances from the laser the output beam spot diameters are 4mm and 6mm respectively, calculate the divergence and explain?
In ATR-FTIR, the refractive index of the crystal used must be significantly lesser than that of the sample. True False
It is stated without proof with respect to Bragg’s law that when the atoms are not sym- metrically disposed to the incident and reflected beams (Fig. 8.3(b)), the path difference (AB + BC) = 2dhkl sin θ . Prove, using very simple geometry, that this is indeed the case.
Potassium chloride is a crystal with lattice spacing of 0.314 nm. Thethird peak for Bragg diffraction occurs at 39o. What energy x-rayswere diffracted?
At 293 K, the Bragg angle for X-ray peak (111) from a powdered gold metal specimen is 38.30o. If the same peak is detected at 493 K, calculate the angle. Assume gold metal has a coefficient of linear thermal expansion of 14.2 x10-6 K-1 and a length of 0.47 nm for its standard FCC unit cell.
X-rays with wavelengths of 128 pm was used to study a crystal which produced a reflection of 15.8 degrees. Assuming first order diffraction (n = 1), what is the distance between the planes of atoms (d)?
Compute the wavelength of scattered photon, wavelength 22x10^-12 m, scattered photon 201o ?
An APD has a quantum efficiency of 50% at a wavelength of 500 nm in the absence of multiplication. If the device is operated with a reverse bias to give a multiplication factor of 8. Calculate: a. responsivity. b. the photocurrent of the APD if the incident optical power is 4 μW.
A mode-locked laser has a linewidth of 100nm at a center wavelength 1050nm. Assume the pulse shape is hyberbolic secant and it is transform limited. What is the pulse width (in fs)? (round all answers to 1 sig. fig. after decimal point) a.116.0 b.11.6 c.5.8 d.58.0 e.100.0
A CO2 laser produces a cylindrical beam of light with a diameter of 0.850 cm. The energy is pulsed, lasting for 2.00 ns, and each burst contains an energy of 200 mJ. What is the length L of each pulse of laser light? What is the average energy per unit volume u(avg) for each pulse?
A CdTe planar wafer has an absorption coefficient of 3.2 × 10^4??−1for light ofwavelength 530 nm Determine the minimum thickness the CdTe wafer has to be for 95% of this wavelength to beabsorbed.
Assume hydrogen atoms in a gas are initially in theirground state. If free electrons with kinetic energy 12.75 eVcollide with these atoms, what photon wavelengths will beemitted by the gas?