Answered: Find the sum of all numerical…

Engineering

Electrical Engineering

Find the sum of all numerical coefficient of the expansion (a+b)6 a. 86 c. 82 b. 76 d. 64

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: The spectrum of the sampled signal may be obtained without overlapping only if a. fs > 2fm b. fs fm…

Q: 4. Derive the formula for the output of an OpAmp integrator.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is…

A: Given: 10 A current lagging the voltage by 470 and 12 A current lagging the voltage by 580. We have…

Q: Find the inverse z-transform of, 1 X(z) = 1-1.52¹ +0.52-2 ROC : [2] > 1.

Q: Theoretically, calculate all the currents and the voltages for the circuit shown in Figure 11

A: In this question, We need to determine the current and voltage across the elements. We are solving…

Q: 2. Calculate voltage drop across the 2 2 resistor for the circuit shown below using nodal analysis.…

A: Given here a electrical circuit and asked to find the voltage across the 2 ohms resistor.

Q: V1 AV (CL) 99 O1000 il The above op-amp acts in a non ideal manner such that R2 R₁ 100 R1 0999 = 1…

Q: Plot the unit step response for each of the two systems below: G1 = G2 = s +3 (s + 2)(s² + 3s + 10)…

A: The required transient parameter can be analyzed with the help of predefined MATLAB functions. The…

Q: An IC amplifier requires a circuit that acts as high-resistance source for driving low-impedance…

A: Given: An IC amplifier requires a circuit that acts as a high-resistance source for driving…

Q: escribe TWO (2) types of basic building blocks used in the realization of digital systems with…

A: The digital circuit realization techniques involve expressing the logical function of the circuit…

Q: The following are alphanumeric codes except: (A) EBCDIC (B) Hollerith C Gray code (D) ASCII

A: EBCDIC It is extended binary coded decimal interchange code which will be used for alphabet code…

Q: What Is programmable logic arrays?

A: Given: Programmable logic arrays: Programmable logic arrays are used in digital circuits. It is a…

Q: Calculate the steps in a 4 section rotor resistance starter for a 3-phase slipring induction motor…

Q: In an experiment for measuring the power and power factor in three phase load using one Wattmeter…

A: Given, Power is measure in a three phase load using one wattmeter method. The load is balanced.…

Q: Determine the power of the following digital sequence: x(n)=u(n)

Q: A 330 kV power system contains three substations A, B and C having fault levels of 20 GVA each. The…

A: Given data, Voltage V= 330 kV Power P=20 GVA =20×103 kVA Given circuit,

Q: The difference equation is: - y(n) - 0.4y(n-1) + 0.29y(n − 2) = x(n) +0.5x(n-1) - a. Find the…

A: Given Difference equation : y(n)-0.4y(n-1)+0.29y(n-2)=x(n)+0.5x(n-1)

Q: In the circuit below, what is the reading of the voltmeter (round off to the nearest whole number)?…

Q: Determine the total amount of power in the series circuit in Fig. 5Ω 50 V 2Ω www I + I 192 2Ω

A: Given data, Circuit diagram is given as,

Q: What is the function of MCB? Write two advantages and disadvantages of MCB?

Q: An n-type Ge Sample has a donor density of 10m. It is arranged in a Hall experiment having magnetic…

A: Given: Density, n=1021m3 Magnetic field, B=0.5T Current density, J=500 A/m2 Width, L=3mm

Q: Compute the convolution y[n] = x[n] * h[n] of the following pairs of signals: a) x[n] = a¹u[n], h[n]…

A: Given, a x[n]=αnu[n]h[n]=βnu[n], α≠βb x[n]=h[n]=αnu[n]c x[n]=-12nu[n-4]h[n]=4nu[2-n]

Q: 3. A 3-phase 80 km long single circuit 66 kV transposed overhead line has horizontal spacing with 5…

Q: 1. A 2000/200V, 20kVA transformer has 66 turns in the secondary. Calculate: (a) Primary turns (b)…

A: Given a 2000/200V , 20kVA transformer has 66 turns in the secondary .Here we have to find the…

Q: A) Find the equivalent resistance of the combination shown in the figure Req Ω

A: Given data, Circuit diagram is given as,

Q: 3. For the AC network shown in Figure 3, the source voltage is 120V (RMS). 4Q2 j6Q ww a) 120/10° V…

A: Given:

Q: The current in a 120 V reading lamp is 2.6 A. You may want to review (Page 739). Y Part A If the…

A: Given data, In a reading lamp, Current I=2.6 A Voltage V=120 V Cost of electricity $0.075 /kWh Time…

Q: 7. An AC circuit has an RMS voltage of 100 volts, RMS current of 20 amps, and a power factor…

A: Given, An AC circuit has Vrms=100 VIrms=20 Aϕ=45°

Q: 4. Suspension string has 3 units. Each unit can with stand a maximum voltage of 11kV. The…

A: Given: Maximum Peak Voltage, V=11kV Number of Insulator Discs, n=3 The capacitance of each joint and…

Q: Two coils, A and B having 1200 and 800 turns respectively are placed near to each other.60 % of flux…

A: Given data: Number of turns in coil A=NA=1200 Turns Number of turns in coil B=NB=800 Turns…

Q: If we want to obtain the QUIESCENT VALUE OF BASE EMITTER VOLTAGE, which analysis type/technique in…

A: With the help of Multisim, we can easily simulate the input and relevant output response of a…

Q: w 1.6 700x find creat 50 WM ww 0.1 son 30V using Norton's Theorem

A: Given here a electrical circuit and asked to find the current in the 50 Ω using norton theorem.here…

Q: What is the current l4 (mA)? VA SR6 15k0 IT R1 RA 1.5k 1kO 12 + V.- 14 +V1- RS R2 Sk0 S10kO R3 E 20…

A: The required parameters can be calculated by calculating the total current in the current and then…

Q: A3-phase, 220 KV, 50 Hz transmission line consists of 1.2 cm radius conductors spaced 2m at The…

Q: a successive approximation a/d converter has a resolution of 20 volts . what is it's digital output…

A: Given: Resolution=20 volts Analog input=2.17 volt

Q: ID= IMQ VDS= VG +90 VDD Given the figure above with the following values: VDD=21, RD=3.30k, IDSS =…

Q: What is the typical value of refractive index for an ethyl alcoh 1 1.36 2.6 3.4

A: The correct option along with the explanation is provided in the following section.

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes.. 1. An insulator 2. An…

A: The correct option along with the explanation is provided in the following section.

Q: It is powered from a grounded Y-balanced three-phase source. The installations have four balanced…

A: Given Four loads Load 1: 150 kVA Y with pf 0.8 (+), Load 2: 100 kW ∆ with pf 1.0, Load 3: 120 kW Y…

Q: B(jo) Determine gain margin and phase margin of the system shown above if the loop gain magnitude…

A: Given: 0

Q: Gauss’s law can tell us how much charge is contained within aGaussian surface. Can it tell us where…

A: Gauss is used to determining the magnitude of the charge within the Gaussian surface. The net…

Q: Standard intermediate frequency used for AM receiver is

A: The correct option along with the explanation is provided in the following section.

Q: can you complete the truth table

Q: An LR circuit has a half-life of 0.230 ms. What is its inductive time constant? The inductive time…

A: Given data, Half life t2=0.230 ms

Q: Use K-map to obtain the minimized sum of products form of the function f (x,y,z,w) = SEGMA…

Q: 3. In the given circuit, the switch is closed for a long time. At t=0, the switch is opened. Find…

Q: A semiconductor is formed by......... bonds. 1. Covalent 2. Electrovalent 3. Co-ordinate 4. None of…

A: The correct option along with the explanation is provided in the following section.

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes ..... ........

A: The correct option along with the explanation is provided in the following section.

Q: Explain the operating principle of an oil circuit breaker with emphasis on the reciprocating pump…

Q: Electrical Machines Numerical Problems 1. A four-pole, lap wound DC machine is having 500 conductors…

Concept explainers

Gradient of a Scalar Field

Consider a room or a place where the temperature is denoted by a scalar field T, such that at each point (x, y, z), the temperature is given as T(x, y, z). It is independent of time, in which the temperature rises most quickly. The gradient of T will show the direction at that point by moving away from (x, y, z). How far will the rise in temperature in that direction be determined by the gradient magnitude? Consider a surface that has a height above sea level at point (x, y) which is given by H(x, y). At that point, pointing in the direction of the steepest slope or grade is the gradient of H. The magnitude of the gradient of the vector gives the steepness of the slope at that point. How a scalar field changes in another direction can be measured by the gradient by taking a dot product rather than just the direction of the greatest change?

Question

Find the sum of all numerical coefficient of the expansion (a+b)⁶a. 86 c. 82
b. 76 d. 64

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC source with ΔVrms = 120 V is connected between points a and d as shown. At what frequency will it deliver a power of 250 W? Explain your answer.
ASAP PLS Compute in Detail and then Draw the Power Triangle.
Calculate the following USING MATLAB: The roots of P1=s^6+7s^5+2s^4+9s^3+10s^2+12s+15
Compute for the Energy and Power of the following signals in terms of per unit use the proper formula whether the signal is continuous or discrete. 2[cos(t) + isin(t)]
For an RC Circuit: a. Using information from the graph, find  b. If R= 6982  , calculate C (use the result from Part (a) c. Show, by dimensional analysis, that  has units of time.
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
1) Given the sinusoids v1(t) = 8cos (250t +15°) V and v2(t) = 6cos (250t – 45°) V, determine the time by which v2(t) is advanced or delayed with respect to v1(t).
Question 5 Use the node-voltage method to find the steady-state expression for v0(t) in the circuit belowif vg1 = 25 sin (400t + 143.15◦)V vg2 = 18.03 cos (400t + 33.69◦)V
A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a resistance of 1050 Ohms, an inductance of 0.06 Henrys, and a capacitance of 0.009 coulombs per volt. - omega for source in rad/s? - omegaR for circuit? -XL? -XC? -phi in radians? -Z? -imax?
Equation: Vt= Vm sin 120π t Solve Vrms and Vaverage
Use current division to find the steady-stateexpression for io in the circuit if ig=400 cos 20,000t mA.
Determine the particular solution by applying initial conditions given