Find the total capacitance in micro farads of the combination of capacitors shown in the figure below. 10 μF 2.5 μF HF 0.30 μF
Q: Solve the collector current of a fixed-bias circuit with Vcc= 10V, RB=310kohms, RC=2.1kohms, and…
A: We need to find out collector current for given fixed bias circuit
Q: following Consider FET is idea
A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…
Q: 5.1 A 0.18-µum fabrication process is specified to have t = 4 nm, μ, = 450 cm²/V-s, and V, = 0.5 V.…
A: MOSFET- MOSFET is a type of field effect transistor. In MOSFET, a silicon oxide thin layer is…
Q: If the waveform of a voltage has a Form Factor of 1.15 and c Peak Factor of 1.5, and if the peak…
A: Given: A voltage waveform with, Form factor = 1.15 Peak factor = 1.5 Peak value, Vm=4.5 kV
Q: PROBLEM NUMBER TWO: For a negative unity feedback system with the given forward transfer function,…
A:
Q: What is the value of Vout? b. What is the voltage gain?
A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…
Q: If you know that the phase crossover frequency is 3.16 (rad/s) for the following transfer function,…
A:
Q: Solve the emitter voltage of a voltage-divider bias circuit with Vcc=9V, R1-560k ohms, R2=560k…
A:
Q: The initial and final values of f(t)=15-10t-10e e-20r are respectively (a) 5 and ∞ (b) 5 and -co (c)…
A: Given function, ft=15-10t-10e-20t
Q: A 30 x 30 x 30 m room is installed with a fan designed to supply air every second. If the losses due…
A: Given,The volume of the room,V=30×30×30 mThe fan supplies air every second.So, t=1sDue to…
Q: A full wave rectifier circuit is given with peak output voltage Vy =15 V, R=10 kN, C= 50 µF, T…
A: For the full-wave rectifier, the ripple voltage is given by the expression as shown below:…
Q: Propose and draw a circuit of a resistive current divider in half
A: Question 1 is answered in step 2 Questions 2 is answered in step 3
Q: Jse superposition to solve for in (t) 20 με 50 cos 2000r V 40 mH 2 sir 4000r A 80 Ω 60 Ω 100 Ω 24 V
A:
Q: 2. Determine Vo #y 201 0 -SY $ 130, UNIVER +
A:
Q: Given a D-MOSFET circuit used as an amplifier with the following parameters: IDSS=12mA and a…
A: We need to find out drain to source voltage and output voltage for given circuit
Q: 2) +5√ I&q=0.8 MA ود RB 3 B = 100 RB = 10k₂ a) re b) Bi, Zo, AV, Ais us fore Vo 4k 20 Rc = 4 km
A:
Q: 2. Obtain the symmetrical components of a set of unbalanced currents IA = 1.6 225 le = 1.0 2180 Iç =…
A:
Q: What is the induced voltage Vs in the transformer, if the primary voltage Vp-220 V with number of…
A: Given data, Primary voltage Vp=220 V Number of turns in primary Np=50 Number of turns in secondary…
Q: dy+ay(t) = Skx(t) The steady-state gain of the step response y(t) is 10 and the rise time is 4, what…
A:
Q: The value of the damping ratio (C) of a critically damped Second order system is 0¹ 0-1 0 51
A: Given, The value of the damping ratio ζ of a critically damped second order system is _____.
Q: 1. A 3 phase, overhead transmission line has a total series impedance per phase of 200 ohms and a…
A: The Performance calculations of long transmission lines need is based on various parameters of which…
Q: 10. The primary and secondary winding of a 50 kVA, 6600/220 V transformer have resistance of 7.8 ohm…
A:
Q: For the circuit in Figure 1, i (0) = 2 A, vc (0) = 5V a. Compute v(t) for t>0. 1R i₁ 1 v(t) 150 Ω 10…
A:
Q: Solve for Ic of Figure 42. 3.2 m/ 3.2 UA 4MA 4UA 12 V www -% = 6V --3-80 20130 1B = 40 μA Reference…
A:
Q: 4. A) Reduce the given circuit to the fewest possible components thru series/parallel combinations…
A: Series or parallel circuit: To find the series or parallel combination of the element in the circuit…
Q: Determine the systems stability using the Routh Hurwitz Criterion for Stability. 1. Number of Poles…
A: Routh Hurwitz Criterion When the table is completed, the number of sign changes in the first column…
Q: - ind the charge on the capacitor in an LRC-series circuit at t= 0.02 s when L = 0.05 h, R = 4, C =…
A: Given: Time is 0.02 sec The value of the inductance is L is 0.05 H The value of R is 4 ohm The value…
Q: Show your solutions clearly and systematically. The D latch of Figure 1 is constructed with four…
A: Given The D latch of Figure 1 is constructed with four NAND gates and an inverter. Consider the…
Q: * Q3: the universal circuit are NAND & NOR AND & OR gates None of the above NOT & NOR Nand only NOR…
A: Universal gates are by using these gate alon realaise a complete cirucit or other gate with…
Q: 4- If the base current in npn transistor = 2 mA, and (a) - 0.97, so, the collector current= @ 64.67…
A: Given data, In an npn transistor Base current, IB=2 mA αe=0.97
Q: The two-wattmeter method is used to measure the total power taken by a balanced three-phase load,…
A: This question belongs to circuit theory . It is based on the concept of power measurements by using…
Q: phase bundled transmission line of 200 km length consists of three ACSR conductors as shown.…
A:
Q: 1. Compare the performance in terms of their efficiency the common base, common emitter, and common…
A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: Solve the beta (3) of Figure 611. 328 200 212 R1 680k VCC 18V R2 $3.9KQ Figure 611 Vc - BV
A: We need to find out value of beeta for the given circuit
Q: * Q4: Identity comparator is A: to find equal, greater and less than B: to find equal C: to find not…
A: Option - A is correct answer
Q: Solve the value of collector resistor of an emitter-stabilized bias circuit with cutoff voltage of…
A: We need to find out the collector resistance value for given current and voltage for bjt circuit
Q: Determine the amplitude of the line current in a three-phase system with a line voltage of 207 V…
A:
Q: 3.0 Problems/Task: Task 1 Students are required to do a calculation using nodal analysis and mesh…
A:
Q: A JFET shown in the circuit has the following V(GS(off))=-8V and IDSS-16 mA. (a) Plot the Q point of…
A: The JFET circuit diagram is shown below, Where, VGSoff = -8 VandIDSS =16 mA
Q: An attenuator used in control systems unit is also known as _________? A. Summing amplifier…
A: In the control system attenuator is used to control diminish signals flowing between different…
Q: PROBLEM NUMBER TWO: The closed-loop transfer function of a negative unity feedback system is given…
A: Given: The closed loop transfer function is Ts=s-2s2-K+2s+2K+5
Q: 3.6 Solve for V₁ in the circuit of Fig. 3.55 using nodal analysis. 10 92 www 492 www www 10 V 20 V…
A: This question belongs to circuit theory . It is based on the concept of nodal analysis in the…
Q: 42 cm 16 m 16 m Determine the inductance per meter and the inductive reactance if the size of the…
A:
Q: Discuss the concept of an Electrical fault. How can we prevent such catastrophic incident for such…
A: Electrical Fault in an electrical equipment or apparatus is a kind of imperfection in electrical…
Q: The value of the damping ratio (C) of a critically damped Second order system is 01 0-1 02. 04
A:
Q: 1. a) Compute the capacitance of a parallel-plate capacitor with plates 10 cm by 20 cm and…
A: We are authorized to answer one question at a time since you have not mentioned which one you are…
Q: 10-ohm resistor and 10 H inductor are connected in series across a source of 12 V. If the current is…
A:
Q: Solve the value of supply of a fixed-bias circuit with collector saturation current of 5.71mA, base…
A:
Q: Figure 4 (for numbers 20 to 24) RSIG V₁ Z₁ RG ở VDD ww www RD Rs 70 RL
A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…
Q: Multiple Choice directions: Circle the letter of the answers that best answer the question. 1. For…
A: These are the few questions related to the basic construction details of microwave and it's…
Step by step
Solved in 2 steps with 2 images
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?4. In what form is the energy of a capacitor stored?
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
- You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.How many degrees are the current and voltage out of phase in a pure capacitive circuit?