Find the total resistance of two resistors in series if R1 = 400 Ω and R2 = 800 Ω

Q: Vin RG VG +- +Vcc RL Vout Image from: Electronic Principles by Malvino, Albert and Bates, David J.

A:

Q: "If a receiving antenna has a gain of 26 dB, calculate its effective capture area (m^2) if its…

A: It is given that: GdB=26f=1.7 GHz

Q: Where did the 108 come from on page 4 for the resistance of slab A?

A: Given We need to explain the solving part in slab A resistance.

Q: 1. (10%) For the circuit shown in Figure P4, find the current i. Ο 10 Ω 12 1A (1) ΤΑ www • 20 Ω 351…

A: Given, The circuit diagram,

Q: Problem 2 Find the Thevening and Norton equivalent circuits for the network shown below. 3Ω 50 V Μ +…

A:

Q: A diode has a reverse saturation current of 8 x 10-15 A and an ideality factor of 1. If its DC…

A:

Q: The sum of the following two e.m.fs will be e1 = 10 sin wt and e2 = 10 cos wt O 10 O 20 sin wt O…

A: We need to find out the resultant of two sinusoidal signal

Q: 1. For an energy meter with a constant of 1500 rev/KW, calculate the energy consumed if the disc…

A: Given, An energy meter has, Meter constant, k=1500 rev/KW. Number of revolutions, N=25. Time, t=2.5…

Q: A 20 kW, 150 V separately excited shunt generator produces a generated armature voltage of 165V in…

A: Given that: Output power, P=20 kW Terminal voltage, Vt=150 V Armature voltage, Eg=165 V…

Q: Write out the node-voltage equations and solve for the node voltages.

A: The given circuit diagram is shown below:

Q: f(x)= 1-cos(πx) Draw the continous-time signal.

A: We need to draw the given signal .

Q: Given the following circuit, 24 V +1 20 Ω 40 Ω www 10 Ω 20 Ω 60 Ω 50 Ω Find the equivalent…

A: Given, Supply voltage, VS=24 V

Q: Draw the complete logic diagram from the given logic equation, maximum of 2 inputs per gates used.…

A: The required logic gate can be implemented by part by part and then they can be combined to get the…

Q: What is the DC resistance per phase? What is the effective resistance per phase?

A:

Q: Example: Delta-connected load consists of 10-Ohm resistance in series with 20-mH inductance. Source…

A:

Q: Problem 4.19 (Node-Voltage Method) Find V₁, V₂, V₁.1₁, and the voltage of the dependent source V…

A:

Q: Determine V₁ and V₂ in the circuit 1 2 3 ΚΩ ΓΚΩ www 10 mA Μ 55 ΚΩ 20 ΚΩ

A: In the circuit we are asked to find the voltages V1 , V2 .

Q: V=E₁ V₂-E2 R₁ Vb Vab IRY Va Vb Vab 4.71-22 IRY E₁ lov V₂ G9 22kn Percuter Computed Va R4 EI $lba…

A:

Q: H|HO Circuit #2 1. Set the battery voltage to 12 V, and the value of one resistor to 10 ohms (R₁)…

A: Given, Battery voltage, VB=12 V resistance, R1=10 Ω resistance, R2=20 Ω

Q: The sending end voltage of a 3-phase overhead line with a resistance of 5 per phase and reactance of…

A: Given,Resistance, Rs = 5 ΩReactance, Xs = 20  ΩSending end voltage, Vs = 34 kVReceiving end voltage,…

Q: 2- Design a 4-bit DAC assuming high voltage of 3.5 V and a Vee of 12 V? determine the output voltage…

A:

Q: €1 R1 R2 a R4 I 3 €3 R3 I2 €2 Circuit 4 3. Verify Kirchhoff's loop rule by measuring voltage change…

A:

Q: Given: L1 = 17 mH L2 = 21 mH L3= 0.014 H L4 = 11981 mH L5 = 89 uH LT BO mm ww Calculate the total…

A:

Q: 1) Determine whether or not the following equations are exact.

A: Given here a differential equation and asked to find it is exact or not.

Q: A 20 kW, 150 V separately excited shunt generator produces a generated armature voltage of 165V in…

A:

Q: Determine IC(sat) = VINO- RB www 1.0 ΜΩ for the transistor. What is the value of lg = is necessary…

A: We need to find out saturation collector current and base current and input voltage to get…

Q: For each of the 3 circuits below, draw small signal model and calculate Vout/Vin. M₂h Vout o Vino-…

A:

Q: Solve for the value of the current in square form. Given frequency is 60Hz. 133mH 360 μF 1502 www…

A:

Q: 2. Dertemine Req using delta-wye transformation. Req 10122 5 100. 2012 552 M 1552 25-22

A: We need to determine the Req using wye delta transformation.

Q: 2. Table 1 gives the types and size of various loads that will be connected to a three-phase…

A: Given that there are 20 lamps, 10 one-phase motors , 5 three-phase motors connected as loads to a 3…

Q: Find the number of strands of ACSR conductor for 4 layer transmission line?

A: Given data, no. of layers x= 4 layer

Q: Calculate the current flowing in a 50 mH - inductor if the energy stored in its magnetic field is…

A: We need to find out the current through inductor for given energy

Q: Question: 4 A Silicon specimen placed in a lab at 17°C has an equal electron and hole concentration.…

A: Given: At 17°C, electrons and holes concentration are equal. After doping concentration of holes…

Q: A network containing 50 buses in which 10 are the voltage control buses, 6 are the generator buses.…

A:

Q: 3. Two (2) 30-ohm resistors are connected in series, when a resistor R is connected across one of…

A: We need to find out unknown resistor ,R for given total resistance .

Q: A circuit with a shunt resistor (R_s) and a load (R_L) is shown in the following figure: Assume…

A: Given: Rs=100mΩVs=50 mVV1=5V

Q: E2.7 Find I, and I, in Fig. E2.7.

A: The required parameters can be calculated by using the kirchhoff's current law at the nodes.

Q: Compute the power dissipated on the Resistance on the red box. Given R1 = 15 ohms, and R2 = 30 ohms.…

A: To find the power dissipated in the resistance in the red box

Q: Obtain the value of mesh currents I1 and I2.

A: In this question,  We need to determine the mesh current as shown the circuit.  We are solving this…

Q: The transistor has a BDC of 50. Determine the value of RB required to ensure saturation when VIN is…

A: The given circuit diagram is shown below: It is given that: βDC=50VIN=5 VVCEsat=0 V

Q: An op amp has an input offset voltage of 4.3 mV. It is used in an inverting amplifier whose gain is…

A:

Q: x(t)=2cos(2π150at) 1) What is the frequency of the signal? 2) What is the period of the signal? 3)…

A: Given data, Function is given as, xt=2cos2π150at.

Q: RG C₁ Vin H L ID= VDD=1.8 V RD C₂ HI mA HEM₁ Given: VDD = 1.8 V, RG = 50 kOhm, RD = 2 kOhm, W/L = 20…

A: We need to find out drain current for given circuit , we will use drain current equation to find out…

Q: Compute for the following: Current in alternator B Real power in alternator B Power factor in…

A:

Q: A 50 Q distortionless transmission line has a capacitance of 10-10 F/m. What is the inductance per…

A: Given a distortionless transmission line with, Characteristics impedance, Zo=50 Ω. Capacitance,…

Q: e for the equivalent resistance at points B to E A B 202 W vi 6Q 4Ω www www. D 2Ω E F

A:

Q: Q6. Determine the total amount of power in the series circuit in Fig. 5Ω ww 50 V 2Ω www 192

A: Given data, Circuit diagram is given as,

Q: What is the radiation resistance of a dipole antenna A/20 long approximately equal to?

A: Given, Length, dl=λ20. Radiation resistance of dipole, Rr=?

Q: Bot t = 0 11 mA (1 Solve for M 2 ΚΩ 1 ΚΩ + Uc due (0+). Unit: V/s dt 6.25 H 1 μF +5V

A: We need to find out the rate of change of capacitor voltage for given circuit

Q: Calculate the thermal-equilibrium electron and hole concentrations for compensated p-type silicon at…

A: It is given that: T=300 kNd=2×1010 cm-3Na=5×1010 cm-3

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.