Find the unknown values ΖΩ Μ W 5 V 19 tistes 8 Ω ΤΩ www +3V

Q: 5. The voltage across a coil when di/dt = 20 mA/ us and L = 8 µH is O(A) 16 mV O(B) 160 mV O(C) 1.6…

A: Given a coil with, Rate of change of current, didt=20 mAμs Inductance, L = 8 μH

Q: 2. A 75 22 load uses 2 W of power. The output voltage of the power supply is approximately

A: Given, Load resistance, RL=75 Ω Uses power, P=2 W

Q: G(s) = 1 0.01 s+1

A: The transfer system is,  G(s)=10.01s+1G(s)=1×1000.01s+1×100G(s)=100s+100 The bode plot is determined…

Q: 30-volt, 3-phase, code A, 40°C, 75-horse- 0% power factor with a nameplate full-load

A: Given as, Nameplate full-load current =185A Minimum capacity of the conductor is 125%. Full load…

Q: Find the Fourier series expansion of the backward sawtooth waveform of Fig. 17.48. Obtain the…

A: Given:

Q: P.2-36 Given the vector function A = a, sin (6/2), verify Stokes's theorem over the hemispherical…

A: Given, vector function  A = aϕSinϕ2

Q: K V AZE Vm= 20 V, V = 8 V Determine the maximum output voltage. O -20 V O 12 V O OV O 28 V

A:

Q: Q1// For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…

A:

Q: For an FM modulator with an unmodulated carrier amplitude vc= 20v, a modulation index m=1, and a…

A: Solution- stFM =∑n=-∞∞VcJnm cos2πFc+nWtVc - carrier amplitude;  (given Vc =20V)m - modulation index…

Q: A 0 to 300 V voltmeter has an error of 2% of the full-scale deflection. If the true voltage is 30 V,…

A: Given: % Error at full scale = 2 % Full scale value of the voltage = 300 V True value = 30 V

Q: Please solve the current I1 in the given circuit using Norton's Theorem.

A: Given circuit :

Q: Based on the circuit configuration, determine the following: a) Ceq b) qT c) V₁ d) Vs C1=5*F HE C4 =…

A: Circuit is given as:

Q: Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

A: Given  Return loss = 12 dB we need to determine reflection coefficient and voltage standing wave…

Q: In the context of digital communication, please explain Communication Channel and Noise in detail.

A: Given  we need to enumerate communication channel and noise in detail. Please find the below…

Q: ww ΤΩ V₁ +) 10 V 3ΩΣ 3 8 A Ο 4.0 Ο 2.0 O None of these answer are correct Ο -1.0 0 -4.0 Ο -2.0 4 Α 2…

A: Both problem solve by using simple kvl amd kcl law are given as

Q: Determine the 12 current using Source Transformation ş @ DC (6 amps) 8 ohms 4 ohms 15 6 ohms www 5…

A: The circuit diagram is shown below,

Q: Q11. to obtain NOT gate from NOR, we use A. two NOR gates O D. None of the above OC. one NOR with…

A: To obtain NOT gate from NOR gate  logic gate digram shown as

Q: C(s) Example: _Find the ramp response for a system whose transfer function is G(s) R(S) 1 (s+3)(s+1)

A: given transfer function GS=CSRS=1s+3s+1 . here we have to find the ramp response for the given…

Q: 8. What is the minimum conductor size, overload protection, and inverse-time circuit- breaker rating…

A: Given information about a three-phase synchronous motor is, Supply voltage Vt=230 Volts. Code of the…

Q: By using Gauss-Siedal method, the voltage of the bus 2 after two iteration is Your answer By using…

A: Given,The data of a system are,Ybus=j0.25-0.2-0.05-0.20.225-0.025-0.05-0.0250.075…

Q: 2. The fuel-cost functions for three thermal plants in $/hr are given by C1 = 120+6.6P₁+0.0029P₁² C2…

A:

Q: Instructions Perform the ff. functions: 1. Create the truth table for the Boolean expression F = (A…

A: here we have to create a truth table for the given expression and other is to reduce the k-map.

Q: power induction motor?

A: Given as, Voltage, V= 600-volt, Power, P=50 hp=50×746 W, Lets take, cos ∅=0.8.

Q: Create the logic circuit diagram for z F= X’Y + XZ’

A:

Q: III-a) A steady voltage of -1.25V is applied to an op amp integrator having component values of…

A:

Q: Example: Determine armature torque and motor speed of 220V, 4-pole series motor with 800 conductors…

A: In this question,  We need to determine the speed of the motor and torque T?    We know  Torque T=…

Q: 8 ohms 6A 4 ohms 6 ohms www I1 5 volts www 2 ohms #H 10 volts 1 ohm #₁ 15 volts 3 ohms 5 ohms 9 ohms…

A:

Q: Using the oscillogram of a periodic sequence of rectangular video pulses u(t) shown in the figure,…

A: Option:d) is correct  Because the explanation as shown below.

Q: There are many different matching techniques. What are important factors required to select a…

A: Thre are different matching techniques however they all have certain important factors required to…

Q: on to test the stability of the system with the following characteristic equation: ch. eq.=…

A: We need to check whether the given system is stable or unstable .

Q: Based on the circuit configuration, determine the following: a) Ceq b) qT c) V₁ d) Vs Ĵ C1=5*F HE C4…

A: given here a capacitive circuit and asked to find the equivalent capacitance, total charge, voltage…

Q: 41. Review. The heating element of an electric coffee maker operates at 120 V and carries a current…

A: Given, The heating element of a coffee maker operates at 120V and carries a current of 2.00A water…

Q: 6. Explain double revolving field theory.

A:

Q: In figure 2, determine the range of Vi with VL maintain at 8.2 volts.

A: Diode : A diode is an electrical component that permits electricity to flow in just one direction. A…

Q: 1. What is the full-load current of a 500-volt, DC, 20-horsepower motor?

A: In this question,  We need to determine the full load current?  If power P= 20hp 1hp= 746W Voltage…

Q: Apply the Shockley's equation and draw the transfer characteristics of the JFET in he circuit shown…

A: Given data is IDss=10mA, VP=-10V The given figure is shown below.

Q: Write an exhaustive VHDL code and a testbench code for the encoder shown below with suitable assert.…

A: ENCODER : Encoders are Combinational circuits that convert binary information into N output lines.…

Q: Q2) Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

A: Given  We need to define return loss and reflection coefficient. For the given return loss we need…

Q: QB: Obtain the transfer function of system defined by the following state space equations: 0 4 8 8…

A: given here state space equations and asked to find the transfer function.

Q: The instantaneous voltage and current for the network in series having a voltage and current…

A:

Q: Example plot the polar plot- G(s) = 100 (5+2) (5+4) (5+8)

A:

Q: 2. Use superposition to solve for io(t) 20 μF 50 cos 20001 V 40 mH 2 sin 40001 A 80 52 60 Ω 100 £2…

A: given here electrical circuit and asked to find current i0.

Q: Consider the following linear time-invariant discrete-time system which is casual.…

A: It is given that: y[n]=y[n-1]-0.21y[n-2]+3x[n]+2x[n-2]y[-1]=4.76y[-2]=13.15

Q: Give the Fourier coefficients ao, an, and bn of the waveform in Fig. 17.47. Plot the amplitude and…

A:

Q: 2) What are the salient features of supply voltage control method?

A: Voltage control method: The voltage is meant to remain continuous, but it isn't. As a result, we…

Q: Basic Electrical Engineering

A: In this answer we will find the current flowing in the circuit using the concept of Kirchhoff's…

Q: Q1// For the circuit shown Plot curve between V and I When voltage variable Vin 0.1 0.2 0.3 0.7 0.8…

A:

Q: A three-phase ring main distributor ABCD, fed from point A and supplies balanced loads as follows:…

A: Distribution network  connected in a form of a ring is a ring distribution network in which one…

Q: H.w: Find the power dissipated in the resistance (75²) 452 652 OT 70A $352 $5.52 15752 {78 5A 42A (1…

A: given here a electrical network and asked to find power dissipated by 7 ohms resistor.

Q: 7. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…

A: Conductor: A conductor, often known as an electrical conductor, is a substance or material that…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.