An a singlefm transmitter is modulated withCone 15 cos Crt 29650t) and a carrierame litude of 69 volt. the out Rut vesistiveload for no modulation is 355e and themodulation constant kc = 4270 HZ/VOH.for the given Parameters.1- The ave rage Power in alside bands.2-The carrierPower if the ampritude ofmodulating Signalis reduced py 5 vovA -by 5 volt.

Answered: Image /qna-images/answer/b809e47b-6359-4b37-b237-0de3712ab05d.jpg

fm transmitter is modulated withn tone 15 cos Cat 29650t) and a carrier An a sine a ame litude of 69 volt. the out Rut vesistive load for no modulation is 355e and the modulation constant ke = 4270 HZ/VOH. for the given Parameters. 1- The ave rage Power in alside bands. 2-The earrierpower if the amP vitude of modulating Signalis reduced py 5 voVA - py 5 VolA

fm transmitter is modulated withn tone 15 cos Cat 29650t) and a carrier An a sine a ame litude of 69 volt. the out Rut vesistive load for no modulation is 355e and the modulation constant ke = 4270 HZ/VOH. for the given Parameters. 1- The ave rage Power in alside bands. 2-The earrierpower if the amP vitude of modulating Signalis reduced py 5 voVA - py 5 VolA

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

There exist several methods to perform AM demodulation, consider a requirement where we intend to design an AM receiver which is characterized by less distortion and high SNR.Identify which type of AM demodulation scheme is mentioned in the above statement and explain one such demodulation with appropriate sketch.Compare and contrast different AM modulation and demodulation schemes in various aspectsExplore one interesting application area involving Amplitude Modulation with explanation and neat sketch.
Q2. An FM transmitter is modulated with a single tone A, cos (2nA2t) and a carrier amplitude of A, volt. The output resistive load for no modulation is A, N and the modulation constant k, = A5 Hz / volt. For the given parameters, determine the following: 1- The average power in all sidebands. 2- The carrier power if the amplitude of modulating signal is reduced by 5 volts.
Q2. An FM transmitter is modulated with a single tone 13cos (2(pi)28041t) and a carrier amplitude of 55 volt. The output resistive load for no modulation is 114N and the modulation constant k, = 14624Hz / volt. For the given parameters, determine the following: 1- The average power in all sidebands. 2- The carrier power if the amplitude of modulating signal is reduced by 5 volts.
A. How many numbers of constellation points exist in phase for 3bit ASK? B. What happens to the radio wave propagation when the frequency is below critical angle? C. If the mark frequency and space frequency are same then what happens to FSK? D. What is the Carson’s rule? E. What is the Maximum data rate in a minimum channel bandwidth is ? F. What is radio horizon and where is it used? G. What are the phase angle limitations of a BPSK? H. What is the change in channel capacity when two number of bits are increased?
Q1 ] A carrier signal ( peak amplitude = 39V , frequency = 100MHz ) frequency modulated by the baseband signal ( peak amplitude = 5V , bandwidth = 12.02kHz ) . The frequency deviation is 77.53kHz , and the load is 5112. Determine ( a ) the load power , ( b ) the bandwidth of the transmitted signal . ( consider only IJn ( $ ) > 0.1 ) .
For an AM envelope with a maximum peak voltage of 52 V and a minimum peak to peak voltage of 24 V, determine the ff. a. Percent modulation = ________? b. Peak voltages of the carrier and side frequencies = ________? c. Maximum positive to negative envelope voltage = ________?
For an FM modulator with a modulation index mf = 1, a modulating signalVm(t) = Vm sin(2π1000t) and unmodulated carrier Vc(t) = 10 sin(2π500kt),determinea) Number of sets of significant sidebandb) Their amplitudec) Then draw the frequency spectrum showing their relative amplitudesd) Determine the unmodulated carrier power for the FM modulator(assume a load resistance RL = 50 Ω)e) Determine the power in the modulated carrier and each side frequency,and sketch the power spectrum for the modulated wave.
An AM carrier wave of frequency f = 1MHz with pack voltage of 20V used to modulated a signal of frequency 1kHz with pack voltage of 10v. Determine i. Modulation index (μ) ii. Frequencies of modulated wave? iii. Bandwidth
For a user signal with maximum frequency 20KHz: What must be the proportionality constant Kf and the modulation index β for the maximum FM modulated signal bandwidth to be 200 KHz, if the maximum signal amplitude is 2 volts? What is your standard deviation in Hz? Calculate modulated signal strength
1.) Answer the following: a. At 50% modulation DSBSC, what is the percentage power saving?b. At 75% modulation, what percentage of the total transmitted power is in the sideband?c. For conventional AM, the useful power, that is, the power that carries the information is rather small reaching a maximum of ______.Select the correct response:-One-fifth of the total signal power at 100% modulation-One-third of the total signal power at 100% modulation-One-fourth of the total signal power at 100% modulation-One-tenth of the total signal power at 100% modulation
Fora standard SSBSC carrier AM, the peak unmodulated carrier peak voltage is 10 V for a load resistance of 10 ohms and modulation index of 1. What will be the total transmitted power?
Define the following conceptsa. Positive modulation percentageb. Modulation efficiencyc. Signal strengthd. At least one technique for building an AM transmitter.