Answered: For a given RC circuit, increasing the…

For a given RC circuit, increasing the value of V A will cause teh time needed for a capacitor to fully charge and discharge to a. increase b. decrease c. stay the same

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 1PP: Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow....

See similar textbooks

Related questions

Q: Choose the charge/discharge resistors to use with 2.2 µF capacitor to generate a 35 ms reset signal…

A: Find the charge/discharge resistors? 2.2 µF capacitor to generate a 35 ms reset signal in a 5V…

Q: Each capacitor in the combination shown in the figure below (C = 11.0 µF) has a breakdown voltage of…

A: The breakdown voltage of any capacitor is the maximum allowable voltage applied on the capacitor…

Q: Please draw the problem and answer, thanks for the help. A capacitor is made of 2 rectangular metal…

A: According to the language of the question, the figure can be represented as

Q: When investigating the charging/discharging mode of the RC Circuit, do you think the internal…

A: Solution - When capacitors and resistors are interconnected, the resistor prevents the transfer of…

Q: please could you solve this problem in a simple way and thank you^^ A 7.9 micro-Farad capacitor was…

Q: 7ee A SI 36vE

Q: Suppose the space between the plates of the capacitor is filled with equal thickness of the same…

A: CAPACITOR: It is a device used to store electrostatic energy in the form of electric field lines. It…

Q: 4. A 100 µF capacitor is connected in series with a 500 V DC voltmeter across a 400 V DC supply. The…

A: In this question, We need to determine the time constant of the given circuit. We know time…

Q: he voltage with the following waveform is applied across a 5.00 micro Farad capacitor, what is the…

A: Given voltage wave form shown capacitor c=5 μF

Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel-plate capacitor. Each plate…

Q: In the figure how much charge is stored on the parallel-plate capacitors by the 12.0 V battery? One…

Q: Q19. Four capacitors of luF, 3µF,5uF and 6uF are connected in series across 360V supply. Evaluate…

A: Series circuit is given .

Q: or a RC discharge circuit, the resistor and the capacitor are having 2400 ohms and 0.00005 Farads.…

A: Given Value R = 2400 ohm C = 0.00005 Farads

Q: In this parallel-plate capacitor, the distance d between the plates is 3cm, the radius of the plates…

A: Given, Distance between the plates, d=3 cm Radius of plates, r=2 cm Relative permittivity, εr=1…

Q: A capacitor is made of 2 rectangular metal plates with side length of 3 cm x 6 cm separated by a…

A: Given data: A=3×6 (cm)V=110 V The figure is given as:

Q: dentify th ff: 1. The property constant in series connection of capacitors. 2. The property constant…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: The voltage with the following waveform is applied across a 5.00 micro Farad capacitor, what is the…

Q: for this circuit : 3μF 4ΜΩ ɛ=12V a) the maximum value of Capacitor C b) the maximum value of Current…

Q: circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold…

Q: Compute the individual values and the total values of the capacitance, and voltage of the series…

Q: The voltage vc across the capacitor when the switch is closed is: İL Ta + ll ic L 3 Q t= 0 C VC 12 V

Q: If the value of capacitor is at maximum in LC tank circuit, the energy at the inductor is: a)the…

A: Application of LC Circuits Generate specific frequency signal Used in Oscilltor,filters ,televesion…

Q: The figure on the side is showing how the voltage on the capacitor in an RC-circuit changes with…

A: The charge on the capacitor is the function of voltage and given as: Q=CV Thus when maximum voltage…

Q: A capacitor consists of two concentric spherical shells. The outer radius of the inner shell is a =…

A: Given values are - Inner shell radiusa=0.1mOuter shell radiusb=0.2m

Q: High voltage capacitor consisting of a concentric spherical upper part and a coaxial cylindrical…

A: Given V= 100 kV Emax=25 kV/cm Emin = 10 kV/cm To find outer radius of the spherical electrode…

Q: long time. At t-0 the switch is moved to position "b". Find the capacitor current as a function of…

Q: Two capacitors corresponding to the first capacitance 4 micro, the second capacitance unknown, the…

A: We need to calculate capacitance value for given condition

Q: How should four 2.0 µF capacitors be connected (draw and name the circuit type) to have a total…

A: When two capacitors are connected in parallel, then the same voltage appears across them. The…

Q: A 10-uF capacitor has an accumulated charge of 500 nC. Determine the voltage across the capacitor.

A: The capacitor is a charge storing electrical element. when the capacitor is connected across…

Q: Measure (using the DVM and oscilloscope) the voltage drop Vc across the capacitor and explain the…

Q: 2. Determine the charge in each capacitor and the voltage across each capacitor in Circuit B. C1 1…

A: We need to find out charge and voltage in each capacitor .

Q: 8. a). What are the values of the inductor voltage and current and the capacitor voltage and current…

A: Given data, Circuit diagram is given as,

Q: Use (C1) polarized capacitor. Provide one battery rated 9v, Connect one end of switch 1 to the…

Q: The voltage across a 5uF capacitor increases in a linear fashion from zero volts to 10 volts for the…

A: In this question we will find current through capacitor with given voltage across capacitor…

Q: A 4.7 Micro-Farad capacitor is in series with a 470 K-Ohm resistor with a 12V power supply. How long…

Q: 1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit.…

Q: Please answer this question and show the solution. What is the value of capacitor required to…

A: 0.685 milli farad is the value of capacitance in series needed to correct the power factor to 0.85

Q: which of the following are true? In forward bias, the transition capacitance dominates In forward…

A: Transition capacitance of will comes in picture only whenever diode is in reverse biased Whenever…

Q: The capacitor acts like a/an ____ circuit when connected to a DC voltage or current source; _____ on…

A: The capacitor acts like a/an open circuit when connected to a DC voltage or current source. Why…

Q: For circuit given in figure 5, find total capacitance and total charge. C1 = 20pF C2 = 30pF 5V C3 =…

Q: An 8-μF capacitor is connected in series with 0.5-MΩ resistance across a 200- V supply. The switch…

Q: the film capacitors are the ones which have an air substance as a dielectric material (True or

A: In this question we will write about Film capacitor dielectric...

Q: The capacitance of a certain variable capacitor may be varied between limits of 1 × 10-20 F and…

Q: In a RC charging circuit, given R = 150 Kohm, Supply voltage = 15 V and voltage across the capacitor…

Q: A multi-plate capacitor is made up of 501 sheets of aluminum 20 cm x 30 cm with an insulation of…

A: we need to find out capacitance in microfarads of the capacitor.

Concept explainers

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.

Question

For a given RC circuit, increasing the value of V A will cause teh time needed for a capacitor to fully charge and discharge to

	a.	increase
	b.	decrease
	c.	stay the same

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.