For a particular RLC series circuit, the capacitive reactance is 1.95 Q, the inductive reactance is 40.1 2, and the maximumvoltage across the 25.9 2 resistor is 19.3 V. What is the maximum voltage across the circuit?Em =V

Max current, I = VR/R = 19.3/25.9 = 0.745 A Voltage across inductor, VL = IXL = 0.745×40.1 = 29.87 V…

For a particular RLC series circuit, the capacitive reactance is 1.95 2, the inductive reactance is 40.1 , and the maximum voltage across the 25.9 2 resistor is 19.3 V. What is the maximum voltage across the circuit? Em = V

For a particular RLC series circuit, the capacitive reactance is 1.95 2, the inductive reactance is 40.1 , and the maximum voltage across the 25.9 2 resistor is 19.3 V. What is the maximum voltage across the circuit? Em = V

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 52PQ

See similar textbooks

Related questions

Q: A rope of mass 3 kg and length 6 m passes over a pulley with a body weighing 2 kg suspended. Calcula...

A: Given: The mass of the rope is 3 kg. The length of the rope is 6 m. The mass of the hanging object i...

Q: 1.47 •• The vector product of vectors Á and B has magnitude 16.0 m² and is in the +z-direction. If v...

A: Given value--- A × B = 16 m2 , + z direction. A = 8 m , -x direction. B = has no x component. W...

Q: A microscope objective with a magnification of 15 is used in a microscope with a magnification of 51...

A: Given, microscope objective with magnification, mo = 15 magnification of microscope, m = 51 Image is...

Q: Given data : Mass-40 kg Density-1300 kg/m3 Find volume

A: Given data: Mass-40 kg Density=1300 kg/m3 Using the concept of density As we know Density = mass ...

Q: Consider a transformer where the secondary winding is connected in series to a resistor with resista...

Q: Which causes a greater effect to the magnitude of the velocity of an object in uniform circular moti...

A: A change in force requires either a change in magnitude or a change in radius. They are all linked. ...

Q: A solenoid that is 106 cm long has a cross-sectional area of 20.4 cm². There are 727 turns of wire c...

Q: (a) Find the power of the lens necessary to correct an eye with a far point of 26.7 cm (b) Find the...

A: (a) Find the power of the lens necessary to correct an eye with a far point of 26.7 cm (b) Find t...

Q: 1. A uniform bar, 9 ft long weighs 5 Ibs. Is supported from left end by a 12 Ibs load. Find W

A: W is the weight of the bar that acts at the middle of bar.

Q: a) 90 m/s b) 18 m/s c) 35 m/s d) 4.7 m/s e) 27 m/s

A: work done w=∫F→.ds→work energy theoremwork done by all the forces = change in kinetic energy

Q: Find the fluid force on the vertical side of the tank, where the dimensions are given in feet. Assum...

Q: If 53.6 cm of copper wire (diameter = 1.42 mm, resistivity = 1.69 × 10**Q-m) is formed into a circul...

Q: The potential energy of two charges, 80 mm apart, is 1.4x10^19 eV. If one of the charges is 20 μC, w...

Q: Explain how the colors in the flame tests are produced (in terms of electrons and energy states) St...

A: 1. The variety of colors observed during the experiments of flame tests are caused by the excitement...

Q: As a diligent physics student, you carry out physics experiments at every opportunity. At this oppor...

Q: Force of a Baseball Swing. A baseball has mass 0.141 kg. If the velocity of a pitched ball has a mag...

Q: y O' ↑ 80 cm + 60 cm → For a uniform rectangular sheet shown in the figure, the ratio of moments of ...

Q: An astronaut who is repairing the outside of her spaceship accidentally pushes away a 90.9 cm long s...

Q: Convex Lenses When an object is placed at a distance d, from a lens of focal length f, and d, is gre...

Q: What is the angular magnification of a microscope using an objective with a magnification of 24.3 an...

Q: Part A A ball of mass 0.476 kg moving east (+a direction) with a speed of 3.78 m/s collides head-on ...

Q: 17.41 A 6.00 kg piece of solid copper metal at an initial temperature T is placed with 2.00 kg of ic...

A: mass of piece of copper = 6 kg Initial temperature of copper = T mass of ice = 2 kg Initial temperat...

Q: A battery is connected to a wire, and makes a current in the wire. Which of the following changes wo...

A: We know that, From ohm's law V= I R Where V is the applied voltage I is the current through the wir...

Q: The spectrum of another astronomical object has a peak wavelength of 51 nanometers. What is the like...

Q: The discharge of the electric eel can transfer a charge of 2.0x10-3C in a time of 2.0 ms. What curre...

A: Given, Charge transfer(q)=2×10-3C Time (t)=2ms= 2×10-3s

Q: What is the force per meter on a lightning bolt at the equator that carries 20,000 a perpendicular t...

Q: A steel wire having a radius of 2.0 mm, carrying a load of 4kg, is hanging from a ceiling. Given tha...

Q: 2. A 75-cm long solenoid is wound with 5 500 turns on an aluminum rod with a radius of 0.77 cm. Comp...

Q: An electromagnet in an MRI creates a 2.20 T field. If it has 12,700 loops in 0.280 m, how much curre...

Q: A boll rounds a 42 m radius curve at 18 m/s. The magnitude of it's acceleration in m/s2

A: Given data : Speed = V Radius = R To find : ...

Q: Problem 5: Two power lines, line 1 and line 2, both of length LL = 74 m, are strung east-west betwee...

Q: A tree 540 m away subtends an angle of 2 degrees. Find the height of the tree.

A: Given value--- base = 540 m. angle = 2 degree . We have to find--- height ?

Q: 5 A 75kg person jumps horizontally out of a tree with an initial velocity of 3m/s i. The person land...

Q: he point charge 6µC located at T(5,3,4) in free space. Find Eρ, E∅, Ez at P(6, 10, 3)

A: Given data- Charge q=6 μC=6×10-6 C Point T5,3,4 and P6,10,3 Given co-ordinates of electric field is ...

Q: 4.103 On June 24, 2003, a violent tornado occurred near Manchester, ND. A pressure drop of 100 mbar ...

A: As we know the relationship Between velocity and pressure, v = √(γP/ρ) Given, γ = 1.4 (air) P = 1...

Q: light ray passes through a glass lens, shown in cross section in the figure below. Find the angle of...

Q: What is one possible observation that the student could make based on the data shown in the table? ...

Q: A wire stretched between two rigid supports vibrates in its fundamental mode with a frequeney of 45 ...

Q: icroscope objective with a magnification of 16 is used in a microscope with a magnification of 46. F...

A: GivenA microscope objective with a magnification, mo=16A microscope with a magnification, m=46The oc...

Q: Can anybody be shocked when touching a wire carrying a very large current with a low voltage source?...

A: Can anybody be shocked when touching a wire carrying a very large current with a low voltage source?...

Q: Calculate the temperature at which the average K.E. of a molecule of a gas will be the same as that ...

Q: 1. An object moving with uniform acceleration has a velocity of 14.0 cm/s in the positive x-directio...

A: Given data X= -10 cm Xo = 4.50cm/s U=14.0cm/s t=3.00 s

Q: 1. What is the definition of momentum?

A: Answer- Momentum is defined as the product of mass and velocity of an object Let m be the mass of th...

Q: The drawing shows three polarizer/analyzer pairs. The incident light beam for each pair is unpolariz...

A: Given data: The intensity of the incident light is I0=48 W/m2.

Q: Find the refractive index of the glass in the figure below. (Take ? = 26°, y = 6.8 cm, and x = 4.7...

Q: Why the book have more frictional force to the surface than the one peso coin? Why do you think so?

A: Friction is the force which opposes the relative motion b/w two surfaces in contact. Its SI unit is ...

Q: d) Determine the final kinetic energy of the bead. e) Determine the final velocity (magnitude and di...

A: Positive charge particle experience force in direction of electric field Magnitude of force F = qE

Q: What is at the root of different types of polarization?

A: Types of Polarisation Polarization is a concept that comes under the branch of electromagnetic ra...

Q: Ropes are attached to the walls at specified angles as shown in the illustration below. What is the ...

A: Given: The weight of the object is 200 N. The free-body diagram is given below.

Q: A capacitor with capacitance 5 µF is charged to 5 µC. If the plates are pulled apart to reduce the c...

Question

For a particular RLC series circuit, the capacitive reactance is 1.95 Q, the inductive reactance is 40.1 2, and the maximum
voltage across the 25.9 2 resistor is 19.3 V. What is the maximum voltage across the circuit?
Em =
V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500 Hz, respectively; R=500 ; and L = 0.20H . Find the average power dissipated in the resistor for the following values for the capacitance: (a) C=2.0F and (b) C=2.0F .
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.
In a purely inductive AC circuit as shown in Figure P21.15, Vmax = 100. V. (a) The maximum current is 7.50 A at 50.0 Hz. Calculate the inductance L. (b) At what angular frequency is the maximum current 2.50A? Figure p21.15
In a purely inductive AC circuit as shown in Figure P21.15, Vmax = 100. V. (a) The maximum current is 7.50 A at 50.0 Hz. Calculate the inductance L. (b) At what angular frequency is the maximum current 2.50A? Figure p21.15
A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
A 20-mH inductor is connected across an AC source with a variable frequency and a constant-voltage amplitude of 9.0 V. (a) Determine the reactance of the circuit and the maximum current through the inductor when the frequency Is set at 20 kHz. (b) Do the same calculations for a frequency of 60 Hz.
The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
A 1.5k resistor and 30-mH inductor are connected in series, as below, across a120-V(rms)ac power source oscillating at 60-Hz frequency. (a) Find the current in the circuit. (b) Find the voltage drops across the resistor and inductor. (C) Find the impedance of the circuit. (d) Find the power dissipated in the resistor. (e) Find the power dissipated in the inductor. (1) Find the power produced by the source.