Answered: For a power supply of 1%, what is the…

Engineering

Electrical Engineering

For a power supply of 1%, what is the load voltage if the no-load voltage is 20 V

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter27: Service-entrance Equipment

Section: Chapter Questions

Problem 33R

See similar textbooks

Related questions

Q: Solve for the value of the voltage on 220 ohms resistor. D1 2200 02 10V

Q: Two batteries, 10.5 volts with internal resistance of 1.5 ohm and 9 volts with internal resistance…

Q: Determine the equivalent resistance across nodes a and b. 20 S30 30 20

A: Given circuit,

Q: An electronic power supply has an efficiency of 92%. If the input voltage and current is 100V and…

A: Efficiency = output power / input power. Input power = voltage × current.

Q: the voltage between the star-point of the load and the supply neutral.

A: Given: An unbalanced star-connected load is fed from a symmetrical 3-phase system. Phase…

Q: An electric heater draws 12 A from a 120 V power source. How much power does the heater dissipate

Q: A consumer has the following connected load: 10 lamps of 60W each and two heaters of 1000W each. His…

A: Energy consumption means amount of energy / power used. we divide our energy in various sector like…

Q: What current does the ammeter read in milliamperes? Given: Solution:

Q: A current of 1.50 A flows through a motor when it is connected to a 120 V source. What is the…

A: To find the resistance of the motor

Q: e? -01 SY. 2122 ELE082 al Resistance 122 ELE082 al Current ver supplied by the voltage s tage Drop…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: small appliances circuits used in dwellings must be calculated on the basis of not less than ____…

A: NEC -National Electricity code It is regionally adoptable standard for the safe installation of…

Q: A 12 V source is connected across a 10 resistor. (a) How much energy is used in two minutes? (b) If…

A: A 12 V source is connected across a 10 resistor.(a) How much energy is used in two minutes?(b) If…

Q: FILL IN THE TABLE AND SHOW THE CIRCUIT WITH THE METER CONNECTION SHOWING THE READING OF THE METER.…

A: The Power across all the resistors can be calculated by connecting the wattmeter across the…

Q: A 60 ohms bulb is connected to a 220V source for 1 hours. How much energy is taken from the source?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: ow much energy does a 5hp mot

Q: Weight of the coal is 2 g and after heating the coal sample, the weight of the coal is 1.82 g. What…

A: Given, Initial weight of coal = 2 g Weight of the coal after heating = 1.82 g

Q: Convert the delta equivalent to its wye equivalent

A: In this question we need to convert the delta connected resistance into star connection.

Q: 50 V= 100Vrms f = 1khz 1uF

Q: Нomework 1. Convert (110101.11)BCD to ()2 directly.

A: Since the concept of BCD (binary coded decimal) is that we have to represent each decimal digit(from…

Q: If a DVD player draws 2 A current from a 23 V DC source, then what will be the resistance of the DVD…

A: According to Ohm’s law if i is the current flowing through a component and thus creating a voltage…

Q: Find the voltage drop on the 2kohm resistor through which I0 current passes.

Q: Overall efficiency of a thermal plant is

A: The explanation is as follows.

Q: An energy meter having meter constant of 1200 revolutions/kWh makes 20 revolutions in 30 seconds for…

A: Given values are - Meter constant=1200revkWhNumber of revolution=20Time=30sec

Q: 20v O 30V Find Ix (any method)

A: Source Transform Theorem: When a Voltage source V connected in series with a resistance R then it…

Q: Resistor Voltage drop (V) Current (A) 10 20 30 40 50

A: I have completely solved for all values of current through and voltage across all elements and…

Q: What voltage drop will be there across a 1 kW electric heater whose resistance when hot is 40 2? 150…

A: Given a electric heater having, Power rating, P = 1 kW Resistance, R = 40 Ω

Q: If LUX= 812 Find: LED light I(A) | Power(w) | ON/OFF Resistor Battery V(v) LDR RLDR(O) | V(v) 1(A)…

A: The circuit is as shown below, Given, R3 = 812 ohm

Q: 12 V 2.2 ka 220 ka B = 60 - 40 kN A

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Finding the voltage for 5kilo ohm and 10kilo ohm

A: IT is the total current flowing in the circuit: a) To calculate IT apply KVL in the given circuit:…

Q: 2 Ix 6V Ix 나

Q: It is recomended that oil tanks be sized to hold about 1/3rd of the annual consumption, so not to…

A: When the oil tanks are built in a suitable size, the probability of stored oil to sit and degrade in…

Q: what is the depth of discharge of battery 12V, 8AH/20HR

A: The batteries are voltage source elements of DC circuits. These consists of many smaller charge…

Q: What is the cost of using a 5Hp motor for two hours if the rate is P50.00 per kWhr

A: Given, Rating of motor is 5 HP The motor in operation for 2 hours. Rate of operation is P50.00…

Q: Ib $402 130V 120V

Q: Ql: Find the value resistance (R) for the circuit in figure 1.The power supply P=lk watt. Slon 우 8고…

Q: A 12 V battery is connected across a load having a resistance of 40 ohms. Determine the current…

A: In this question, A 12 V battery is connected across a load resistance of the load = 40 ohm…

Q: Pick which is the correct answer from the given choices 11. The normal current through a load…

A: The simple problem on network analysis. Look below for the explaination:-

Q: What is the current through an 8-ohm toaster when it is operating in 120V? *

Q: esistance of the circuit? 20 40 12 V 10

Q: What is the resistance in ohms if the voltage is 230V and the

Q: An electric kettle is required to boil 0.6 kg of water from 10 oC in 5 minutes, the supply voltage…

Q: Which one of the following can produce maximume of power about 5kW? a. Fuel cell b. Solar c. Wind d.…

A: A 5kW solar system will generate approximately 20kWh per day, depending on location and a variety of…

Q: A 1-W, solar panel has an efficiency of 15% and costs $1.50. It costs another $1.50 to install and…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: Determine the power required to raise a 100kg load with 100m vertically in 30 seconds.

A: Given Mass of the load =100 kg Height h=100 m Time t=30 s

Q: Predict power consumption for a month if the temperature is 770F

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: An energy-meter having a meter constant of 1200 rev/kWh is found to make 5 revolutions in 75s. The…

A: Use fundamental relation between the given values Related to energy meter

Q: (vehlmin) 100 1 milelmi 50 Ko = 100 200 Kj= ? %3D

A: Kj can be find by using slope Since the slope between k = 100 to Kj is same as slope between 100 to…

Q: Voltage = 120 resistance =30 and Cap reactance =40 what is the current at the power source

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

For a power supply of
1%, what is the load
voltage if the no-load
voltage is 20 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the circuit attached, assume that V0 = 18 V. Find the power supplied or absorbed by each element of the circuit.
A 50-ohm load dissipates 200W of power.How much is the voltage and current across the load?
Please assume a price for electric energy of $0.15/kWh. If washer A costs $750 and uses 200 kWh of energy per year to operate, and washer B costs $300 and uses 800 kWh of electricity per year to operate, which of the two washers costs less to own and operate over a period of ten years?
what is the energy used of a light bulb if its plugged into a 100 V outlet for 100 hours and has 140 ohms resistance
7. An ampere-hour meter calibrated at 200 V is used on 220 V circuit and indicates a consumption of 730 kWh in a certain period. If this period is reckoned as 200 hrs. What is the average value of the current?
If a nonlinear resistor has a voltage-current relation of V = 5I3+5, what power does it absorb when energized by 68 V? The final unit must be in watts, W. Round your answer to 2 decimal places.
A heater uses 20 A when connected to a 220-V line. If electric power costs 10 centavos per kilowatt-hour, the cost of running the heater for 10 hours is
Show the complete and step-by-step solution for an upvote. a. The voltage source value if the power dissipated by the 8 Ω resistor is 8 Joules per second. (Answer: 262.051 V) b. The power supplied in Watts by the voltage source if the power dissipated bythe 8 Ω resistor is 1 Joule per second. (Answer: 766.915 W, supplying)
What is the power rating (in kW) of a device which has a resistance of 150 ohms and draws 6Amps of current?
Considering a no.00 AWG wire is 100 m. For no.00 AWG wire, it has a resistance of 0.078 per 1000ft. Calculate the power loss if the current flowing on the wire is 10 ohms.
A 37Ω resistor is connected to an AC voltage source. The figure shows the power dissipated by the resistor versus time. If the electrical energy costs 0.10$/kWh, how much does it cost to run this device nonstop for one full week?
A no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1000ft. Determine the power loss if the current flowing through the wire is 18 amperes.