Question

For a specially designing on junction diode, the value of the forward current is 35 mA at a forward voltage of 3 V. If the eta of the material of the diode is 1.5, then estimate the reverse saturation current. 

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: There are 5005 electrons in an assembly. What will be total charge in coloumb?

A: Electrons are negatively charged particles and the charge of a single electron can be expressed as ...

Q: Find the Thévenin equivalent circuit as seen by the3- resistor for the circuit of Figure P3.51

A: To find the equivalent Thevenin equivalent circuit remove the 3 Ω resistor and find the open-circuit...

Q: Derive the convolution property of the DFT.

A: Convolution property states that if two signals are getting convoluted in time domain then they will...

Q: A 1.5V AA battery has a measured open-circuit voltage of 1.62 V and a measured short- circuit curren...

A: The open-circuit voltage of the battery is 1.62 V, this voltage can be considered as the Thevenin vo...

Q: Find the voltages Vi an Vo for the cirucit shown where R1 = R2 = RL = 2kohm. Assume that the op amp ...

A: Redrawing the given circuit:

Q: A DSB-modulated signal u(t) = Am(t) cos 21 fet is mixed (multiplied) with a local carrier xL(t) = co...

A: Since double sideband (DSB) modulation scheme is used, the expression of the signal obtained at the ...

Q: For the operational amplifier circuit shown , What is the magnitude of voltage gain in db at the fre...

A: The given cicuit is an inverting operational amplifier. Voltage gain of an inverting operational amp...

Q: Why to choose active filters over passive filters?

A: A filter is used to remove the undesirable portions of the frequency spectrum of a signal. Active fi...

Q: A device which is used to measure current passing through a circuit element is called .................

A: An ammeter is a device which is used to measure the current passing through a circuit or a circuit e...

Q: The complex impedance of an inductor is j30 ohm. Estimate the frequency of the input signal is the i...

A: An inductor of inductance L H, when excited by an ac signal of frequency f Hz, produces a complex im...

Q: I want questions from 2 to 10 to be answered. Question 2 - 10. Thats (2 through 10)

A: As we are authorised to do 3 subparts at a time so i am answering first 3 subparts. Please mentioned...

Q: Compute and sketch the DTFT W(f) of w[n] if w[n] = 1 from (-5 <= n<= 5).

A: The expression of the discrete-time signal is:

Q: 4 Using phasor techniques, solve for the current in the circuit shown in Figure P4.54. 3H ww v:(t) =...

A: Observe that the angular frequency of the given source is 3 radian per second. So the impedance prov...

Q: Given a 115kV/13.2kV distribution transformer rated at 30 MVA (OA) with an 8% nameplate impedance (P...

A:   Since we only answer up to 3 sub-parts, we’ll answer the first 3.Please resubmit the question and ...

Q: With reference to Figure P3.40, determine thecurrent through R1 due only to the source VS2.VS1 = 110...

A: Click to see the answer

Q: Find I, in the circuit in the figure using mesh analysis. 2 V 2 kn 2 kn 4 kN 8 mA 2 kN 6 kN 1 mA 2 k...

A: Given circuit is –

Q: 6. Pez = 0.3,|V,|=0.95, Sp2 =1+ j0.3 Sp3 = 0.5+ j0.2,V, =120 Assume a flat start and do one iteratio...

A: Given Y – matrix is – Given values are –

Q: Given the circuit of Figure P10.5, determine theemitter current and the collector-base voltage. Assu...

A: Click to see the answer

Q: A discrete time signal x(n)=[1,2,3,4] for n=0 to 3 is provided. What will be the time domain represe...

A: The discrete time signal is given as The sample values of this discrete time signal x(n) can be wri...

Q: Find out the ratio of the ac output voltage (ve) to the ac input voltage (v6) B iь Bi, RL EO RE Ve

A: According to Kirchhoff's voltage law, the total voltage drop across any closed loop is zero.  Applyi...

Q: A Voltage amplifier circuit is shown in Fig. 1.1, where the membership functions of the two resistor...

A: Given circuit is – Given output voltage equation is –

Q: Problem 4. One of the applications of the op-amp is a comparator. Determine the output of the op-amp...

A: The output voltage of an op-amp is given as Here, Vd is the differential voltage at the input termi...

Q: Compute the impulse responseh[n] of the filter with trequency response HLf. HCf) wう+e your ansmuer i...

A: Given function is –  

Q: How do you calculate the RMS Value of a cosine wave ?

A: To find the RMS value of cosine wave.

Q: How do i use source transformation as a method to find V1 ?

A: Voltage source into current source transformation: When a voltage source is connected to the resisto...

Q: 7 The diodes in the full-wave DC power supply shown in Figure P9.44 are silicon. If L = 85 mA V, = 0...

A: The given problem is of a full-wave rectifier, the value of the turns ratio and the capacitor is to ...

Q: 4. Use the nodal analysis method to formulate a system of simultaneous linear equations representing...

A: To apply the nodal analysis first apply the voltage at the different nodes as shown in the figure gi...

Q: If the value of the thermal voltage is 25.5 mV, then estimate the ambient temperature. Assume standa...

A: Thermal voltage is a very important parameter in semiconductor devices. It is a function of Boltzman...

Q: 1. Determine the numerical value of Vr. 30 V 15 N 15 V 2 A 10 2 х

A: The circuit diagram is:

Q: What is the common-mode voltage of the balanced Wheatstone bridge ?

A: Click to see the answer

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: It is given that the length of the transmission line is 15 km. It is considered as a short transmiss...

Q: What is the angular frequency w of the AC current i(t) = 40cos(5t+60°) A?

A: The standard expression of the AC current is, Here, ω is the angular frequency of the current.

Q: 6) For the Delta-connected circuit below, calculate (assuming balanced source): a. The line current ...

A: The line voltage is 208 V. The given load is balanced delta having only resistive load, so the power...

Q: 2 Determine the reglon of operation for the following transistors: a. npn, VBE = 0.8 V, VCE = 0.4 V ...

A: (a) - Given transistor is npn transistor. That means collector and emmiter are of n-type material an...

Q: Calculate the output offset voltage of the circuit shown in the figure below: The op-amp spec lists ...

A:  tFor an ideal operational amplifier (op-amp), the value of the output voltage should be zero when e...

Q: Transmitted power by a radio is 50 mw. Express the transmitted power in terms of dBm.

A: dBm is the power expressed in decibels where the reference power is 1 mW. Transmitted power (Pt) by ...

Q: The following three-phase loads are connected to a short transmission line with impedance per wire o...

A: From the given load information calculate the total load current. The power dissipated by the resis...

Q: Find the voltage v across the 3- resistor in thecircuit of Figure P3.52 by replacing the remainder ...

A: The circuit diagram is:  

Q: A periodic waveform with w0 = 10^5 rad/s is applied to a circuit as shown in Fig. P3.2.3. Determine ...

A: Given the value of the angular frequency: Now the 50th harmonic is given as:  

Q: identify and make a list of at least ten products around your home that are certified by the underwr...

A: Underwriters Laboratories (UL) is the largest and best known independent, not-for-profit testing lab...

Q: 2 For the Circust below, solue for ix(€). 4 S2 ..బ 18ix 25 V Lix * the switch openo at -100

A: The given circuit diagram is: The switch opens at t = 0, that is before t = 0 the circuit was in st...

Q: Using a 15-kΩ resistance, design an RC high-passfilter with a breakpoint at 200 kHz.

A: The circuit diagram of the RC high pass filter is,

Q: What approximations are usually made about the circuit components and parameters shown in Figure P8....

A: Considering the following operational amplifier:

Q: What will be the inverse Laplace transform of X(s)=1/(s-3) and RoC: Re(s)>3

A: For any continuous-time function x(t), the Laplace transform of x(t) is defined as Region of conver...

Q: 1-7. Find the indicated current by use of the current division rule. *a. 1 Review of Basic Circuit A...

A: When three resistors of resistance RA, RB and RC are parallel to each other, then the value of their...

Q: DC to AC 1) Determine the efficiency of the following DC to AC converter (i.e. how much of the energ...

A: The figure of the signal is: From the figure: The RMS value of the voltage signal is determined as...

Q: Find out Nyquist's sampling frequency for the signal x(t)=5sin(200t).

A: According to Nyquist's sampling theorem, if a signal is to be recovered from its samples properly, t...

Q: Problem 2

A: The circuit diagram is: The modified circuit for t < 0 is:

Q: When discharging a capacitor, as discussed in conjunction with Figure 21.39, how long does it take f...

A: The discharge equation is Theoretically, the time taken by the capacitor to completely discharge is...

Q: A fm signal is represented as x(t)=10cos{105t+3sin(102t)}  Find out the maximum frequency deviation.

A: In general, for a message signal m(t), the expression of the frequency modulated signal is given as ...