For an aperture of width 1mm and using light of wavelength of 633 nm, estimate the distance from the aperture at which the Faunhofer approximation would be appropriate. a. Under the Fraunhofer condition, what would be the angle of the first minimum? b. If the screen is 1m away, how far from the central maximum would the first minimum be located?

For an aperture of width 1mm and using light of wavelength of 633 nm, estimate the distance from the aperture at which the Faunhofer approximation would be appropriate. a. Under the Fraunhofer condition, what would be the angle of the first minimum? b. If the screen is 1m away, how far from the central maximum would the first minimum be located?

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter3: Interference

Section: Chapter Questions

Problem 35P: Ten narrow slits are equally spaced 0.25 mm apart and illuminated with yellow light of wavelength...

See similar textbooks

Similar questions

Consider a single slit that produces its first minimum for 630 nm light at an angle of 26 degrees Part a: How wide is the single slit in meters? Part b: at what angle ( in degrees) will the second be minimum
How much diffraction spreading does a light beam undergo? One quantitative answer is the full width at half maximum of the central maximum of the single-slit Fraunhofer diffraction pattern. You can evaluate this angle of spreading in this problem. (a) as shown, define φ = πa sin φ/λ and show that at the point where I = 0.5Imax we must have φ = √2 sin φ. (b) Let y1 = sin φ and y2 = φ = /√2. Plot y1 and y2 on the same set of axes over a range from φ = 1 rad to φ = π/2 rad. Determine φ from the point of intersection of the two curves. (c) Then show that if the fraction λ/a is notlarge, the angular full width at half maximum of the central diffraction maximum is θ = 0.885λ/a. (d) What If? Another method to solve the transcendental equation φ = √2 sin φ in part (a) is to guess a first value of φ, use a computer or calculator to see how nearly it fits, and continue to update your estimate until the equation balances. How many steps(iterations) does this process take?
Monochromatic light is incident on (and perpendicular to) two slits separated by 0.220 mm, which causes an interference pattern on a screen 571 cm away. The light has a wavelength of 656.3 nm. What is the fraction of the maximum intensity at a distance of 0.600 cm from the central maximum of the interference pattern? What If?What is the minimum distance (absolute value, in mm) from the central maximum where you would find the intensity to be half the value found in part (a)?
What minimum path length is needed to introduce a phase shift of 205° in light of wavelength 566 nm? (Give your answer in nm.) What phase shift will that path difference you calculated in part (a) introduce in light of wavelength 799 nm? (Give you answer in degree.)
Ten narrow slits are equally spaced 0.25 mm apart and illuminated with yellow light of wavelength 580 nm. (a) What are the angular positions of the third and fourth principal maxima? (b) What is the separation of these maxima on a screen 2.0 m from the slits?
A diffraction grating with 2000 lines per centimeter is used to measure the wavelengths emitted by a hydrogen gas discharge tube. (a) At what angles will you find the maxima of the two first-order blue lines of wavelengths 410 and 434 nm? (b) The maxima of two other first-order lines are found at 1=0.097 rad and 2=0.132 rad . What are the wavelengths of these lines?
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Consecutive bright bands on an interference pattern are 3.5 cm apart when the slide containing the slits is 10.0 m from the screen. The slit separation distance is 0.050 mm. y= ________ d=________ m=_______ L=________
Consider a single slit being illuminated by light with wavelength λ. Part (a) What is the minimum width, w1min, expressed as a multiple of λ, for which the slit produces the first minimum? Part (b) What is its minimum width of the slit, w50,min, if it produces 50 minima? Again, express this in multiples of λ. Part (c) What if it produces 1000 minima?
An intereference pattern is produced by light with a wavelength of 560 nm from a distant source incident on two identical parallel slits seperated by a distance (between centers) of 0.580 mm. (A) if the slits are very narrow what would be the angular position of the first order two slit intereference maxima? Express your answer in radians. (B) what would be the angular position of the second order two slit intereference maxima in this case? (C) let the slits have a width of 0.330 mm. In terms of the intensity at the center of the central maximum what is the intensity at the angular position of theta? (D) what is the intensity at the angular position of theta2?
Two radio antennas separated by d = 270 m, as shown in the figure below, simultaneously broadcast identical signals at the same wavelength. A car travels due north along a straight line at position x = 1,030 m from the center point between the antennas, and its radio receives the signals. Hint: Do not use the small-angle approximation in this problem. (a) If the car is at the position of the second maximum after that at point O when it has traveled a distance of y = 400 m northward, what is the wavelength of the signals? m(b) How much farther must the car travel from this position to encounter the next minimum in reception? m
solve a,b and c asap a. Explain Diffraction Phenomena?b. Is Laser monochromatic light? Explain? Are there any other methods to determine the wavelength of the laser? Give it ?c. If the width of an aperture is 0.Imm and the distance from the central fringe to the first fringe (z)is 5mm and the distance between the aperture and the screen (L)is 93cm determine the wavelength of light source used ?
a. The slits are currently set to be a=3.32 um wide. what is the distance between the slits and the screen? b. What is the spacing of the slits?