For problems 15 and 17 A transmission line has the following per unit length parameters. R' = 0 Q/m, L' =0.4µH /m, G' = 0 S/m, C' =150 pF /m Problem [15] Is this a lossless or a lossy transmission line? Problem [16] Calculate the characteristic impedance of this line at 500 MHz Problem [17] Calculate the wavelength on this line at 500 MHz

For problems 15 and 17 A transmission line has the following per unit length parameters. R' = 0 Q/m, L' =0.4µH /m, G' = 0 S/m, C' =150 pF /m Problem [15] Is this a lossless or a lossy transmission line? Problem [16] Calculate the characteristic impedance of this line at 500 MHz Problem [17] Calculate the wavelength on this line at 500 MHz

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.31P: A 500-kV, 300-km, 6()-Hz, three-phase overhead transmission line, assumed to be lossless, has a...

See similar textbooks

Similar questions

1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit. The line is operating in air with a wavelength of 0.8m and is lossless. (a) If input voltage is 10V, what is themaximum voltage amplitude at any point on the line? (b) Whatis the current amplitude in the short circuit?
An extra high voltage transmission line of length 300 km can be approximated by a lossless line having propgation constant is 0.00127 rad/km. The percentage ratio of line length to wave length will nearly by ?
An extra high voltage transmission line of length 300 km can be approximate by a lossless line having propogation constant β= 0.00127 radians per km. Then the percentage ratio of line length to wavelength will be given by ??
A lossless transmission line is terminated by an open circuit. An incident signal travels from the source to the load gets reflected and travels all the way back to the source. It takes 4 microseconds for the signal to go from the source to the load and then from the load to the source. What is the length of the line (in m) if the propagation velocity is equal to the speed of light (in m/s)? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an integer).
For the lossless transmission line shown below, the T.L. was previously charged to E=128V and the switch is closed at t=0. If Zo= 150 ohms and RL= 450 ohms, find the following VRL at t=3To VRL at t=To First reflected voltage from the load (Vr-)
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.8 wavelengths, what is input admittance?
A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL.According to what is given, a) RL for Voltage Standing Wave Ratio to be 2What should be the relationship between XL and?b) If RL = 100Ω, find the value of XL.c) Find the voltage minimum point closest to the load on the line.
Estimate the corona loss for a 3-phase, 110 kV, 50 Hz, 150-km-long transmission line consisting of three conductors, each of 10 mm diameter and spaced 2.5 m apart in an equilateral triangle formation. The temperature of the air is 30oC and the atmospheric pressure is 750 mm of mercury. Take the irregularity factor as 0.85. Ionisation of the air may be assumed to take place at a max voltage gradient of 30 kV/cm.
A microstrip line is composed of zero thickness copper conductors on a substrate having εr = 8.4, tan = 0.0005 and thickness 1.5 mm. if the line width is 0.5 mm,and operated at 6Ghz, determine the characteristic impedance.
A three-phase, 765-kV, 60-Hz transposed line is composed of four ACSR, l,431,000-cmil, 45/7 Bobolink conductors per phase with flat horizontal spacing of 14 m. The conductors have a diameter of 3.625 cm and a GMR of 1.439 cm. The bundle spacing is 45 cm. The line is 400 km long, and for the purpose of this problem, a lossless line is assumed. (a) Determine the transmission line surge impedance Zc, phase constant ß, Wavelength λ, the surge impedance loading SIL, and the ABCD constant. b) The line delivers 2000 MVA at 0.8 lagging power factor at 735 kV. Determine the sending end quantities and voltage regulation. c) Determine the receiving end quantities when 1920 MW and 600 Mvar are being transmitted at 765 kV at the sending end. (d) The line is terminated in a purely resistive load. Determine the sending end quantities and voltage regulation when the receiving end load resistance is 264.5 Ω at 735 kV.
Q1) A 70 cm long lossless transmission line with characteristics impedance of 50 Ω operating at 5Mhz is terminated with a load of ?? = (65+j80) Ω. If the velocity is 0.8 times the velocity of light, then calculate (a) The reflection co-efficient, also verify the value using the given smith chart.(b) Compute the input impedance using the transmission line input impedance equation.